The key to solve the problem lies in the optimal design of clearances between the insert rotary shaft and its bearing as well as the round insert fitted hole.
解决刀片回转不均匀问题的关键在于优化设计刀片回转轴与轴承、刀片内孔之间的配合间隙。
This paper analyses the working principle of bearing insert and some cause of the damage, meanwhile, some points needing attention in repairing fault bearing insert are also given.
本文重点对柴油机轴瓦的工作特点及其损坏原因进行了分析，并阐述了故障轴瓦修配时应注意的事项。
Of all the troubles that diesel engine meets, the most common trouble is bearing insert damage.
而在柴油机的故障中，曲轴轴瓦的损坏占有很大的比例。
This article analyzes the causes of repeated emergence of engine bearing insert burned-out and provides practical solutions, according many years practical experience on engine maintenance and repair.
结合多年修理发动机的实践，对重复发生发动机烧瓦事故的原因进行了分析，并提出了具体解决方法。
The desiring installation method of installing insert ball bearing unit is: first install the housing at support base firmly, then tighten the bearing to the shaft.
安装带座外球面球轴承时，将轴承套在轴上，先将轴承座牢固地固定在支承面上，然后将轴承紧固在轴上即可。
The solid of journal bearing pair is created with ANSYS. Some inserts are built and added to the cone solid. The pressure load is applied on the several insert surface, which is more practical.
利用ANSYS建立了牙轮钻头滑动轴承副实体，与前人所不同的是增加了牙齿实体，并在牙齿顶部加上了面载荷，因此数字模型更能反映实际情况；
The core products are insert bearing, deep groove ball bearing, tapered roller bearing.
公司主要经营外球面轴承、零类深沟球轴承、七类圆锥滚子轴承。
The core products are insert bearing, deep groove ball bearing, tapered roller bearing.
公司主要经营外球面轴承、零类深沟球轴承、七类圆锥滚子轴承。
应用推荐