The modulation is driven by the bias current below the threshold.
调制时的偏置电流低于阈值。
The bias module provides a bias current to the differential input stage.
偏压模块提供偏压电流至差动输入级。
Under dry conditions, the transistor will have no bias current and be fully off.
在干燥条件下，晶体管的偏置电流和没有被完全关闭。
The second mode is associated with more bias current for the SPS receiver than the first mode.
第二模式与第一模式相比与SPS接收机的更大偏置电流相关联。
BIAS_APC function can set bias current of ld automatically by estimating threshold current of ld.
BIAS_APC功能可以设置偏置电流通过估计阈值的自动ld LD的电流。
The low-bias current control method is proposed in order to improve system high frequency dynamic performance.
为提高系统高频动态特性，提出了低偏置电流工作方式。
As shown in Figure 2-2, the input bias current (IBIAS) develops an error voltage across the source resistance (RS).
如图2 - 2所示，输入偏置电流(IBIAS)在源电阻(RS)上产生了误差电压。
Another consideration when measuring voltages from high resistance sources is the input bias current of the voltmeter.
在测量高电阻源时要考虑的另一个问题是电压表的输入偏置电流。
The output buffer includes a differential input stage, a bias current source, a feedback module, and an output stage.
输出缓冲器包括差动输入级、偏压电流源、反馈模块以及输出级。
The input bias current flows at the instrument input due to internal instrument circuitry and the internal bias voltage.
仪器内部电路和内部的偏移电压会在仪器的输入端引起输入偏置电流。
The current corresponding to this point will be the required bias current, and the dissipation will be maximum at that point.
目前相应的这一点是需要偏置电流，以及最大耗散将在这一点。
The feedback module adjusts the bias current and the output current based on the first input signal and the second input signal.
反馈模块依据第一输入信号和第二输入信号来调整偏压电流和输出电流。
An OPA128 operational amplifier with extreme low bias current and big gain is adopted for enhancing the response to weak signals.
同时为了保证测量精度，采用偏置电流极低的运算放大器opa128，并且增大了反馈电阻，以增强对弱信号的响应。
As one tube's current increases from the midpoint, or idle, bias current, the other tube's current is decreasing by an equal amount.
作为一个管的电流增大的中点，或闲置，偏置电流，其他管目前正在减少的同等数额。
Again, consider using AMPLIFIERs that exhibit a smooth input bias current transition throughout the applied input common-mode voltage.
再者，所用的放大器也要考虑在加到输入端的整个共模电压(范围内)输入偏置电流转换保持平滑。
As a result, the influence of signal light and bias current to the power and extinction ratio of converted light is studied in detail.
从而研究了待转换的信号光及偏置电流对转换光功率和消光比的影响。
The SPS receiver may be operated in one of multiple modes, which may be associated with different bias current Settings for the SPS receiver.
SPS接收机可在多种模式之一下工作，这多种模式可与SPS接收机的不同偏置电流设置相关联。
Measuring the reverse bias current of an APD requires an instrument that can measure current over a wide range as well as output a voltage sweep.
测量APD的反向偏置电流需要一种能够在很宽范围内测量电流并且能输出扫描电压的仪器。
First, the bias current for each side is flowing in opposite directions in the primary of the output transformer, so they effectively cancel each other out.
首先，偏置电流为每一方都在流动方向相反的主要输出变压器，所以他们有效地相互抵消。
Some new low-noise edge triggered flip-flops are presented, and their logic levels are realized in the current domain by steering a constant dc bias current.
提出以电流信号表示逻辑值的新型低噪声触发器设计，用于高性能混合集成电路的设计中以减少存贮单元开关噪声对模拟电路性能的影响。
Bias circuit according to the reference voltage to bias the first stage circuit and the current compensation circuit, and set the bias current compensation circuit.
偏压电路依据参考电压来偏压第一级电路与电流补偿电路，并设定电流补偿电路的偏压。
At constant bias current, the simulation shows significant enhancement in optical bandwidth due to moving the quantum well in the direction of collector-base junction.
模拟表明，在恒定的偏置电流下，沿集电结方向移动量子阱能显著提高光学带宽。
According to the performances, the bias current and the modulation current of the laser should be ascertained appropriately and should vary with the change of the temperature.
根据这两项指标，需要确定适当的激光器偏置电流和调制电流，并且偏置电流和调制电流需要随温度的变化而变化。
The necessity of setting the bias current and segregation resistances in every element of bipolar silicon photo-negative resistance phototransistor array is studied and analysed.
探讨并分析具有光致负阻特性的双极型硅光电三极管阵列中各单元器件设置偏流隔离电阻的必要性。
Experimental data show that the intensity modulation depth increases with the bias current of LD. When the modulation frequency increases, the intensity modulation depth decreases.
实验数据表明，光强调制度随激光器偏置电流的增加而加深，随调制频率的升高而减小。
After the introduction of the characteristics of semiconductor laser diode, the bias current supply of the laser driver and the automatic power control (APC) function were analyzed.
简要介绍了半导体激光器的温度特性的后，分析了激光驱动器偏置电流提供和自动功率控制(APC)功能。
It is made clear through the theoretical analysis that the frequency shift is dependent on the modulation frequency, thermal time constant, bias current of the laser diode and so on.
理论分析表明频移幅度与调制频率、时间常数和半导体激光器的偏置电流等物理量有关。
It is made clear through the theoretical analysis that the frequency shift is dependent on the modulation frequency, thermal time constant, bias current of the laser diode and so on.
理论分析表明频移幅度与调制频率、时间常数和半导体激光器的偏置电流等物理量有关。
应用推荐