文中给出了电路原理图和主程序流程图。
Its electrical arrangement and main - program flow diagram is also given here.
给出了该远程测控系统的硬件原理图及软件主程序流程图。
The hardware principle and software flowchart of the remote measuring and control system are offered.
重点介绍了硬件组成与软件设计，并给出了主程序流程图。
The design of elementary composition in hardware and software is introduced mainly. Main program flow diagrams are given.
最后，对软件系统进行设计，完成了功能模块划分并给出了主程序流程图。
Finally, the thesis designs software system, gives the partition of software functional modules and the flow chart of main program.
根据设计要求，给出了测试仪的具体硬件电路设计和相应的主程序流程图。
In accordance with the design requirements, the design of specific hardware circuits of the tester and the flowchart of related main program are given.
作者利用通信接口rs485设计编制了一套通讯软件，给出了主程序流程图。
The author designs a software of communication based on the communication interface RS485, and shows the flow chart of the main program.
给出了硬件电路图及主程序流程图，阐述了软硬件设计过程中关键技术的处理。
Give the hardware circuit and the main program flow chart to explain the hardware and software design process deal with the key technology.
给出了四汉字显示模块的硬件电路原理图、主程序流程图以及中断显示流程图。
The basic circuit diagram, the main program flow chart and the display interrupt flow chart of four Chinese characterses display module are also given.
给出了硬件电路图设计及主程序流程图，阐述了软硬件设计过程中关键技术的处理。
Hardware circuits and main program diagram are presented, and the processes of key techniques in design of hardware and software are described.
结合S7—200系列plc的特点，制定了通信规约，画出了PLC的主程序流程图，并给出了部分调试结果。
The communicate stipulations of an agreement is constituted according as the characteristic of S7-200 PLC. The main procedure flow chat is drawn. The part of debugging result is shown.
本文给出了系统的主程序流程图，并研究了如何利用波形插值技术以尽量小的采样频率实现尽量高的有效存储带宽(usb)、如何实现波形重现等问题。
Flow chart of system main software is given, how to use waveform interpolation theory to heighten USB (Usable Store Bandwidth) and how to rebuild the waveform are studied.
本文介绍了其硬件电路的设计，并给出了主程序的流程图。
This article describes the design of its hardware and shows the main program flow chart.
对于主程序的描述，还给出了大量的流程图和程序框图。
In the description of main program, the paper gives lots of flow charts and procedure block diagrams.
在软件方面，介绍了主程序的流程图及各部分电路的编程方法。
In the software aspect, it curtly introduces flow chart of main program and the programming method of all ports of circuit.
软件设计部分给出了主程序和子程序的流程图及软件设计思路。
Flow chart and design thought of main and subprogram is presented in software design part.
介绍了控制方案和程序流程图及部分主程序。
Control plan, procedure flowchart and part of main procedure are introduced.
软件设计方案采用模块化的设计思想，给出了主程序的流程图及数据处理的相关说明。
On the software design, modularized program has been used, the procedure flow chart is introduced, and explanation on digital processing is given.
洋细论述了系统的总体结构、部分硬件设计和相应固件程序的实现，给出了主程序和中断服务程序流程图。
Then, the whole systematic architecture, some hardwares and firmware program were detailed, finally, the main program and interrupt service program were provided.
介绍了仪器的硬件结构和软件设计思想，给出了硬件原理电路图和主程序的流程图。
The hardware structure and the main idea of software design are also introduced. Final1y the hardware principle circuit and the main programme flow chart are given.
介绍了仪器的硬件结构和软件设计思想，给出了硬件原理电路图和主程序的流程图。
The hardware structure and the main idea of software design are also introduced. Final1y the hardware principle circuit and the main programme flow chart are given.
应用推荐