建立了所设计电机的二维有限元模型，在此基础上分析了电机的基本特性。
Then the two-dimensional finite element model of HEDS machine has been builded and the basic characteristics of HEDS machine has been analyzed.
四边形面积坐标(QAC)方法是新近提出的构造二维有限元模型的工具。
The new Quadrilateral Area Coordinate (QAC) method is a powerful tool to construct 2d finite element models.
同时通过建立二维有限元模型，研究了工程上采用的回灌和止水措施对减小地表变形的作用。
Furthermore, by the 2-d FEA model, the effect of the reduction of the surface settlement due to different distances of recharge or the depth of water-sealing was studied.
对有钝化层与无钝化层的铝互连线的热应力进行了数值模拟，并建立起互连线的二维有限元模型。
Two-dimensional finite element modeling was used to simulate the thermal stress in unpassivated and passivated aluminum thin film interconnects.
利用解析方法计算了空芯线圈的阻抗，然后通过二维有限元模型进行了阻抗求解，对比结果有较好的一致性。
The impedance of single coil is calculated using analytic method, and the result is compared with that calculated by 2d FEM model.
依据大变形理论和虚功原理对高速切削过程进行分析，建立了基于拉格朗日描述的有限元控制方程并采用二维有限元模型进行模拟。
Large deformation theory and virtual work principle were applied to analyses high - speed machining process, the finite element governing equation was approached based on Lagrangian description.
最后，建立隧道—土体—建筑物二维有限元模型，总结了建筑物的振级随各种参数变化的规律，为研究地铁附近建筑物的减振提供参考。
At last, by establishing tunnel-soil-building 2d finite dynamic elements model, study on the rules of the vibration levels of the buildings wit.
为了验证测试结果，文中对大桥用二维有限元模型建模，用有限元软件ANSYS建立了该桥的二维有限元模型，并计算得到了桥的模态参数。
To verify the results, a 2D finite-element model of the bridge is developed and its modal parameters are calculated by using the finite element software ANSYS.
在比较了多种研究材料内部磁场分布的方法的基础上，分析了二维有限元模型在研究局部磁化中存在的问题以及采用三维有限元计算的必要性。
The problems by using 2D finite element computing modeling to study the local magnetization for tank floor are analyzed, and 3D finite element modeling is set up.
建立了取样管与沉积物接触的二维轴对称有限元模型。
A two-dimensional axisymmetric finite element model of sampling tube and sediments is built.
介绍堆石体的几种本构模型，用二维有限元方法分析了混凝土面板堆石坝的应力变形特性。
The article introduces several structural models, as well as analyzes the stress deformation feature of concrete face rockfill dam using two dimension finite element method.
目的：建立X线头颅侧位定位片硬组织形态二维有限元分析模型。
Objeclive:To establish a two dimensional finite element analysis model for hard tissue morphology on lateral cephalometric X ray film.
文中提出了“双向剪切变形”有限元模型，使三维问题简化为二维问题，计算工作量大为减少。
A two-direction shear deformation finite element model is presented in which a three-dimensional problem is reduced to a two-dimensional one and thus the calculation is much simplified.
用TL法分析研究，建立了二维弹性大变形接触问题的一般实用有限元分析模型。
A general practical finite element analysis model for two-dimentional elastic large deformation contact problems was established using the TL method.
本文采用三维有限元模型分析了荷载作用下自上而下裂缝尖端的应力强度因子，并与二维平面应变模型分析的结果进行比较。
In this thesis, the stress intensity factors of top-down cracks caused by loading are calculated using three dimensional finite element model and compared to the results of plane strain model.
在此基础上，建立了可考虑土体流变性态的二维施工模拟有限元模型。
On the basis of this, the two dimensional FE model that can consider rheology of soil and simulate the staged construction of excavation was set up.
基于MERCHANT粘弹性模型，建立软土地基沉降二维粘弹性BIOT固结有限元计算公式；
The two dimensional formulas of viscous elastic BIOT's consolidation FEM based on MERCHANT's model are presented to calculate settlement of saturated soft clay ground.
改变以往建立有限元模型时采用的二维建模方法，根据塔机实际结构建立三维空间桁架模型；
Instead of tow-dimensional finite element mode, three-dimensional mode in truss structure is established based on the actual structure.
建立了二维轮胎橡胶材料的有限元模型，用应变能密度这个参数模拟了试样承受单向拉伸时裂纹的扩展方向。
A 2-d finite element model of tire-rubber was established to simulate the crack growth of the sample under simple tension, by using the strain energy density parameter.
本文基于三角形网格划分，采用有限元法，建立了平面二维非恒定潮流数学模型。
Based on triangular grids and finite element method, a planar 2-d unsteady tidal flow mathematical model is established in the article.
本文针对二维三温辐射热传导方程的两种简化模型的有限元方程，讨论了两层网格方法。
In this paper, using the finite element method, we discuss the two-grid methods for two simplified models.
采用二维平面模型，“以静代动”的荷载简化方法，建立沥青路面永久变形有限元分析模型。
The two-dimension plane model and the simplification of dynamic loading are applied to create the finite element model for asphalt pavement permanent deformation analysis.
运用有限元数值模型，对托莫尔日特地区成矿初期及主成矿期构造应力场及流体运移势进行了二维计算机模拟。
Numerical modeling of tectonic stress field and fluid seepage potential in Tomorite ore region has been studied in the paper.
用有限元法模拟了连续激光辐照受载金属所产生的软化效应。建立了计算软化效应的二维有限元数值模型。
The termal degradation effects in the preloaded metal thin plate irradiated by CW laser beam are calculated with the finite element method.
在二维有限元动力分析程序dyna2d中加入了两种反应速率模型，对圆头钢弹撞击PB X 940 4炸药的冲击起爆行为进行了数值模拟研究。
Shock initiation behaviors of PBX-9404 impacted by round-nosed steel projectiles were studied numerically by means of adding two kinds of reaction-rate into two-dimensional finite element code DYNA2D.
采用有限元分析软件ANSYS建立了BLDCM的二维和三维定子振动的有限元分析模型，研究了BLDCM定子结构和参数对其振动模态和固有频率的影响。
This paper constructs several 2d and 3d finite element analysis models with ANSYS, studies the influence of the structure and parameters of BLDCM on vibration mode and natural frequency.
体包括有限元计算模型模拟水，热二维和三维运动，多种媒体在变饱和溶质。
The software package includes computational finite element models for simulating the two - and three-dimensional movement of water, heat, and multiple solutes in variably saturated media.
二维石膏块体断裂破坏模拟试验结果与有限元计算十分相近，从而模型试验为解决水工结构断裂问题提供了途径。
The result of two-dimension simulating test of the plaster block for the fracture failure is quite close to that of the calculation from the finite element meth...
二维石膏块体断裂破坏模拟试验结果与有限元计算十分相近，从而模型试验为解决水工结构断裂问题提供了途径。
The result of two-dimension simulating test of the plaster block for the fracture failure is quite close to that of the calculation from the finite element meth...
应用推荐