介绍中间继电器和信号继电器电流线圈的计算，着重分析信号继电器所需满足的条件和在不同情况下的选型。
Calculation of current coil is discussed to middle relay and signal relay, lay stress on signal relay that contents condition and selects a type in different circumstances.
继电器内的浮控开关发动报警信号。
A float operated switch in the relay is used to initiate an alarm signal.
本系统可以实现多路温度信号采集与显示，可以使用按键来设置温度限定值，通过进行温度数据的运算处理，发出控制信号达到控制蜂鸣器和继电器的目的。
The system achieves multi-channel temperature signal acquisition and control. Temperature limit is set by keyboard. The buzzer and relay are controlled by MCU.
这种电荷转移是由于触点的机械释放或闭合、“触点-线圈”电容以及信号和继电器驱动线路之间的寄生电容引起的。
This charge transfer is due to the mechanical release or closure of the contacts, the contact-to-coil capacitance, and the stray capacitance between signal and relay drive lines.
高功率处理能力(300 0瓦特加)在太区继电器- 26允许简单的设置和没有信号电缆复杂的路由操作。
The high power handling (3000 watts plus) relays in the WPR-26 allow simple set up and operation without the complex routing of signal cables.
依据信号必须通过的继电器数量的不同，路径长度(从而，相位延迟)也发生变化。
The path length (and therefore, the phase delay) varies, depending on the number of relays that the signal must go through.
飞兆半导体的21型是一种可调比气动继电器，即输出的压力信号的压力比是无限可调。
Fairchild's Model 21 is an adjustable ratio Pneumatic Relay, whereby the ratio of output pressure to signal pressure is infinitely adjustable.
在检测到待机信号时，单片机控制继电器开关，将电流切断，家电完全断电，消除了待机功耗，达到节能的目的。
When detecting standby signal, microcomputer gives structure to relay switch to cut off the current, then standby power is eliminated so as to realize energy saving.
充电器应发出警报信号后没有任何一方发起一个欠压继电器或零充电电流继电器。
The charger shall give an alarm signal upon failure initiated by either an under-voltage relay or a zero charging current relay.
恒温器包括继电器、阀门、电门等，当恒温器高于或低于所需的数值时，恒温器就发出信号，通常为电信号。
The thermostat generates signals, usually electrical, to activate relays, valves, switches, and so on when the temperature rises above or falls Below the desired value.
由单片计算机控制的计数器自动产生通1秒停4秒的信号，使5路继电器输出带动电喇叭轮流通电。
By single chip computer control of counter automatically generate tong 1 second stop 4 seconds of signal, make no. 5 relay output drive electric horn turns electrify.
提出了一种基于航天继电器微粒碰撞噪声检测(PIND)试验信号的多余物材料特征提起方法。
A feature extraction method of remnant material based on aerospace relay particle impact noise detection (PIND) experiment signal was presented.
门机运行到该位置输出“指定位置”继电器信号。
When the door motor run to the position, it output pointed position relay signals.
本文提出在大型机械式挖掘机的提升电流信号回路中，增加继电器调节环节的方法求得提升力与推压力的合理匹配。
It is proposed in this paper that a relay regulating loop be added in the hoist current signal of large power shovel so that rational coordination between hoist and crowd capacities can be obtained.
前端采集插头接收测试数据，切换继电器电路传递被测电路板信号。
Testing data is received with data acquisition plug, signal from tested circuit board is transferred by circuit of switch relay.
温度继电器检测电动机温度，超过额定温度发出信号，接触器切断主电路，完成电机保护。
Temperature relay tests temperature of motor, if it exceeds rating temperature to send a signal, contactor cut off main circuit to complete protection of motor.
信号切换和变换板由JZX - 18f继电器和WB系列电量传感器组成。
Signal switch circuit board is composed of JZX-18F relay and WB series sensors.
明亮的LED指示灯显示继电器状态和信号强度。
Bright LED indicators show relay status and signal strength.
门机运行到该位置输出“门开齐”继电器信号，门机开始开门推进。
When the door motor run to the position, it output door open fully relay signals and start to open door pushing.
电子模块取代原有的继电器，直接实现对道岔、信号机、减速器的控制和对轨道电路的状态识别。
Electronic modules, instead of traditional relays, perform directly the control of switches, signals and retarders and identification of the status of the track circuits.
在信号机点灯电路中，灯丝继电器只检查点灯灯丝的情况，不检查另外一个灯的情况。
A filament relay only checks the status of the lighting filament in the circuit route of lighting railway signal, not checks the status of another one.
所以射频载波信号即可由System40主机中的同轴继电器进行路由。
Therefore, the RF carrier signal is routed by coaxial relays in the System 40 chassis.
门机运行到该位置输出“门关齐”继电器信号，门机开始关门推进。
When the door motor run to the position, it output the relay signals of "door close fully" and the motor start to close door pushing.
如果实际温度超出了控制范围，则系统会有自动的提示信号，并且相应的继电器会动作。
If the actual temperature exceeds the setting range, the system will automatically give signal, and the corresponding Relay will take related actions.
该装置通过接近开关来产生脉冲信号，由单片机进行计数，按实际要求做出相应的继电器动作输出和模拟量输出。
The device produces pulse signals by a proximity switch and count by the processor, corresponding relay operation output and analog quantity output are done according to real requirements.
在电路，这个信号表明，驾驶继电器。
这种气动继电器输出提供了压力，表示输入信号压力加上预设的偏见高输出流量。
This pneumatic relay provides high output flow at an output pressure that represents the input signal pressure plus a preset bias.
控制电路通过水位检测信号，利用继电器和接触器控制排水机构。
The control circuit controls the water drainage mechanism using a relay and a contactor by the water level detection signal.
该保护继电器实时监控电流信号，具有3段电流保护和接地漏电保护等动作特性。
The protection relay monitors the signals of currents real time and has performance characteristics of three-sect current protection, grounding leakage protection and other protections.
该保护继电器实时监控电流信号，具有3段电流保护和接地漏电保护等动作特性。
The protection relay monitors the signals of currents real time and has performance characteristics of three-sect current protection, grounding leakage protection and other protections.
应用推荐