往复泵启动前必须将排出管路中的阀门打开。
Reciprocating pump discharge pipe must be before the start of the valve to open.
启动前应全开吸入和排出管路中的阀门，严禁闭阀启动。
Should be fully open before the start of suction and discharge pipe valves, non-closing valve started.
启动前应全开吸入和排出管路中的阀门，严禁闭阀启动。
Should be fully open before the start of the suction and discharge pipe valves, non-closing valve to start.
并保证泵在工作时，不超过其允许汽蚀余量。4、吸入和排出管路应该有支架。
And ensure the pump at work, no more than the allowed NPSH. 4, suction and discharge line should be a support.
本实用新型涉及一种设置在吸入含有凝结性物质的瓦斯的螺旋杆型的真空泵的排出管路上的消音器。
The utility model relates to a discharge silencer with raffinate recovering function, arranged on the spiral rod type vacuum pump which sucks gas with coagulability matters.
安装前对吸入、排出管路要清理干净，去掉铁锈等脏物，特别是焊接管路的焊渣必须彻底清除，以免进入泵后咬死。
Before installation on the suction and discharge line to clean, remove rust and dirt, especially welding pipe welding slag must be thoroughly cleared, to avoid killed after entering the pump.
停泵时先按下电控箱上泵的停止按钮(红色)，泵停止运转后，关闭管路上的进水阀和排出阀。
When the pump is going to stop, first press the stop button (Red), then close the water intake valves and the discharge valve.
象排出口，储槽，泵井或空油漆管路等部位都会有颜料汇集。
Areas such as drains, sumps, pump Wells, or dead paint lines may collect pigment.
该阀一般安装在气缸与换向阀之间靠近气缸的管路上，使气缸的排气不经换向阀直接排出，达到气缸快速换向的目的。
General installed in the valve cylinder and the cylinder valve between the tube close to the road, so that the exhaust cylinder without a valve directly into to the cylinder for the purpose of rapid.
在排水管路上设一小迂回管段，可防止外界空气进入蒸发器内并有利于冷凝水排出。
A short passage of return pipe on the water discharge pipe may be placed to prevent outside air into evaporator and facilitate the outflow of condensate.
在排水管路上设一小迂回管段，可防止外界空气进入蒸发器内并有利于冷凝水排出。
A short passage of return pipe on the water discharge pipe may be placed to prevent outside air into evaporator and facilitate the outflow of condensate.
应用推荐