本文分析了电流传送器的基本镜像电流源和电压跟随器模块电路。
The paper analyzes the fundamental part circuit of current conveyor, the current mirror and the voltage follower.
介绍以通用集成运算放大器构成高压放大电路及高摆幅电压跟随器的原理和电路。
The principles and circuit diagrams of the high voltage amplifier as well as the big swing voltage follower using general puropse IC operational amplifiers are presented.
在引入了跨导线性原理后，利用混合跨导线性回路完成了对电压跟随器的设计，进而得到了双极管型电流控制传送器。
After introduction of the tranlinear loop principal, the BJT current controlled conveyor has been designed by using mixed tranlinear loop voltage follower.
本论文工作的电子鼻采用了金属氧化物气体传感器阵列、电压跟随电路。
The metal oxide gas sensor and voltage following circuit are adopted in this electronic nose system.
该电路应用两级差动放大增加电路增益，利用源极跟随器作为电压缓冲器以减少信号电平损失。
It uses tow-stage differential amplifiuers to increasee the circuit gain and uses a source follower as a voltage buffer to decrease signal volt- age losing.
将LVDT输出加在同步稳压器上，跟随一个低通滤波器，产生直流电压送至adc或直接驱动模拟反馈控制系统。
Applying the LVDT's output to a synchronous rectifier followed by a lowpass filter produces a dc voltage that can feed an ADC or directly drive an analog feedback-control system.
将LVDT输出加在同步稳压器上，跟随一个低通滤波器，产生直流电压送至adc或直接驱动模拟反馈控制系统。
Applying the LVDT's output to a synchronous rectifier followed by a lowpass filter produces a dc voltage that can feed an ADC or directly drive an analog feedback-control system.
应用推荐