这创建电压降，这可能被测量确定位置。
This creates a voltage drop, which can be measured to determine position.
在用户内部接线中也存在相当的电压降。
There is also considerable voltage drop in the consumer's internal wiring.
电流时，仪器就会指示出产生的电压降。
When the test current is applied, the instrument will indicate the resulting voltage drop.
电动机起动时的母线电压降不得超过10%。
A bus bar voltage dip during motor starting, shall not exceed 10%.
每一电阻所消耗的电压量称为该电阻上的电压降。
The amount of voltage used up for each resistor is called the voltage drop across that resistor.
减少阴极电压降；
电机堵转电流，检验开始的电压降不应超过15%。
Motor stall current the initial voltage drop for inspection shall not exceed15%.
本文分析了主线上的电压降对电池栅线设计的影响。
The influence of the decreasing of the voltage along the grid line on the design of front contact was analyzed.
如果被切换电流足够高，通道电阻会引起明显的电压降。
The channel resistance may cause a significant voltage drop if the current being switched is high enough.
他使调整三极管上的电压降接近稳定，改进了他的性能。
It keeps the voltage drop across the pass transistor more nearly constant, improving its performance.
该传感器1。5毫欧的电阻可确保极低的功率损耗和电压降。
The1.5mohm resistance of the sensor provides extremely low power loss and voltage drop.
电压降及相应的这部份损耗决定于负荷电流在薄膜上的回路电感。
The value of voltage drop and loss of variation of inductancedepend upon load loop inductance in superconducting film.
电流从两个外部的探针加入，而电压降则在两个内部的探针之间测量。
The current is sourced through the two outer probes and the voltage drop is measured between the two inner probes.
产生的电压降正比于未知电阻，仪表直接指示出电阻值，而不是电压值。
The resulting voltage drop is proportional to the unknown resistance and is indicated by the meter as resistance, rather than voltage.
源-测量单元还可以测量其它的二极管参数，包括正向电压降和击穿电压。
The Source-Measure Unit can also test other diode parameters, including forward voltage drop and breakdown voltage.
由于安培计上的电压降可以忽略，所以所有的测试电压都出现在电阻R上。
Since the voltage drop across the ammeter is negligible, essentially all the test voltage appears across R.
其中两个探针提供恒定的电流，而另外两个探针测量一部分样品上的电压降。
While two contacts supply a constant current, the other two contacts measure the voltage drop across a portion of the sample.
提出了一种对基于标准单元芯片计算其电源线网的静态电压降的分析方法。
Then the circuit network is generated using resistance interconnect model and standard cell equivalent current model.
这些电阻器的阻值应当使其在最大测试电流时的电压降不会影响测量的准确度。
These resistor values should be such that the voltage drop at the maximum measured current will not affect measurement accuracy.
电压互感器至电能计量仪表之间二次线上的电压降，对计量精度有重要影响。
The voltage drop in the secondary wiring connecting the meters with the voltage transformer affects seriously the accuracy of measurement.
本文讨论了低温下P -N结的正向电压降v _ F随温度t变化的特性。
The temperature behavior of the forward voltage VF of the P-N junction is discussed.
为了克服100米以上提升高度时过大的电缆自重和电压降，配有电缆滑车装置。
In order to overcome the weight of cable itself and voltage drop when lifting height is over100m we use cable trolley.
否则，从电池电极吸取的电流将会在电极的内阻上产生电压降并可能使电池极化。
Otherwise, the current drawn from the cell electrodes will cause a voltage drop across the internal resistance of the electrode and may polarize the cell.
为了减少大规模配电网潮流分析的计算量，探讨了电压降和线损的简化计算方法。
To reduce the calculation amount of power flow in large-scale distribution networks, a simplified calculation method for voltage drop and line losses are researched.
结果表明：在电磨损初期接触电压降较小，随着时间延长，接触电压降上升并趋于稳定；
The contact voltage drop was low in the initial stage of wear, then rose to a certain level, finally became stable.
现在，共模电流(ICM)流过r2，产生了一个电压降。这个电压降与被测的电压相加。
Now, the common-mode current (ICM) flows through R2, developing a voltage drop, which is added to the voltage to be measured.
由于流过齐纳二极管的泄漏电流会在电阻器上产生电压降，所以希望使用低漏电的齐纳二极管。
Since the leakage current through the zener diodes results in a voltage drop across the resistor, low leakage zener devices are desirable.
此式表明，蚀坑内的电压取决于蚀坑内各类活性腐蚀因子的化学势梯度和相应粒子的电压降。
The equation shows that the potential depends on the chemical potential gradient of the active ions in the occluded pitting and partial potential drop corresponding to the same ions.
由于所使用的测试电流很低，所以就需要非常灵敏的电压表来测量这种通常在微伏范围的电压降。
Because of the low test current level used, a very sensitive voltmeter is required to measure the voltage drop, which is usually in the microvolt range.
这种技术强制电流通过一对引线流过样品，而用另一对引线测量其电压降从而消除引线电阻的影响。
This technique eliminates lead resistance by forcing a current through the sample with one pair of leads while measuring the voltage drop with a second pair of leads.
应用推荐