A virtual balancing method of a flexible rotor based on rotor dynamic and finite element method is proposed in this paper to decrease the vibrations caused by mass unbalancing.
为了有效地降低回转机械由于质量不平衡引起的振动故障，基于转子动力学理论和有限元数值分析方法，进行了柔性转子系统虚拟动平衡研究。
Flexible set cycloid gear pump rotor pump vane pump with the advantages of a similar volume than pump more than 10% efficiency.
柔性摆线转子泵集齿轮泵与叶片泵优点于一身比同类容积泵的效率提高10%以上。
The revolving system of large-scale vibration mills is simplified into a three rotor system which is joined by two flexible coupling.
通过对大型振动磨机运动特性的研究分析，把其旋转系统简化为由两个柔性联轴节连接的三转子系统。
The model of a spatial flexible rotor beam element is presented, and the dynamic equations of spatial manipulators considering joint and link flexibility is derived.
提出了空间柔性转子梁单元模型，建立了考虑关节及杆柔性的空间机器人动力学方程。
A new technology method of high speed dynamic balance to balance a slender flexible rotor is presented by using auxiliary tool of balance-balance collars in this paper.
提出了一种通过平衡辅助工装——平衡卡箍来进行细长柔性转子高速动平衡的新工艺方法。
Numerical simulations and experimental investigates were carried out for unbalance response of a single disk flexible rotor system with far shaft end mounted on EORD.
通过数值仿真和实验研究远轴端eord支承的单盘柔性转子系统的不平衡响应。
The paper established a modal of bearing system supported by flexible support considering both support damp and rotor external damp.
本文建立了同时考虑支承阻尼和转子外阻尼在内的弹性支承滑动轴承系统模型。
Generator rotor is a flexible stuff with approximately equal horizontal and vertical stiffness.
发电机转子是一个水平刚度和垂直刚度基本相同的柔性体。
Based on the model theory and with the use of electromagnetic exciter (ea), a new imbalance (identification) technique for flexible rotor supported by fluid bearings was presented.
基于模态理论，针对滑动轴承支撑的挠性转子系统，提出了一种新的不平衡量在线识别方法。
In this paper, first, the concepts of the bend-rigid critical speed and bend-flexible critical speed of rotors are presented, and then the concept of a semi-flexible rotor is presented.
本文先提出了弯曲刚性临界转速与弯曲挠性临界转速的概念，然后又提出半挠性转子的概念。
In addition, using a pair of strength shield which is connected with the flexible docking part can strengthen the bonding between the ear of the shaft and the rotor shaft.
另外，使用一对与弹性对接部抵靠的强化垫片，以加强轴耳与转轴杆之间的结合强度。
In addition, using a pair of strength shield which is connected with the flexible docking part can strengthen the bonding between the ear of the shaft and the rotor shaft.
另外，使用一对与弹性对接部抵靠的强化垫片，以加强轴耳与转轴杆之间的结合强度。
应用推荐