It can also be used to measure the AC voltage signal with superimposed DC component.
能测量含有直流分量的交流电压信号。
Signal control cable applied the copper cored cable which may withstand 500 AC rated voltage.
信号控制电缆采用能耐交流额定电压500伏以上的铜芯电缆。
For capacitive sensing, driving signal with DC bias voltage and ac voltage is usually necessary for the measurement of capacitance.
对电容式加速度计，为测量其电容的变化，通常需要带直流偏置的交流电压信号来驱动。
For AC voltage measurement, an RMS converter circuit or a precision rectifier circuit convert the AC signal into a DC voltage.
对于交流电压测量﹐利用有效值转换电路或精密整流器电路将交流信号转换成直流电压。
By comparing the heating effect of an unknown AC signal to that from a known DC reference, metrologists can determine the RMS AC quantity (voltage or current) in terms of the DC quantity.
为了对比一个已知直流参考的未知交流信号热效应，计量人员可以确定在一段时间内直流的交流有效值(电压或电流)。
If the AC voltage at the input is large, part of this signal is rectified, producing an error in the DC signal being measured.
如果输入端的交流电压很大，其一部分信号被整流，于是在被测的直流信号中产生了误差。
An arc due to an AC signal usually quenches itself as soon as the voltage level passes through zero.
交流(ac)信号产生的电弧通常在电压通过零点时就会自己熄灭。
Feedforward signal includes the information of both grid voltage and DC side load. Power balance between the input and output can be maintained by adjusting AC side currents.
前馈信号同时包含了电网电压和负载的信息，通过快速调节交流侧进线电流，使得系统功率平衡得以维持。
Subsequently, a novel controller for DC bus voltage regulation is put forward according to the small signal model based on the instantaneous power balance in AC and DC sides of three-phase SAPF.
然后根据交流侧和直流侧的功率平衡方程，推导了电压环的小信号模型。最后基于该模型设计了一种高动态性能的直流电压调节器。
T3 on sampling signal panel is sampling transformer, which can convert primary voltage (0 ~ 380v) of primary transformer into 0 ~ 10v AC voltage.
取样信号板上T3为取样变压器，将整流变压器一次电压(0 ~ 380v)变为0 ~10v交流电压。
T3 on sampling signal panel is sampling transformer, which can convert primary voltage (0 ~ 380v) of primary transformer into 0 ~ 10v AC voltage.
取样信号板上T3为取样变压器，将整流变压器一次电压(0 ~ 380v)变为0 ~10v交流电压。
应用推荐