Reeling shaft: Air compression thimble type.
卷取轴：空压顶针式。
Gripping mode: Air compression type grip holder.
夹头方式：空压作动式夹头。
ZN: Air compression coefficient in standard condition;
气体在标况下的压缩系数；
Air compression ratio is in absolute pressure calculation.
空气的压缩比是在绝对压力计算的。
The third must be considered is the air compression ratio.
第三个应予考虑的问题则是空气的压缩比。
Related suggestion and scheme are put forward for the retrofitting of air compression system.
提出了空气压缩系统改造的相关建议和方案。
Electrical resonant method is used in crankshaft fatigue testing of an air compression machine.
采用电动谐振法对空压机曲轴进行疲劳试验。
This is the first unit in support of the new MPACT Pure Air Compression Technology systems development program.
这是第一个支持新式MPACT纯空气压缩技术系统开发计划的单元。
Still, the new engine gets a 14-to-1 ratio for fuel-air compression, compared with the more common 10-to-1 ratio for engines.
新款引擎的燃料空气压缩率高达14比1，而一般的引擎只有10比1。
The invention relates to a method for braking exhaust gas, which is implemented by the following steps: air compression and pre-dehydration are carried out;
本发明涉及一种废气制动的方法，是通过以下步骤实现的：进行空气压缩和预脱水；
Finally, with the air of freedom multiplied by the number of air compression ratio that the pressure can be drainage, to determine choose which kind of air compressor.
最终，用自由空气的数量乘以空气的压缩比即可得出排水所需的压力，以确定选择哪种空压机。
The invention has the advantages that structure is simple, processing is easy, air compression without oil is provided, work is stable, service life is long, and noise is small.
本发明的优点是：结构简单，加工容易，可提供无油压缩空气，工作平稳，寿命长，噪音小。
Thus, the oxygen concentration in air compression chamber is controlled below 23% and the reformed head cover is applicable to air compression chamber for hyperbaric oxygen treatment.
改造后的输氧头罩适用于空气加压舱内治疗时使用，能大大提高安全性和治疗的有效性。
No air bubbles were present in the green ice, suggesting that the ice was not formed from the compression of snow but instead from the freezing of seawater.
绿色冰层中不含气泡，这表明了这种冰层是由冻结的海水形成的，而不是凝结压紧的积雪。
The upper portion of the air intake is incorporated with an intake ramp designed to generate a rearward leaning oblique shock wave to aid the inlet compression process.
进气口的上部为进气口混合斜面设计，这样设计的目的是为了产生斜振波以帮助进气压缩过程。
The heat generated in the compression phase is normally radiated into the air outside the building.
压缩阶段产生热量一般被辐射到建筑物外的空气中。
Then clean air into the motor drive by the rotor of compression.
接着干净的空气进入由马达带动的转子进行压缩。
Air compressor suction certain volume and pressure of the air, and the compression for smaller pressure higher after air output.
空压机吸入一定体积和压力的空气，并将其压缩为体积更小压力更高的空气后输出。
Due to compression process influence the air dew point of compressed air in the pipeline, run it will gradually decrease temperature, so the compressed air system always have liquid water.
由于压缩过程影响空气的露点，压缩空气在管线中运行时温度会逐渐降低，所以压缩空气系统中总是有液体水存在。
Heat gained from burning fuel increases the pressure, thereby forcing the piston to move, expanding the air volume beyond the volume when compression began.
燃料燃烧热上涨增加了压力，从而迫使活塞移动，增加量超出时的空气量压缩开始。
An exhaust port (20) allows dried air out of the compression chamber.
一排气口(20)让干燥空气的压缩会议厅。
Air in its liquid state, intensely cold and bluish, obtained by cooling and compression.
液态空气：处于液体状的空气，呈蓝色，极度冰冷，通过冷却和压缩而成。
For most users will tell, out of the gas consideration, in house in the compression, often can use many sets of air compressor.
对大多数用户来讲，出于对用气的考虑，在压缩站房内，往往会使用多台空压机。
So the compression process and do not increase the compressed air volume of water, it is just simply make moisture increased thick.
因此压缩过程并不能增加压缩空气的水气量，它仅仅是简单地使水气增浓。
In physical and mechanical indexes, the basic density, air-dried density, compression strength parallel to grain, MOR, MOE and toughness of mature wood are higher than that of juvenile wood.
在物理力学性质指标中成熟材的基本密度、气干密度、顺纹抗压强度、抗弯强度、抗弯弹性模量及冲击韧性高于幼龄材；
Exergy loss in an air separation unit mainly derives from the compression and expansion processes of fluid, heat exchange, rectification and throttling.
空分设备有效能损失主要存在流体的压缩与膨胀、热交换、精馏及节流减压等。
The application of two-stage compression forward bootstrap air refrigeration cycle is introduced.
最后介绍了双级压缩正升压循环实际流程空气制冷机的应用。
Concurrently analyzed is that improvement of effective thermal efficiency after rise in compression ratio and water injection is resulted from thermal efficiency promotion of fuel-air ideal cycle.
同时分析了提高压缩比并掺水蒸气后有效热效率提高的主要来源是燃料—空气理想循环热效率的提高。
Concurrently analyzed is that improvement of effective thermal efficiency after rise in compression ratio and water injection is resulted from thermal efficiency promotion of fuel-air ideal cycle.
同时分析了提高压缩比并掺水蒸气后有效热效率提高的主要来源是燃料—空气理想循环热效率的提高。
应用推荐