Amorphous material is one of the most active part of the solid phase of soil.
无定形物质是土的固相中很活跃的一个组成部分。
The crystallization temperatures of amorphous phases in the products are higher than those of amorphous alloys with single phase, and hardly independent of the milling conditions and the composition.
不同球磨条件下的产物含有的非晶相的晶化温度比单一非晶相合金的晶化温度稍高，并且与球磨条件以及成分的关系不大。
The microstructure of the intergranular amorphous phase is different with that of the complete amorphous.
晶间非晶相的微结构不同于完全非晶，并随淬速的变化而改变。
The main attention has been paid on amorphous rare earth- transition metal alloy films for magneto-optical storage and amorphous semiconductor films for phase change optical storage.
我们主要注意磁光型存储的非晶态稀土-过渡金属合金薄膜和相变型光存储的非晶态半导体薄膜两个方面。
There is amorphous phase in diffusion layer of the hot-dip La-aluminizing and the content of the amorphous phase increases due to the addition of rare earths la.
热浸镀铝-镧钢的扩散层中存在非晶态相，且稀土镧的添加可使扩散层中的非晶含量增加。
Stability of an amorphous alloy is a key for synthesizing bulk amorphous alloy, short range order formed after relaxation has important influence on nucleation of crystalline phase in amorphous.
非晶合金的稳定性是制备大块非晶合金的关键，而弛豫后形成的短程有序结构对非晶中的晶体相形核有重要的影响。
The compression strength of heat treated amorphous alloy is decreased remarkably due to the occurrence of precipitated phase or crystallization phase in the amorphous alloy.
热处理后，当非晶合金中出现分离相或晶化析出相时，压缩强度将急剧下降。
In addition, the amorphous phase also contains two components: an anisotropic interfacial amorphous phase and a melt-like amorphous phase.
另一方面，非晶相也由两种不同的分量组成：运动受限的各相异性的非晶界面相和高度可动的橡胶型的非晶相。
The metallic glass layer is a dense and homogeneous amorphous phase and is capable of satisfactorily exerting the functions of metallic glass, such as corrosion resistance and abrasion resistance.
金属玻璃层是致密且均一的无定形相，可以充分地发挥耐 腐蚀性、耐摩耗性等金属玻璃的功能性。
As there exists a amorphous phase in cement clinker and a serious multi-peak overlap phenomenon, huge difficulty in the X-ray quantitative analysis results.
由于水泥熟料存在非晶相以及水泥熟料严重的多峰重叠现象，给X射线定量分析带来了极大的难度。
But the CeO2-TiO2 mixed oxides prepared by conventional drying method show lower pore volume and surface area with serious aggregation, and amorphous phase compared to the corresponding aerogels.
采用普通干燥法制备得到的复合氧化物具有较低的孔体积和比表面积，颗粒间团聚较严重，但无“孤岛”状大颗粒，晶相为无定型结构。
The amorphous phase is found in the outer layer of hot-dip aluminized layer.
结果发现，镀铝层的表面层存在非晶态金属相。
This paper discusses the advantages of two phase method consisting of amorphous liquid phase and main phase with composition very close to nominal 2:14:1 phase.
探讨了使用非晶态液相和接近2：14：1成分的主相的双相合金工艺制造烧结钕铁硼稀土永磁材料的优越性。
In terms of biogenic calcium carbonate minerals, amorphous precursor phase is generally considered to be formed under the joint regulation of biological macromolecules and inorganic ions.
对生物成因碳酸钙而言，普遍认为其非晶的前驱体相是在生物有机大分子和无机离子共同作用下形成的。
We also discuss in detail the relation between heat treatment technology, phase structures, optical spectroscopic properties with apparent crackle, crystalline state and amorphous state etc.
讨论了PLZT铁电薄膜的热处理工艺条件、结构特性、光谱特性与材料的表观裂纹、晶态与非晶态之间的关系。
When the temperature of the blend is between melting-point and phase-mixing point, both melting-crystal phase and amorphous miscible phase are present.
这对高聚物是一完全互溶的共混体系，当共混体系处在熔点和相混合温度之间时，同时存在结晶的熔融相和无定形的相容共混相。
The field intensity of ion and the temperature of mixed dissolve are the primary factors that influence phase separation and crystallizations to amorphous solids.
离子场强和混溶温度是影响非晶态固体相分离和结晶的主要因素，相分离为玻璃的结晶成核提供一种驱动力；
The characteristic of amorphous phase synthesized by mechanical alloying(MA) was reviewed.
简述了机械合金化（MA）制备非晶的特征。
The quantification of amorphous phase can not be obtained by Rietveld.
结果发现，镀铝层的表面层存在非晶态金属相。
On the other hand, the microstructure of amorphous materials does not change with the phase change.
另一方面，无定形材料的微观结构不随相变而改变。
The present invention relates to a multi-component large-block amorphous alloy material with large supercooling liquid phase area and high thermal stability.
大过冷液相区与高热稳定性的多组元大块非晶合金材料，它涉及一种非晶态材料。
The invention takes copper mold casting for preparation. The crystalline phase of 2-5 nanometers is distributed on the amorphous body, and the volume fraction is 5-10%.
采用铜模浇铸的方法来制备，该合金非晶基体上弥散分布着2-5纳米的晶态相，体积分数为5-10％。
The glass has an amorphous structure and exists at the composite phase interface and ceramic grain boundary.
玻璃料以无定形态存在于复合材料中的相界与陶瓷晶界上。
The glass has an amorphous structure and exists at the composite phase interface and ceramic grain boundary.
玻璃料以无定形态存在于复合材料中的相界与陶瓷晶界上。
应用推荐