The peak anode current is a massive 250 Amps.
阳极电流的峰值是一个巨大的250安培。
The automatic machine of anode current collector and bottom plate spot welding was designed and prepared successfully.
报导了碱锰电池负极集流体自动焊接机的研制。
Test result shows that the circuit decreases the effect of temperature to anode current, improves the stability of neutron yield.
测试结果表明，该电路减小了温度对阳极电流的影响，改善了中子产额的稳定性。
The influence of anode current density, polishing temperature, polishing time and stirring modes on polishing quality was discussed.
探讨了阳极电流密度、抛光温度、抛光时间和搅拌方式对抛光质量的影响。
The picoammeter reads the current at the last dynode, which is equal to the anode current minus the current flowing to the previous dynode.
皮安计在最后一个倍增管电极处读取电流，此电流等于阳极电流减去流过前一个倍增管电极的电流。
Silicon in an anode active substance layer provided in an anode current collector has an amorphous structure with a low degree of a local order.
设置在负极集电体上的负极活性物质层中的硅具有局部有序性的程度低的非晶结构。
According to Fourier's law and Kirchhoff's law, a mathematical model of prebaked anode current and temperature fields of aluminum reduction cell was built.
根据傅里叶传热定律和基尔霍夫导电定律，建立了预焙阳极铝电解槽阳极传热、导电的数学模型。
To keep the anode current stable suitably, a temperature compensated circuit based on a thermal resistor to self-regulate the filament voltage has been designed.
为使阳极电流稳定在合适的区间内，设计了一种利用热敏电阻自动调节中子管灯丝电压的温度补偿电路。
The count rate at the extrapolation of bias to zero varies monotonously with the anode current of phototube and tends to the activity of source as the inverse anode current approaches zero.
甄别电压外推到零时的计数率随光电倍增管阳极电流而改变，当阳极电流的倒数趋于零时，计数率趋于被测源的活度。
The measured results indicated that the carbon consumption of a prebaked anode decreased slightly with increasing anode current density towards a value of about 110% of the theoretical consumption.
研究结果得出，预焙阳极的炭阳极消耗随阳极电流密度的增加而趋向于理论消耗110%左右。石墨阳极消耗随电流密度增加而略有提高，其范围在135 ~ 150%之间。
By running an electrical current through the cell, using an ordinary battery charger, the copper in the anode (and in the pins) dissolves and is deposited on the lead cathode.
要想让电流通过电解池，你需要一个普通的电池充电器。阳极和针脚里的铜溶解之后会聚集在阴极上。
Anode slime: in the current under the action of the residue after an anodic dissolution.
阳极泥：在电流作用下阳极溶解后的残留物。
Electrolysis: make the current through the electrolyte solution at the anode and cathode cause REDOX reaction process.
电解：使电流通过电解质溶液而在阳极，阴极引起氧化还原反应的过程。
It and reversing current different is not to be, but with a anode intermittently stop, because the intermittent power supply current interrupted, cathode potential with time periodically change.
它与换向电流所不同的是不把镀件作阳极，而是间歇地停止供电，由于间歇中断电流，阴极电位随时间周期性地变化。
Two layers of organic material are sandwiched between two conductors. When a current passes from the cathode to the anode a bright light is produced by the organic material.
两层有机物质层夹在两层导体之间。
The current efficiency of the anode significantly dropped with the increasing ac density.
阳极电流效率随交流电流密度的逐步增大而明显下降。
Electric lift oil: containing alkali solution in to parts used as an anode or the cathode, in the current function, remove the process of surface oil parts.
电解除油：在含碱溶液中，以制件作为阳极或阴极，在电流作用下，清除制件表面油污的过程。
The effect of the current density and fuel cell temperature, humidified temperature of cathode and anode, porosity of porous diffusion layer on the results mentioned above are discussed.
讨论了质子交换膜燃料电池运行电流密度和温度、阴极和阳极加湿温度、气体扩散层孔隙率等参数对以上结果的影响。
To realize the high efficiency of dernisting, thenew type cathode wires and anode tubes with superperformance were developed for increasing the current density and field intensity.
实现除雾高效化，关键在于研制高性能的新型阴极线和阳极管，提高电流密度和电场强度。
The measuring methods of D C TIG welding arc anode sheet surface current density split sheet method and probe (made by ourselves) method were analysed and compared.
对直流TIG电弧阳极板表面电流密度的测量方法——分离极板法和探针（自制）法进行了分析比较。
Self-produced stray current can severely corrode the metallic boom of hanging type anode.
自生杂散电流会严重腐蚀悬挂式阳极的金属吊杆。
The critical factor causing the arc length fluctuation to affect the input heat power to the anode proves to be the phenomenon of the current dispersion in plasma arc itself.
文中指出，弧长波动影响阳极输入热功率的重要因素是等离子电弧本身存在着电流分散现象。
The results show that the anode passivation can be decreased through the mechanical force of the drum anode, and the current efficiency can be improved.
结果表明：转鼓阳极的机械力作用可以缓和阳极钝化，提高硬质合金废料电解的电流效率。
The sacrificial anode cathodic protection features no power source, simple management and even current distribution. It is well received especially on special shaped structure.
牺牲阳极法阴极保护因其不需电源、管理简单、电流分布均匀，特别是对于形状特殊的构筑物。
Auxiliary anodes: in addition to the normal in electroplating need outside anode, and to improve the product plated on the surface of the current distribution and use additional anode.
辅助阳极：除了在电镀中正常需用的阳极以外，为了改善被镀制件表面上的电流分布而使用的附加阳极。
From the experiment result of metal specimens buried in underground, discussing the influence of AC stray current on cathode protection by using galvanic anode method.
根据室外现场埋片试验结果，讨论了杂散电流对牺牲阳极阴极保护性能的影响。
The current researches of metal inert anode in China are presented primarily.
着重介绍了国内对金属陶瓷惰性阳极材料的研究现状。
This article analyses the electric energy loss of adjusting the line current by stages, which has a bigger wave motion when the anode effect happens-a phenomenon peculiar to aiu-minium reduction.
分析了由于铝电解的一种特有现象——阳极效应的发生造成铝电解系列电流波动较大，在对系列电流分段调整时铝电解电能的损失情况。
This article analyses the electric energy loss of adjusting the line current by stages, which has a bigger wave motion when the anode effect happens-a phenomenon peculiar to aiu-minium reduction.
分析了由于铝电解的一种特有现象——阳极效应的发生造成铝电解系列电流波动较大，在对系列电流分段调整时铝电解电能的损失情况。
应用推荐