Introducing load increment factor in applied loads, the load increment of the whole loading history can be controlled to improve the quality of solutions.
在荷载增量向量中引入荷载增量因子，就可以通过控制荷载增量因子来控制结构的整个加载历程。
ArcExplorer loads all the data into main memory, and all filtering is applied there.
ArcExplorer将所有数据装载到主存中，并在那里应用所有过滤。
Prioritizer: a list of rules and priorities applied to chunks and loads to determine order of processing.
优先排序器：应用于数据块与加载以确定处理顺序的一个规则与优先级列表。
The paper offers a method of identification of dynamic loads applied to a continuous system.
本文提出连续系统动态载荷识别的一种时域方法。
The steel frames resist lateral loads applied in the short direction while diagonal bracing stabilizes the building longitudinally.
当斜向支撑确保纵向稳定时，钢框架结构只需抵抗短方向的侧荷载。
The back-to-back arrangement is especially good when the distance between bearings is short and moment loads are applied.
在背靠背的安排是特别好时，轴承之间的距离很短，目前负荷得到应用。
This is necessary because the loads are usually applied normal to the calibration fixture surface.
之所以有此需要，是因为所加载荷通常是垂直于校准装置平面的。
These loads are normally applied by hydraulic jacks acting directly at the point of application of the force.
通常这些荷载是用液压千斤顶直接施加于力的作用。
The instrumented shutdown analysis forms the basis for the Fujian Ethylene Plant loads except for the maximum safety valve load on each flare header, where the non-instrumented basis is applied.
好像是说对于火炬总管上负荷是基于最大安全阀的负荷来决定的，这是个运用非仪表基准的例外情况。
Loads are commonly applied with universal testing machines, hydraulic cylinders dead weights, or some form of pressure.
通常是用万能试验机、液压缸重物或某种形式的压力施加载荷。
Finite element method is applied to analyze the windage of suspension insulator strings under dynamic wind loads.
针对传统计算方法的不足，采用有限单元法计算分析动态风作用下悬垂绝缘子串的风偏。
When there is not any information of load-appearance probability, approximately applied in this paper is the maximum value of the probability of structural failure under the action of various loads.
当缺少荷载出现概率资料时，本文采用在各种荷载位置作用下结构失效概率的最大值。
No external loads are applied, and one of the extreme nodes in the bottom surface is considered to have zero displacement in the longitudinal direction, while the other is fully constrained.
没有外部负载有应用，与一个极端的节点在底层外表被以为具有零位移纵向方向，另一种是完整约束的。
Typically, hydrogen embrittlement cracks propagate rapidly once loads are applied to the part.
通常，部件承载后，氢脆裂纹扩展迅速。
The reciprocal theorem is applied to research on the bending problem of set square with free hypoteuse and a clamped edge under uniform loads, the accurate solution of this problem is given.
应用功的互等定理研究了在一集中载荷作用下三个角点被支承的三角形板的弯曲问题，给出了该问题的精确解。
The repetitive control approach is applied to the single-phase aviation static inverter (ASI) for solving the wave distortion of the output voltage caused by nonlinear loads.
针对航空静止变流器带非线性负载造成的输出电压波形畸变问题，分析了采用重复控制技术的单相静止变流器控制模型和补偿器的数学表达形式。
In finite element and reliability analysis, the randomness of the structural physical parameters, geometry dimensions and the stochastic loads applied on structures are all considered.
在同时考虑结构物理参数、几何尺寸和作用荷载随机性的情况下，给出了结构有限元和基于可靠性的灵敏度分析方法。
The dynamic forces applied on such system include loads due to waves, -winds, currents, operations, earthquakes, etc.
作用于这一系统上的动载荷包括波灌、风载、流、设备载荷、地震等。
The algorithm is applied for similarity mining of the time series data of the electrical loads for a steel plant. The simulation results show the effectiveness of the algorithm.
将该算法用于某钢铁企业的电力负荷时序数据，计算结果表明了算法的有效性。
In this paper, the method of singularity function is applied to the structural plastic limit analysis, and simplified the calculation of limit loads of some annular plates of fixed supports.
本文将奇异函数法应用于结构的塑性极限分析，简化计算某些固支环形板的极限荷载。
The cutting loads of cemented carbide drilling tool in drilling PCB are analyzed, a method applied to testing the brazing strength of cemented carbide cutters is studied.
分析了硬质合金微型钻头加工时的受力状态，根据钎焊硬质合金刀具的强度指标要求，研究了刀具焊接强度的检测方法。
The dynamic response analysis of the rotating blade when the aerodynamic and mechanical loads are applied on the blade.
叶片在气动和机械载荷作用下的结构动力学响应分析。
A new type of liquid propeller-single-blade propeller is discovered and its dynamic equations are established by means of kinematic analysis of the blade and loads applied on the blade.
提出了一种新型的流体推进器——单叶片推进器，通过对叶片的运动学和负载的分析，建立了该推进器的运动方程。
Relatively small loads are applied thousands of times.
相对较小的载荷应用数千次。
Referring to static mechanics, three types of static operating conditions are simulated and static finite analysis is made after the loads are applied.
然后根据静态力学的有关知识，提出了立柱三种静态工况的模拟，并施加载荷对立柱进行静力有限元分析。
Secondly, cooperative game theory is applied to allocating unit start-up costs among loads.
第二，尝试运用基于合作博弈的成本分摊理论来分摊机组启动费用。
Cooperative game theory is applied to allocating unit start-up costs among loads.
尝试运用基于合作博弈的成本分摊理论来分摊机组启动费用。
Cooperative game theory is applied to allocating unit start-up costs among loads.
尝试运用基于合作博弈的成本分摊理论来分摊机组启动费用。
应用推荐