The power supply shall be protected when any output operation in circuit short condition. The power supply shall be Auto restart when the fault condition is removed.
在任何时候，任何输入条件下，当输出操作在短路情况下，电源供应器将进入保护模式，当故障消失后，电源要能自动恢复正常。
For the process and database instance failures, you can enable automatic crash recovery by verifying that the database configuration auto restart is set to on (by default, auto restart is on).
对于流程和数据库实例故障，可以通过确认已将databaseconfigurationauto restart设置为on(缺省情况下，自动重启已启用)来启用自动故障恢复功能。
When the Torrium detects "loss of prime" it waits 5 minutes then goes into auto retry mode, whereby it will restart the pump to see if prime can be re-established automatically.
当Torrium检测到“进水口失水”情况，它会先等5分钟，再开始自动重试模式，通过这个过程它可以重新启动水泵并观察引水问题是否可自动被解决。
ATC, temperature sensor failure cutoff and alarm, high-temperature cutoff and low temperature alarm, blocked pump motor, auto-restart after power failure and run-dry protection.
数显温度校正，传感器异常保护和报警，高温保护和低温报警，泵马达堵转，停电恢复，防干烧。
ATC, temperature sensor failure cutoff and alarm, high-temperature cutoff and low temperature alarm, blocked pump motor, auto-restart after power failure and run-dry protection.
数显温度校正，传感器异常保护和报警，高温保护和低温报警，泵马达堵转，停电恢复，防干烧。
应用推荐