According to the calculation theory of normal section bending bearing capacity, the calculation formula of cracking moment of high-strength concrete beam was derived by the concrete mechanic method.
根据正截面受弯承载力计算理论，运用混凝土力学分析方法，导出高强混凝土梁的开裂弯矩计算式。
The maximum working pulling force of bolt-set connection under a bending moment is measured and analyzed. An accurate calculation method is presented, which tallies with the actual situation.
对受翻转力矩螺栓组联接的最大工作拉力进行测试与分析，提出符合实际受力状态的精确计算方法。
The methods for calculation of additional vertical bending moment and confining bending moment of flanges are deducted, and the type and quantity of radial reinforcements are proposed.
为此，导出了竖向附加弯矩和法兰盘约束弯矩的计算方法，提出了径向联系筋的形式及数量。
This paper analyses the relativity between bending moment (M) and axial force (N) in calculating ground supporting capacity, and the effect of relativity on reliability calculation.
分析了在地基承载力验算中，弯矩M与轴力N之间相关性的存在，以及相关性对可靠度计算的影响。
From the test results, the calculation method for crack resistant bending moment is proposed.
在试验分析的基础上，提出适用于高强轻集料钢筋混凝土梁的抗裂度计算方法。
This paper introduces the bending moment and shearing force calculation formula of rudder and rudderstock according to the model required by classification society.
本文给出了按船级社规定的模型计算舵和舵杆中的弯矩和剪力的公式。
The limit load calculation of welding piping tees under the action of the in plane bending moment was derived based on the limit analysis.
基于极限分析的观点，推导了工业中焊制三通在面内弯矩作用下的极限载荷估算式。
This approximate method is simple and suitable for fast calculation on the bending moment of continuous beams.
该法适用简单，可用于快速近似计算连续梁弯矩。
Based on a new orthogonal cutting model with cutting bending moment, a theoretical calculation method of the cutting bending moment is put forward.
根据带弯矩的正交切削新模型，提出了切削弯矩的理论预报方法。
According to this view, this paper compiles a practical calculation program, which provides the vertical and lateral shear, bending moment as wel...
按照这一思想编制了实用程序，可对一般船进行外力计算，提供纵向和水平方向的剪力、弯矩以及扭矩。
The calculation of ledger maximum bending moment and deformation the even load of scaffold board and live loads above the ledger.
“跃龙”品牌系列电缆桥架的最大载荷、支撑间距应小于允许载荷和支撑荷和支撑跨距。
After the completion of the above, the calculation for each group above data analysis, the bending moment adjustment, internal force combination.
以上计算完成后，对以上各组数据停止数据剖析，弯矩调整，内力组合。
After the completion of the above, the calculation for each group above data analysis, the bending moment adjustment, internal force combination.
以上计算完成后，对以上各组数据停止数据剖析，弯矩调整，内力组合。
应用推荐