Risk-based maintenance technology for boiler heating surface is a new emerging technology that evaluates the risk rank and optimizes the maintenance strategy.
锅炉受热面风险维修技术是一项新兴技术，根据评价后的风险级别来优化维修策略。
This article, to the Meng Da power plant 330MW unit, develops one et of complete power station boiler heating surface dust stratification and slag-bonding monitoring system.
本文针对内蒙达旗电厂330MW机组，开发了一套完整的电站锅炉受热面结渣积灰监测系统。
Fouling and slagging not only prevent the heat transmission of heating surface but also influence the normal operation of boiler.
阐述了积灰和结渣不仅降低了锅炉受热面的传热能力，而且还对锅炉的实际运行产生较大的影响。
The paper deals with endanger of scaling on heating surface of boiler and importance of boiler water treatment.
论述了锅炉受热面结垢的危害及水质管理工作的重要性。
The combined application of finned heating surface and shock wave ash removing technique is a very good choice in boiler retrofit.
扩展受热面强化传热技术和冲击波清灰技术联合应用是锅炉改造的优化选择。
High temperature corrosion of heating surface of a boiler often leads to burst of boiler? Tube, it initiates boiler failure.
锅炉受热面的高温腐蚀常常会导致炉管爆裂，引发锅炉故障。
This paper analyzes the impact of the variation of coal proportion on flying-ash erosion in heating surface at the rear of coal-fired boiler.
飞灰磨损是导致锅炉受热面管壁减薄失效的一个重要因素，煤质的好坏又直接影响着飞灰磨损的强度。
The damages of heating surface fouling and slagging in boiler and their forming process are elaborated in detail.
对锅炉受热面积灰、结渣造成的危害及其形成过程进行了详细的介绍。
The calculate formula premise of the residual life of boiler convection heating surface is pointed out, and the cause of heating surface wearing due to the quality decline of coal is analyzed.
指出了影响锅炉对流受热面剩余寿命计算公式的应用前提，分析了由于燃煤质量的下降，造成受热面磨损的原因。
Abrasion and corrosion of heating surface, superheater tube cracking and weld leakage are the main cause of waste heat boiler breakdown in sulphuric acid plant.
硫酸废热锅炉故障主要是由受热面管子的磨损、受热面的腐蚀、过热器爆管及焊缝漏水等引起的。
A detailed numerical simulation study was conducted of the flow distribution in the heating surface tubes of a boiler roof superheater featuring a distribution header with a bent inlet.
对一台锅炉中其分配集箱带弯头入口的顶棚管过热器受热面管流量分配做了较详细的数值模拟研究。
The boiler is designed multipass structure with large volume and heating surface area, several times of ordinary boiler. Load variation ratio should not be less than 2 times .
垃圾锅炉设计成多烟道结构，体积庞大，受热面积数倍于普通锅炉，且负荷变化率不小于2。
The erosion-abrasion, which is one of the main reasons of the leakage of the power-station boiler-conduit-pipe 'contra-flow heating-surface, accounts for 75% or more of the accidents of the boiler.
冲蚀磨损是电站锅炉对流受热面管道泄漏的主要原因之一，占到锅炉事故的75%以上。
The erosion-abrasion, which is one of the main reasons of the leakage of the power-station boiler-conduit-pipe 'contra-flow heating-surface, accounts for 75% or more of the accidents of the boiler.
冲蚀磨损是电站锅炉对流受热面管道泄漏的主要原因之一，占到锅炉事故的75%以上。
应用推荐