The raw data output from the measuring equipment for surface roughness and coating thickness must be attached to all required documentation.
对所需的所有文档还必须附上测量设备测量表面粗糙度和涂层厚度时输出的原始数据。
Wet film thickness gauges may be used during coating to ensure correct coating thickness.
在涂敷时应采用湿膜测厚仪以确定准确的涂层厚度。
Other inspectors can also be adjusted by the amount of zinc coating to get the thickness of the coating.
别的查验人员也可经过镀层锌附着量进行换算得到镀层的厚度。
Deposition continues until the coating thickness becomes sufficient to form a barrier against further paint attraction.
继续沉积，直到涂层厚度足够形成一个屏障以对抗进一步的油漆引力。
In order to improve the fluidity of hot dipping liquid at low temperature, avoid coating thickness, and improve the coating appearance, pure aluminum often participate in 0.01% ~ 0.02%.
为了提升在较低温度下热浸镀液的流动性，避免镀层过厚，并进步镀层外观，常常参加0.01% ~ 0.02%的纯铝。
It finally discusses measuring methods of coating thickness and technical problems to be solved in measuring methods.
文章最后讨论了“涂层厚度的检测方法”及检测方法中需解决的一些技术问题。
In the course of color coating steel plate production, coating thickness directly effects product cost and quality.
彩色涂层钢板的生产过程中，涂层的厚度直接影响产品的成本和质量。
The results show clearly that the microwave absorption of dispersions of metallic ultra fine grain relates to particle size, coating thickness, and method preparation.
结果表明：金属超细颗粒弥散系的微波吸收与粒度、涂层的厚度及配制方式有关。
On the basis of electromagnetic induction principles, this paper primarily discusses the design of electrocircuits and probes for coating thickness monitor.
该文根据电磁感应原理，主要讨论涂层厚度监测仪电路和探头的设计。
Micrograph technology was used to measure film coating thickness.
采用显微图像测量薄膜包衣厚度。
The preparation parameters were investigated by evaluation of the film coating thickness and uniformity.
以薄膜包衣厚度和均匀性为指标，考察包衣工艺参数。
Tools with internal contours (drilled holes; slots; etc.) can be coated. Depending on the geometry, the coating thickness will diminish as their depth increases.
模具的内部轮廓(孔，槽等)也可以涂层。涂层的厚度会随着深度增加而减小。
The preparations before test shall include corrosion check, mechanical inspection, vehicle photo, coating thickness measurement, metal thickness identification, paint layer scratch and etc.
试验前的准备工作包括腐蚀检查、机械检查、车辆拍照、涂层厚度测量、金属厚度识别及油漆层划线等。
Decorative requirements of the higher parts can choose ultra-thin fire retardant coating. 4 fire coating thickness should directly adopt the fire test data of actual components.
装饰要求较高的部位可选用超薄型防火涂料。4防火涂料的厚度，宜直接采用实际构件的耐火试验数据。
Results show that thermal fatigue behavior is associated with circle temperature and coating thickness.
结果表明，复合涂层的热疲劳行为与热循环上限温度、涂层厚度有关。
Cartons, cardboard resistance broken meter, temperature tracker, coating thickness gauge, hardness and a high degree of regulation, and other devices.
纸箱、纸板耐破度仪、炉温跟踪仪、涂层测厚仪、硬度计、高度规等测试仪器。
Note: We can manufacture the products upon special requirements of clients, and thickness, rigidity of copper matrix and tin coating thickness can also be adjusted upon the requirements of clients.
备注：其它规格可以按客户特殊要求加工定做，铜基厚度、铜基硬度和锡层厚度可以按用户要求调整。
At the same temperature, the dipping time is longer, the greater the coating thickness.
在同一温度下，浸镀时间越长，镀层越厚。
Plastic heavy wire mesh of the raw material is coated with a PVC plastic coated wire, plastic coating thickness of about 1mm or so.
包塑重型六角网的原料铁丝是涂敷了PV C塑料涂层的铁丝，塑料涂层厚度大约在1 mm左右。
Measuring range coating thickness measurement.
测量范围涂层厚度测量。
EIS of Q235 steel with epoxy coal tar coating was determined. It is shown that the infiltrative electrolyte amount into coating decreases with increasing coating thickness.
采用环氧煤沥青作为涂层材料，测定了涂敷不同厚度涂层的Q 235钢的交流阻抗谱。
The required finished coating thickness shall be specified by the purchaser. The specified thickness should not exceed the maximum recommended by the coating manufacturer.
业主需要确定涂层的厚度，但是厚度不应超过涂层生产商的建议厚度。
Increasing properly coating thickness is helpful to resist th...
适当增大涂层厚度有助于模样抗变形能力。
The deposition rate and coating thickness were determined, and the effects were compared with those of electroplating.
对镀速和镀层厚度进行了测定，并与电镀进行了效果比较。
The results show that thermal insulation coating and suitable coating thickness are helpful to improving the filling velocity of liquid aluminum.
结果表明，保温涂料及一定的涂层厚度有利于提高铝液的充型速度。
The resilience punching coating pachymeter has small size, light weight, and easy use, and can solve the problem of measuring the coating thickness at the construction field site.
本实用新型体积小、重量轻、使用方便、解决了在施工现场测试涂层厚度的问题。
Through the numerical analysis, it is posed that the structure surface stress gradient and the coating thickness are the principal factor that influence thickness effect.
通过数值分析提出，构件表面应力梯度和贴片厚度是影响厚度效应的主要因素。
Influencing factors to the uniformity of coating thickness for alkaline zinc plating have been studied systematically by Hall-cell test.
采用霍尔槽试验对碱性镀锌镀层厚度均一性的影响因素进行了研究。
We have introduced Japanese Minolta, computerized color spectrometer, coating thickness tester, nanometer, pencil hardometer, water spraying machines and the like professional inspection equipment.
为确保品质，公司还引进日本美能达，电脑色差分光仪，膜厚机，光泽度计，铝笔硬度计，水喷雾机等一批专业检测设备。
Measurement of coating thickness in the proof-test of IC packages and metal cases using X-Ray Fluorescence (XRF) spectrometry is described.
介绍了在外壳检验中，应用X射线荧光光谱法（XRF），对外壳的镀涂层厚度进行测试；
应用推荐