Extrusion die design for compound triple-layer plastic pipe by two extruding machines is introduced.
介绍用两台挤出机共挤复合三层塑料管材机头的模具设计。
Introduced design of the adjustable blanking-drawing compound for the drawing with flange, the drawing die could adjust the flange size, and satisfied the part tolerance requirement.
介绍了带凸缘拉伸件可调式落料拉伸复合模设计，实现对凸缘直径尺寸可以进行调整以实现一定公差要求的模具结构。
The design describes the structure of compound die stamping flip-chip design and working process.
本次设计阐述了冲压倒装复合模的结构设计以及工作过程。
The structure, main design parameters and work process of the compound die installed on single action press and working for blanking and drawing with constant blank holder pressure were presented.
介绍了用于单动压力机的新型恒压边力落料拉伸复合模的结构及主要设计参数和模具工作过程。
Then layout design and various process forces of calculation is introduced. Finally drawing and extrusion compound dies is adopted to make die structure better rationalization and effectiveness.
并进行了排样设计和各种工艺参数的计算，最终采用拉深、挤边复合模具，可使模具结构更为合理而有效。
A curling compound die for the hinge used for the plate-bending machine was introduced. The structure characteristics of the die and the attention problems in the design of the die were discussed.
介绍了一种适用于折板机的铰链卷圆成形复合模，讨论了该模具的结构特点和设计中应注意的问题。
The main points for the design of the compound die were introduced. The compound die has prominent advantages on the production of series products and on speeding up the production cycles.
通过介绍复合模的设计及要点，阐明了复合模对于系列化产品的生产，加快产品的投产周期，具有显著的效果。
The structural design, design parameters, material chosen and manufacture process of multi-pinhole compound die of main printed circuit board for large screen color TV are introduced.
介绍大屏幕彩色电视机主印制板多小孔复合模的模具结构、设计参数、材料的选用和制造工艺等。
In the paper, the compound stamping die structure design and working process was introduced.
介绍了复合模具的结构设计及工作过程。
This paper put forward a new kind of compound die mechanism which is a combination of the link mechanism and hydraulic, and design of a new energy-saving plastic equipment.
因此本文提出了一种以连杆机构与液压相结合的执行机构，在此基础上设计出了一种新型的节能塑封设备。
This paper put forward a new kind of compound die mechanism which is a combination of the link mechanism and hydraulic, and design of a new energy-saving plastic equipment.
因此本文提出了一种以连杆机构与液压相结合的执行机构，在此基础上设计出了一种新型的节能塑封设备。
应用推荐