Taper roller bearings of the series 313 are particularly adequate due to their comparatively large contact Angle (approximate 30 deg), when high axial forces are to be considered.
圆锥滚子轴承系列313，特别是足够的，由于其相对较大的接触角(约30摄氏度)，高轴向力时要考虑的。
These bearings have a larger contact angle and no filling slots.
这些轴承有更大的接触角和无填充槽。
Larger contact Angle type has better axial load capability.
更大的接触角型具有较好的轴向负荷能力。
As a result, the contact Angle of CFs with respect to epoxy resin was found to be remarkably decreased.
结果表明，经过氧化和氨化方法处理后碳纤维与环氧树脂的接触角降低。
Design a variety of radial clearance and the contact Angle, to meet different application requirements of load and deflection.
设计有多种径向游隙和接触角，满足不同的应用负荷和偏斜要求。
The raceways of both the inner and outer rings of this bearing type are made with a set contact Angle.
双方的这种类型的轴承内圈和外圈的滚道是由一组与接触角。
The higher the surface energy of the solid substrate in relation to the surface tension of the liquid, the better its wettability, and the smaller the contact Angle.
较高的表面能量的固体基质有关的表面张力的液体，它的更好的润湿性，较小的接触角。
The sessile drop technique is used to measure the contact Angle between molten aluminum and graphite or copper coated graphite.
采用改进的座滴法分别测定了铝熔体与石墨、镀铜石墨的接触角。
FAG single row angular contact ball bearings of series 72b and 73b have a contact Angle of 40. They can therefore accomodate high axial loads.
FAG单列角接触球轴承72b和73 B系列有一个40度的接触角，因此它们能够提供较高的径向载荷。
The contact Angle is the Angle between the tangent line at the contact point and the horizontal line of the solid surface.
接触角是角之间的切线的联络点和水平线的固体表面。
The article has accounted what Sodium Carboxy Methylcelluos effect to washing action by Samples' experimental datas of surface tension and contact Angle.
本文利用各种样品的表面张力和接触角的实验数据，说明羧甲基纤维素钠对洗涤作用的影响。
Grinding coal sample result is better than the forming fine coal during contact Angle measurement.
指出在接触角测量过程中，研磨煤样要比成型粉煤测量效果好。
An alternate experimental approach which does not require the direct measurement of contact Angle appears to be promising.
有一种可选用的试验方法看来很有希望，它不要求直接测量接触角。
The property changes of foam rubber surface before and after the treatment were studied by XPS and contact Angle measurement.
通过X射线光电子能谱分析和接触角测定，研究了处理前后泡沫橡胶表面性质的变化。
The dynamics contact Angle of some polymer materials is studied.
详细研究了有关高分子材料的动态接触角。
Based on the measurement of the contact Angle of differently treated ITO, the surface energy and polarity were calculated using the harmonic mean method.
在测量ito接触角的基础上，应用调和平均法计算了不同表面处理ITO阳极的表面能和极性度。
Due to their contact Angle, single-row angular contact ball bearings are better suited to sustaining high axial loads than deep-groove ball bearings.
由于其接触角，单列角接触球轴承比深沟球轴承更适合维持高轴向负荷。
The relationship between the morphology and the dynamic contact Angle of polypropylene fibers treated by plasma was found out through comparative analysis.
通过比较分析得出了等离子体处理后丙纶纤维的表面形态和表面接触角的关系。
The resultant surfaces were characterized by means of SEM, transmission electron microscopy (TEM), X-ray diffraction (XRD), and water contact Angle measurements.
用扫描电镜、透射电镜、X射线衍射、接触角测量等技术对表面进行了表征。
The contact Angle has the important effects on CHF.
接触角对临界热流密度有重要的影响。
The simulation results indicated that heat transfer coefficient increased with increasing surface free energy difference and decreasing contact Angle hysteresis.
模型计算结果表明液固表面自由能差越大、接触角滞后越小则越有利于冷凝传热。
The effects of preparing conditions on surface modification of graphite were introduced. The morphology observation, contact Angle determination and TG-DTA analysis were carried out.
介绍了包覆条件对石墨表面改性的影响，对改性后的石墨进行了形貌观察、接触角测定、差热-热重分析。
Through measures such as surface contact Angle method and infra-red spectrum, the effects of particle size, particle surface activity, particle shape, etc were studied.
通过对改性产品接触角测量和红外光谱分析，探讨了颗粒粒度、表面性质、晶体结构对填充橡胶性能的影响。
Many properties of material were tested, such as mechanical property, surface water contact Angle, water absorption rate, infrared spectrum and ESCA analysis.
测试了材料的力学性能、表面接触角、吸水率，同时对材料进行了表面电子能谱(esca)分析。
The properties of a class of curve shortening flows with contact Angle is studied.
对一类带接触角的曲线收缩流的性质进行了研究。
The effect of the esterification on contact angle is obviously bigger than that of graft copolymerization.
酯化处理所产生的接触角增大作用要比接枝共聚所产生的作用大；
Surface properties of PVC were characterized by the contact Angle, surface tension, X-ray photoelectron spectroscopy (XPS) and electron spin resonance (ESR).
等离子体改性前后pvc的表面特性通过接触角、表面张力、X -光电子能谱(XPS)、电子自旋共振(esr)表征。
Two common measuring methods of fiber contact Angle were introduced in this paper.
介绍了两种常用的纤维接触角测定方法。
The polymer structure was investigated by using FTIR, X-ray diffraction, electron diffraction and contact Angle measurements.
通过热失重，红外光谱、X -射线衍射、电子衍射和接触角测定等，研究聚合物结构与性能。
The polymer structure was investigated by using FTIR, X-ray diffraction, electron diffraction and contact Angle measurements.
通过热失重，红外光谱、X -射线衍射、电子衍射和接触角测定等，研究聚合物结构与性能。
应用推荐