Clearly, their model misses some important correction factor.
显然，他们的模型漏掉一些重要的修正系数。
An empirical formula of curvature correction factor was presented.
提出了一个曲率修正系数的经验计算式。
The results showed that the correction factor is of high reliability.
验证结果表明，修正系数具有较高的可靠性。
For shorter lengths, a correction factor must be applied to the result.
对于长度较短，校正因子必须实施的结果。
The monograph does not specify a correction factor for a specified impurity.
各论并未指定特定杂质的校正因子。
Correction factor tables begin on page 767. Review pressure temperature limits.
校正系数表始于第767页。查看压力和温度范围。
Correction factor is a significant factor to affect correct use of instruments.
校正系数是影响仪器正确使用的重要因素。
Clearly, a temperature correction factor is required and this is shown in equation.
显然，温度校正因子是必要的，这是显示在方程。
The method can calculate the correction factor in real time and keep high correction quality.
该方法能够实时计算校正系数，并能够保证校正质量。
The paper introduces a calculation method of the correction factor in engine performance test.
介绍一种发动机性能测试时校正系数的计算方法。
It has been proved that there exists the same correction factor for any polygonal optical gyro.
证明了任意正多边形光陀螺都具有同一形式的修正因子。
An end group correction factor was introduced for getting the true weight distribution of chain length.
引进了一个端基改正因子以获得真实的重量链长分布。
The influence of sample size, carrier gas, correction factor on quantitative results has been approached.
文中探讨了进样量对保留时间，载气性质和定量校正因子对定量结果的影响问题。
The dibutyl o phthalate was used as internal standard and the relative mass correction factor of DCPCP was determined.
以邻苯二甲酸二丁酯为内标物，测定了DCPCP对内标物的相对质量校正因子。
The USP method shows less recovery for some of the solvents. Will USP propose recovery correction factor for calculations?
USP方法对有些溶剂回收率较低。USP是否建议在计算中加入回收校正因子？
The correction factor is nearly equal to the true value (numerical solution), the average relative error of 66 data is 0.04%.
校正因子与真实解(数值解)十分接近，66个数据的平均相对误差为0.04%。
Q1: the USP method shows less recovery for some of the solvents. Will USP propose recovery correction factor for calculations?
提问：usp方法在测定某些有机溶剂时回收率较低。USP是否将提出计算用回收率校正因子？
ABSTRACT: OBJECTIVE: to explore the regularity of relative correction factor (RCF) in multi-components by single marker (QAMS).
摘要：目的：探寻相对校正因子(RCF)在中药材一测多评中应用的规律性。
The change of heat transfer coefficient and the vapor lock make the tube bundle arrangement correction factor change with load.
凝汽器蒸汽流场的变化使其传热系数和汽阻发生变化，传热系数和汽阻的改变使凝汽器管束布置修正系数随着负荷变化。
However, During the design of heating engineering, determining the orientation correction factor to the heating load is very important.
然而在进行采暖工程设计时，确定采暖热负荷的朝向修正率是非常重要的。
With the concept of concentration correction factor, the effect of the disc to improve the near field dilution of buoyant jet is confirmed.
提出轴线浓度校正系数的概念，从而清晰直观地证实了阻力盘具有提高射流近区稀释度的作用；
A new type calibration method, the correction factor method, is proposed, which can expand the scope of instrument used as the reference standard.
随后引入了一种新的定标方法校正因子法，可扩大用作参考的标准仪器的范围。
The star point of the dynamic star simulator's showing grid is measured, and the position error correction factor of each star point is calculated.
利用经纬仪对动态星模拟器显示的网格上的星点进行测量，计算了各星点的位置误差及修正系数。
Thesystematic error could be corrected by means of two correction factors, i. e. fractionation correction factor and nonlinearity correction factor.
而系统误差可以借助两个修正因子，即分馏效应修正因子和非线性修正因子加以修正。
In correction factor fuzzy control method an online interpolation algorithm is introduced. And it has been used in level control system of water tank.
在修正因子模糊控制方法中引入了在线插值算法，并将其应用于水箱液位控制系统中。
Finally, shear correction factor for each element was estimated, and the deflection corrector was calculated by incorporating shear correction factor.
最后在单元上计算和引入剪切修正系数，再经过有限元分析计算出层合圆柱壳的挠度修正值。
Finally, the shear correction factor for each element was estimated and the global response corrector was calculated by the incorporating shear correction factor.
最后在单元上计算和引入剪切修正系数，再经过有限元分析计算出全局响应的修正值。
By adopting dynamic correction factor, adjusting coal flow factor and changing the kind of coal, the accuracy of measurement with SWR engineering DensFlow was improved.
介绍了梅山高炉喷吹煤粉的计量控制原理，采用动态修正因子技术，通过调节煤流因子和改变喷吹煤种，解决了喷吹计量中煤流计计量不准的问题。
After getting the formula about the normal backlash and the stiffness of the tooth pairs of the gear, the contact ratio and the load correction factor could be obtained.
在获得齿轮内啮合传动的齿侧间隙计算公式以后，结合齿对刚度的计算公式，推导出齿轮内啮合传动的加载重合度及载荷修正系数。
After getting the formula about the normal backlash and the stiffness of the tooth pairs of the gear, the contact ratio and the load correction factor could be obtained.
在获得齿轮内啮合传动的齿侧间隙计算公式以后，结合齿对刚度的计算公式，推导出齿轮内啮合传动的加载重合度及载荷修正系数。
应用推荐