The influence of melting temperature, melting time, crystallization temperature and cooling mode on form and size of nylon 66 was studied.
研究了熔融温度、熔融时间、冷却方式及结晶温度对尼龙66球晶形态和大小的影响。
With increasing melting temperature, the cold crystallization peak temperature increases, the crystallization peak strength of PEEK weakens and the peak width increases.
熔融温度升高时，聚醚醚酮的结晶峰强度减弱，峰宽增加；而冷结晶峰温度提高。
On the other hand, both the glass temperature and cold crystallization peak temperature of PEEK increases and melting peak strength decreases while the melting time becomes longer.
熔融时间延长时，聚醚醚酮的玻璃化转变温度和冷结晶峰温度均提高，熔融峰强度减弱。
The diagram above illustrates an important point for both the melting of mantle rocks and the crystallization of high temperature silicate liquids (magma or lava).
图表上方举例说明地涵岩石和高的温度矽酸盐液体（岩浆或熔岩）的结晶的两者熔化者的重要的点。
The DSC results showed both the melting temperature and crystallization temperature of the grafting products were decreased.
DSC研究表明辐照接枝产物的熔融温度和结晶温度均降低。
The blending composition, temperature and time have a dramatic effect on the cold crystallization temperature (Tc) increases and the melting Tmperature (t m).
冷结晶温度和熔融温度与共混比例、共混时间、温度等因素密切有关。
Jacket can access certain temperature steam or liquid, high melting point to prevent the crystallization of liquid generated.
夹套中可通入蒸汽或一定温度的液体，防止高融点液体产生结晶。
The results showed that optimized flux has higher crystallization temperature, lower viscosity and melting point.
结果表明：优化的保护渣具有较高结晶温度、较低的粘度和熔点；
Te-free memory material with adjustable crystallization temperature, melting point and crystallization activation energy can be obtained by changing the ratio of the two compositions.
通过调整这种材料中两种元素的组份，可以得到具有不同结晶温度、熔点和结晶激活能的存储材料。
The former is characterized by lower viscosity , lower crystallization temperature, lower softening and melting temperature, proper basicity and higher melting rate.
薄板坯连铸保护渣应具有较低的粘度，较低的结晶、软化及熔融温度，合适的碱度以及较快的熔化速度。
The former is characterized by lower viscosity , lower crystallization temperature, lower softening and melting temperature, proper basicity and higher melting rate.
薄板坯连铸保护渣应具有较低的粘度，较低的结晶、软化及熔融温度，合适的碱度以及较快的熔化速度。
应用推荐