The conditions which have an important influence on metal cutting are work material, cutting tool material, cutting tool geometry, cutting speed, feed rate, depth of cut and cutting fluid used.
对金属切削有重要影响的条件有工件材料、刀具材料、刀具几何形状、切削速度、进给率、切削深度和所用的切削液。
High productive machining i. e. machining with faster production cycle is a comprehensive technology, in which increasing cutting speed and feed rate are merely two components.
高速加工即以较快生产节拍进行加工，提高切削和进刀速度是其系统技术中的一个环节。
The influence of different cutting speed and feed rate on the roughness of vane's finished surface was investigated and analyzed.
研究分析了不同的切削速度及进给量对叶轮叶片加工的表面粗糙度的影响。
The influence of cutting speed and feed rate on the surface roughness of machined blade was investigated.
研究了切削速度和进给量对加工表面粗糙度的影响。
Using Taguchi method to optimize the operation about the depth of cut, the spindle speed and the feed rate. Then the optimal cutting parameters can be drawn after analysis.
应用田口法分析主轴转速、背吃刀量和每齿进给量三个可控因素对表面粗糙度的影响，经过分析可以得出最优的参数组合。
Especially for cutting the material in high speed and feed rate.
尤其是切割速度和进料速度比较高。
High speed cutting and finish milling with high feed rate.
高速切削且能以高迸给率精铣。
Thread cutting. When performing thread cutting, the axial feed must be kept at a constant rate, which is dependent upon the rotational speed (RPM) of the workpiece.
在螺纹切削作业时，轴向进给必须保持恒定速率，这取决于工件的转速(rpm)。
The results of computer simulation demonstrates that it is more efficient to suppress chatter by time-varying feed rate cutting than by increasing feed rate cutting only.
计算机模拟结果表明，时变进给切削比单调增大进给切削更能有效地抑制颤振。在一定的条件下，时变进给量变化幅度及变化频率越大，抑振效果越好。
Three layers network topology is adopted. The input variables are water pressure, diameter of orifice, diameter of abrasive particles, flow rate of abrasive and feed rate of cutting head respectively.
模型采用三层结构，输入变量有水射流压力、水喷嘴直径、磨料粒子粒度(直径)、磨料流量和切割头进给速度。
According as formula of cutting surface mark deepness from educing, the paper explain that is really one another contradiction between tooth feed rate and cutting surface roughness.
文章首先以导出的锯痕深度公式为依据，说明每齿进给量与锯切表面光洁度两者之间确实是相互矛盾的。
According as formula of cutting surface mark deepness from educing, the paper explain that is really one another contradiction between tooth feed rate and cutting surface roughness.
文章首先以导出的锯痕深度公式为依据，说明每齿进给量与锯切表面光洁度两者之间确实是相互矛盾的。
应用推荐