The problem of solving large deflection plate by the variational method is changed into that of solving systems of cubic algebraic equations with multi-unknown quantities.
采用变分法求解薄板大挠度问题的高级近似解时将导致多元三次代数方程组。
The maximum deflection is calculated in case of isotropic, uniformly loaded circular plate and equidistant bearing points.
对各向同性、均布载荷及简支点等间距分布的简化情况计算了圆板的最大挠度。
Because elastic modulus of CFRP plate are weaker than elastic modulus of steel bar, while strengthening beam is destroyed, the deflection is still strong.
由于CFR P板的弹性模量比钢筋的弹性模量小，加固梁破坏时的挠度仍较大。
The damage factor is too high, the compressed air blowing pipe deflection, flower plate deformation and other factors, can be adjusted to prevent breakage.
破损因素是压缩空气过高、喷吹管歪斜、花板变形等因素构成，调整后即可防止破损。
The deflection functions given satisfy the differential equation of thin plate, all the boundary conditions as well as the conditions at free corner points.
给出的挠度函数满足薄板的基本微分方程、全部边界条件以及角点条件。
The optimal design of minimax deflection of an annular plate is studied in this paper.
本文讨论环形板的最大挠度极小化的优化设计。
This paper gives the exact solution of large deflection of circular sandwich plate under the action of uniform lateral load by the method of power series.
本文应用幂级数方法求出了在均布载荷作用下夹层圆板大挠度问题的精确解。
On the basis of classical lamination theory and large deflection hypotheses of plate, the equilibrium and compatibility equations of simply supported composite laminated plates were obtained.
基于经典的层合板理论及板的大挠度基本假设，得到四边简支层合板的非线性运动方程及变形协调方程；
A method of calculating elastic curve for semiflexible plate wind tunnel nozzle has been presented, based on the linear theory of small deflection of beam deformation, in this paper.
本文基于梁弯曲变形的小挠度线性理论，提出了半挠性喷管挠性板弹性曲线的计算方法。
In this paper, the study of disc spring is simplified and regarded as the symmetrical bending of circular plate with initial bending deflection.
本文将碟形弹簧简化为具有初挠度的圆环形薄板的对称弯曲问题。
Superior to the electrostatic deflection of the old plate, folded one is used in aberration.
结果表明，折板结构静电偏完成的图像像差明显优于原直板结构静电偏。
Based on the SDS-3 E-beam lithography machine, the electrostatic deflection of the folded plate structure was used instead of the electrostatic deflection of the plate.
以SDS - 3电子束曝光机为基础，用折板结构静电偏转替代直板结构静电偏转，探讨了电子束曝光机折板静电偏转场的电子轨迹与电位分布应满足的要求。
A position detection system is incorporated into a parallel plate interferometer in order to realize large deflection Angle measurement.
为了实现较大的偏转角度测量，该平行平板干涉仪引入了一位置探测系统。
Deflection, the total tendency is under the similar load, along with the web plate high increase, the built-up beam rigidity is increasing, amount of deflection unceasing reducing.
对于挠度来说，总的趋势是在同样的荷载下，随着腹板高度的增加，组合梁的刚度在增加，挠度不断的降低。
The strain distribution based on small and large deflection theories of diamond square diaphragm was studied using theories of plate bend.
采用薄板弯曲理论研究了均匀载荷作用下多晶金刚石方膜在小挠度和大挠度下的应变分布情况。
A general solution to differential equation for deflection function in bending problem of orthotropic rectangular thin plate on elastic foundation is established.
建立了弹性地基上的正交异性矩形薄板弯曲挠度函数微分方程的一般解。
A method to calculate the deflection of cast-in-situ plate stairs and the comprehensive corrected coefficient based on this method.
提出计算现浇板式楼梯的挠度的方法以及基于该方法的综合修正系数，可供工程设计、教学和科研参考。
A general solution of differential equation for deflection function in bending problem of orthotropic rectangular thin plate on elastic foundation is established in this paper.
建立了弹性地基上的正交异性矩形薄板弯曲问题挠度函数微分方程的一般解。
So the correlations of PFWD and bearing plate, CBR, deflection, FWD are established according to many testing results. The analyses indicate that the correlations are good in double logarithm.
为此，根据大量的试验检测结果建立了PFWD与承载板、CBR、弯沉和FWD检测值之间的相关关系，结果表明各检测值之间存在良好的双对数关系。
The general equations of principal curvature derived from differential geometry overcame the limitations of previous equations derived from the theory of elastic thin plate with small deflection.
由微分几何学原理得到计算主曲率的一般公式，克服了由薄板小扰度弯曲理论得到的主曲率计算公式的局限性。
The deflection trial function is formed by the 24 kinds of particular solutions of the elastic plate _bending control differential equation.
选取薄板弯曲控制微分方程的24类特解序列组合构造挠度试函数。
Solving the thin plates on Winkler's foundation by the nonsingular boundary element method and the layerwise summation method, the deflection of the given point of the plate can be obtained.
本文以无奇点边界元法分析地基厚板，而用分层总和法计算地基沉降，并将两者联系起来，即利用边界元法解出的厚板下的地基反力作为分层总和法的外力，从而求出地基的沉降。
But if initial deflection is small and in the designed range of the pavement structures, it'd better not grout or the plate stability will be impacted by disturbance caused by grouting.
但如果初始弯沉很小并在原路面结构层的设计范围内，最好不要压浆，因为压浆所造成的扰动可能会对板块的稳定性产生影响。
The computation results show the cantilever plates which fiber is perpendicular to the clamped boundary has the minimum deflection. The effect of anisotropy on the deflections of the plate isd...
分别选取强各向异性材料、弱各向异性材料进行计算分析，结果表明纤维方向垂直于悬臂板固定边的层合悬臂板刚度挠度最小。
Taking a heliostat as example, the paper applies thin plate flexure theory and study regularity of load-deflection curve for reflector plate.
建立了直角坐标系有限变形非线性弹性力学的倒易定理并给出了大挠度弯曲薄板的倒易定理。
The deflection of double-pitch hipped-plate grid structure increased significantly after earthquake, and the part of anchor bolts of rubber bearing were cut off.
某双坡折板式网架结构在地震作用下出现结构挠度大幅度增加、部分橡胶支座锚栓被剪断的破坏特征。
The deflection of double-pitch hipped-plate grid structure increased significantly after earthquake, and the part of anchor bolts of rubber bearing were cut off.
某双坡折板式网架结构在地震作用下出现结构挠度大幅度增加、部分橡胶支座锚栓被剪断的破坏特征。
应用推荐