This thesis gives the full IC design flow.
本论文基本体现了集成电路设计的完整流程。
The design flow of a mixed-signal circuit is complicated.
数模混合电路的设计流程是比较复杂的。
Figure 6 depicts the application design flow for this scenario.
图6描述了该场景的应用程序设计流程。
Figure 4 depicts the application design flow for this scenario.
图4描绘了用于该场景的应用程序设计流。
The second chapter explains the structure of FPGA and design flow.
第二章介绍了FPGA的结构和设计流程。
The system design framework and software design flow chart are described in detail.
从硬件和软件两方面详细阐述了系统的设计框架和软件设计流程。
The hardware composition and software design flow diagram of the system are introduced.
介绍了该系统的硬件组成及其软件设计。
A new design flow is summarized and a key algorithm is designed for the new architecture.
针对新的结构，概括了设计流程，设计了核心算法。
The design flow of integration design was put forward through functional analysis of products.
从产品结构功能分析的角度，提出了融合设计的设计流程。
This paper first discusses the design methodology of analog IC, namely, analog IC design flow.
本文首先讨论了模拟集成电路的设计方法学，即模拟集成电路的设计流程。
Moreover, it presents the architectural design of a corresponding design flow management system.
文中还给出了相应的设计流管理系统的总体设计。
In chapter four, we discuss the criterion and design flow of a whole ASIC design and SOC design methodology.
第四章给出asic设计的规范和流程，以及最近流行的SOC设计方法学。
Computer aided analysis and design flow chart and program for current source inverter circuit are presented.
提出了该逆变器的通用计算机辅助分析与设计框图和源程序。
The valve can positively isolate the flow and be set at an intermediate position to maintain the design flow rate.
这种阀门可以绝对隔断流量，或设置在某个中间位置以保持所需的流量。
It puts forward the design flow and design issue of embedded systems based on system-on-a-programmable chip (SOPC).
提出基于可编程片上系统(SOPC)的嵌入式系统设计流程及其所涉及的主要设计问题。
Additionally, current low power techniques are introduced and classified by the view of design flow and design level.
然后对功耗降低技术的现状，从设计层次和设计流程的角度进行了简要地介绍和归类。
The paper briefly describes integrates circuit top-down design in three aspects of design tools, design methods and design flow.
从设计工具、设计方法和设计流程三个方面对集成电路正向设计进行了简要的叙述。
We pictured the hardware structure of gradient waveform generator. The introduction of FPGA and FPGA design flow is also described.
文中描述了梯度波形发生器的硬件结构，简介了卡上fpga内部结构及FPGA内部逻辑设计流程。
Then, the software design flow of receiving and dispatching module and the structure design of the buffer descriptor were emphasized.
着重分析了协议栈数据收发模块的软件设计流程及缓冲区的结构设计。
With the new method, the flow variation curve of each inlet can be easily obtained, giving a basis for the design flow of storm pipelines.
利用新方法可模拟求得各集水口入流水流变化曲线，为准确确定雨水管道的设计流量奠定了基础。
Since integrated circuit designs are becoming more and more complex, functional validation has been the main bottleneck of the design flow.
随着集成电路设计的规模变得越来越大、功能越来越复杂，功能验证已经成为设计流程的主要瓶颈。
In this paper, modular design approach was introduced to nursing-bed design, and completed its design flow, elaborated its design significance.
本文把模块化设计方法引入到护理床设计领域，并完成了其设计流程，阐述了其设计意义。
It introduces speech recognition system based on interval data of passing zero, refers some crucial technology and the design flow of the system.
介绍了基于过零间隔点技术的声纹识别系统和其中一些关键技术和系统的设计流程。
This article describes the design flow and technics parameter of this combined technics detailedly with the Hangzhouwan Waterworks as an example.
本文结合杭州湾新区水厂详细说明该组合工艺的设计流程和工艺参数。
Under the DLX instruction set, the design flow of a microprocessor includes functionality organizing, logic designing and realization technology.
在完成了指令集的设计之后，微处理器设计的过程主要包括功能组织、逻辑设计、实现技术等要素。
This article narrated the FPGA unique feature and the design flow, discussed the main point of using the FPGA design radar signal tracking device.
叙述了FPGA的结构特点和设计流程，讨论了利用FPGA设计雷达信号跟踪器的要点。
The deep submicron technology presents lots of new challenges to the physical design of VLSI and new techniques are needed in the back-end design flow.
深亚微米下芯片的物理设计面临很多挑战，特别是对于超大规模电路，在后端设计流程上要有新的方法。
In this paper, an ASIC based on PCI Local Bus SpecificationV2.2 is designed, and its function, timing characteristic and design flow are also presented.
研究并设计了符合PCI规范V2.2的接口芯片，着重阐述了它的功能特点、时序特征及其大致设计流程。
Based on object oriented idea, ordered management of static product structure and dynamic design flow for series plastic box packing machine is achieved.
应用面向对象的技术思想，实现对系列化塑盒体包装机的静态产品结构与动态设计流程的有序管理。
Based on object oriented idea, ordered management of static product structure and dynamic design flow for series plastic box packing machine is achieved.
应用面向对象的技术思想，实现对系列化塑盒体包装机的静态产品结构与动态设计流程的有序管理。
应用推荐