The Dielectric Withstand test is the third test required by the electrical safety testing standards.
电气强度试验是电气安全性能测试标准所要求的第三项测试。
The Dielectric Withstand test consists in measuring the current leak of a device under test, while phase and neutral are short circuited together.
电气强度试验包括在测试过程火线和地线同时短路的情况下测量被测设备的漏电量。
The dielectric strength test can be made to be destructive or non-destructive.
电气强度测试可分为破坏性和非破坏性。
The machine contain main functions of above four testing apparatus, it can automatic test leaking current, grounding electric resistance, dielectric intensity, resting voltage and print testing data.
具备四种测试仪的全部主要技术性能，可连续自动测试漏电流、接地阻抗、电介质强度、剩余电压。可打印测试数据。
Dielectric loss measuring is the normal test items in electric power system.
介质损耗测量是电力系统中的常规试验项目。
Dielectric loss measuring is the normal item to test the high voltage equipment in electric power system.
介质损耗测量是电力系统中检测高压电气设备的常规项目。
The Dielectric Strength Test is to be performed between each pair of conductors (including ground if applicable) and between each conductor and the foil wrapped cord guard.
电介质强度试验是在每对导体（包括地）之间和每个导体与包装了金属薄片的尾档之间测量。
Test results of the dielectric properties of A1N films are given.
本文给出了A 1 N膜介电特性的测试结果。
The circuitry may be rearranged for the purpose of the test to reduce the likelihood of solid state component damage while retaining the representative dielectric stress on the circuit.
有获得的电介质应力集中在电路时，为了测试，可以将电路重新安排，以减少固态组件受损的可能性。
The cord set completed required cycles of flexing with no occurrence of end results and also successfully completed the Dielectric Strength Test without breakdown.
插头完成了要求的弯曲周期，没有出现上文所提到的最后结果，并且通过了电绝缘强度测试，没有损坏。
Test result of dielectric strength, partial discharge and endurance property are analyzed and contrasted between solid dielectric is two film and tree film in model capacitor elements.
本文比对分析了极间介质为两层膜和三层膜的模型电容器元件的介电强度、局部放电性能以及耐久性能的试验结果。
Standard Test Method for dielectric breakdown voltage and dielectric strength of D149 ASTM solid electrical insulating materials at industrial power frequencies.
ASTM D149固体电绝缘材料在工业电源频率下的介电击穿电压和介电强度的试验方法。
Test method for ASTM D149 solid electrical insulating materials at commercial power frequencies the dielectric breakdown voltage and dielectric strength.
ASTM D149固体电绝缘材料在工业电源频率下的介电击穿电压和介电强度的试验方法。
This paper briefly introduces the requirements about the insulation system of electronic product, and describes the importance of functional check and Dielectric strength in safety test.
本文简述电子电气产品对绝缘系统的要求，以及在产品的安全测试中抗电强度试验和对测试仪器作运行检查的重要性。
The design of dielectric loss test system based on SOPC is carried out in the paper, according to the analysis of existing systems and the development and application of SOPC.
本文首先介绍了介质损耗测试的原理并对现有的介质损耗测量技术进行了分析对比，以谐波分析法作为基于SOPC技术的设计方案的理论基础。
In the dissertation, on the basis of analyzing the electric and dielectric conductivity, the bathtub effect of the alternating conductivity of the fiber was verified by the test.
本文在分析了纺织纤维导电特性和介电特性的基础上，试验验证了纤维交流导电浴盆效应。
This paper introduces a new type of test circuit for measuring the ar (?) gap dielectric recovery strength of low voltage electrical apparatus.
本文介绍一种测量低压电器弧隙介质恢复强度的试验线路。
By analyzing the case of the dielectric strength test on household top-heating automatic soymilk machine, this paper briefly discuss two questions which should be pay attention to during safety test.
从结构设计和元器件选用两方面分析了上加热式家用全自动豆浆机在抗电强度试验时遇到的问题，并就安规测试中需要注意的问题进行了论述。
To achieve rapid moisture detection of culture media, dielectric type EC-5 soil moisture sensor was used to make adaptive test with substrate in different proportions.
为实现栽培基质水分快速检测，在不同配比的基质中采用电介质型EC - 5土壤水分传感器进行了适应性测试。
TGA and High voltage Bridge are used to test the dielectric loss factor and the breakdown voltage of the solvent-free insulating varnish.
用TGA、高压电桥等测试了无溶剂绝缘漆的介电损耗因子、介电强度等绝缘性能。
In chapter 5, the essence of the commutation's dielectric strength detecting is one of screening test of reliability.
第五章基于可靠性相关理论，揭示了换向器片间介电强度检测的实质，即其本身是一项可靠性筛选试验。
The dielectric voltage-withstand test apparatus shall be in accordance with Clause 16.20.
绝缘体的耐压性能测试设备要能达到第16.20条中所列标准。
In this paper, we introduced the technologies used in preparation and test of low-dielectric-constant materials.
本文介绍了有关低介电常数材料薄膜的制备方法和基本特性的检测技术。
A test technique of the microwave properties of the dielectric rod of the travelling wave tube is discussed.
本文讨论了行波管夹持杆微波性能的测试技术。
This paper introduced the reason for performing dielectric voltage withstand test, test requirements of CSA and UL standards, dielectric voltage withstand tester, and test method.
本文介绍了耐压测试的由来，CSA、UL的标准要求，耐压测试的测试设备以及测试方法。
The ozone generation characteristics of MVQ/BT Ozonizer are also discussed, and the test results show that the ozone concentration and output are linearly increased by increasing dielectric constant.
用此种复合材料作为臭氧发生器介质的实验结果表明，臭氧浓度随介质的介电常数的大小改变而近似呈线性变化。
In the continuum dielectric theory one considers the interactions between the test particle and its polarization cloud.
在连续统一体里非导电性的理论一考虑在试验粒子和它的极化作用云之间的相互作用。
In the continuum dielectric theory one considers the interactions between the test particle and its polarization cloud.
在连续统一体里非导电性的理论一考虑在试验粒子和它的极化作用云之间的相互作用。
应用推荐