This means cutting out shapes, taping things in place and allowing glue to dry if need be.
这意味着切割出各种形状，把东西贴在特定的地方，需要的话，可以使用胶水。
The glue is so strong, once it is dry I can hold a tray by the handle of the teacup and nothing will fall apart, it's amazing.
胶水非常强劲，胶水干后，我可以抓着茶杯把将整个盘拿起来，没有东西会脱落，简直不可思议。
If you prefer to use the white glue instead of the hot glue gun - you should let it set overnight to dry.
如果你是用胶水而不是热粘剂，就要等一整夜以便让胶完全晾干。
Let dry and repeat 4 or 5 times, until you have a coat of clear glue that holds the edges together.
干透后重复涂胶水的步骤4 ~5次，直到边缘上的一层胶水可以固定住所有纸张为止。
Don't trust that lining up your layers by the exterior border will be correct-always check your alignment before you allow your glue to dry!
不要认为把图层按照外边沿为基准排列就一定是正确的——在胶水干之前，你需要不断的检查是否对齐。
For both materials (especially HD80), rough up the glue surface first with coarse sand paper, then apply a coat of cement and let it dry.
为两种材料(尤其是hd80)，粗糙了胶的表面首先与粗砂的文件，然后申请一件外套，水泥，让它干。
Get a sense for how long the glue you're using takes to dry and make sure you give it the full time to set.
对胶水变干的时间有一个大致感觉，并且确定你有足够的时间来等它固定。
Wait for the glue to dry before you sit on it.
等胶水干了你再坐上去。
Once the glue is dry, I vacuum the excess and then paint in earth colors.
一旦胶干，我真空多余的涂料，然后在地球的颜色。
If you need to quickly repair a flip flop, drop a tiny bit of water in some super glue. It'll help the glue dry more quickly.
如果你需要快速修补拖鞋，可以在强力胶里加一点点水，能使强力胶干得更快。
Once the glue was dry, I removed the clamp, the wooden form and the wax paper, and was pleased to find they fit very well!
一旦胶水未干，我删除了钳，木制形式和蜡纸，并高兴地发现，他们非常适合！
Stick these patterns to the cups with decorative glue. Let the glue dry.
用装饰胶水将这些图案粘到纸杯上。 静待胶水晾干。
By near infrared waves to glue molecules produced vibration absorption accelerated glue dry.
利用近红外线光波对胶水的分子产生振吸收加速胶水烘干。
With a glue stick, lightly coat one side of the paper template and apply it to the cleaned stainless surface, and allow it to dry.
用胶水棒一旁的皮大衣轻轻模板适用于清洗不锈钢表面让它干燥。
It is produced through dry glue preparation, sponge preparation and emulsion preparation.
是经过干胶工艺、海绵工艺和乳胶工艺制做而成。
万能速干胶？
The Cue Tip should be larger in diameter than the ferrule so that it can be properly shaped. Make sure the glue is completely dry before shaping.
粘合上的皮头应该是比先角大上一圈的，待会我们会对它进行切割成型。在切割皮头使其成型前要先确保胶水已经干透。
Smart splinter remover: Just pour a drop of Elmer's Glue-All over the splinter, let dry, and peel the dried glue off the skin.
屑剌脱除：倒入一滴胶水盖遍碎屑上，让胶水干后﹐从皮肤剥脱干 胶水。
Circuit board glue packer is a machine which can put the processed circuit board to special glue and then pour soak dry, it is a process after the circuit board is processed.
线路板封胶机是对加工好的线路板浸泡特殊胶水然后淋干烘干的机器，是线路板做好后的工序。
This paper discusses how to improve the performance of oxidized corn starch adhesive, including low green bond, bad consistent glue viscosity, bad water-resistance and slowly dry speed.
针对氧化淀粉胶粘剂初粘力低、干燥速度慢、稳定性差、抗水性差等缺点进行改性研究。
I am sorry, because the glue has not yet dry, so do not you take over, I will give you tomorrow.
对不起，因为那个胶水还没有干透，所以没给你拿过来，明天一定可以给你的。
After the glue nearly dry, take off the wing for the next installation.
待胶基本固化，取下机翼以便进行下一步的安装工作。
Abstract circuit board glue packer is a machine which can put the processed circuit board to special glue and then pour soak dry, it is a process after the circuit board is processed.
【摘要】线路板封胶机是对加工好的线路板浸泡特殊胶水然后淋干烘干的机器，是线路板做好后的工序。
The heart with its power of sympathy, acting as glue, can retain things much better than the head or intellect which is hard and dry.
具有善解人意的力量的心灵，像胶水一样，比起艰涩而枯燥的头脑或者智力来说，能更好地记忆事情。
If the wide cracks can first use of the companys high-strength anti-cracking treasure filled with water, dry and then glue to the construction.
如宽裂缝可先用本公司生产的高强抗裂防水宝填充，干燥后再进行涂胶施工。
You've got to pretty much take that chalk, and make a slurry out of it, put water, and dry it back up, put in a mold, and then you can have the chalk again, but you can't just glue it back together.
你得尽可能地收集它的碎片，把它做成粉浆，加水然后风干，放进模具，然后你就能重新得到这支粉笔，但是你不能简单地把它粘起来。
Once again white glue was brushed on, but only over the strings on canvas (picture 8.) After that, let it dry and than paint.
再涂一遍白胶，只是这次只要给伞布上的伞绳刷下就可以了(见图8)。然后，等干了之后再上色。
At present, the use of the two-sided glue more coated paper to make a partition, main purpose is to prevent a partition is affected by cold and hot dry wet contraction, which emit particles.
目前，多采用双面上胶的铜版纸作分隔板，主要目的是为了防止分隔板受冷热干湿的影响发生收缩，从而散发微粒。
At present, the use of the two-sided glue more coated paper to make a partition, main purpose is to prevent a partition is affected by cold and hot dry wet contraction, which emit particles.
目前，多采用双面上胶的铜版纸作分隔板，主要目的是为了防止分隔板受冷热干湿的影响发生收缩，从而散发微粒。
应用推荐