Tighten exhaust manifold to cylinder head bolts.
紧固排气岐管汽缸头螺栓。
Exhaust manifold, Vibration, Finite element method;
排气总管，振动，有限单元法；
The exhaust manifold is bolted to the cylinder head.
排气歧管采用螺栓联接固定在 气缸盖上。
The exhaust gas exits through the other exhaust manifold.
废气经另外一个排气歧管排出。
The exhaust gas exits through the other exhaust manifold .
废气经另外一个排气歧管排出。
Thee exhaust gas exits through the other exhaust manifold.
废气经另外一个排气歧管排出。
Clean the exhaust manifold and cylinder head mating surfaces.
清洁排气歧管和汽缸头配合面。
The calculation results of unsteady flow in an exhaust manifold model are presented.
最后对一根模型排气管进行了不稳定的流场计算。
High back pressure of exhaust manifold, rapid change in load, scavenge fire and so on.
高背压的排气系统，在负载快速变化，清除火灾等。
In many engines, the thermostat is located in a well in the intake or exhaust manifold.
在很多发动机内，恒温控制器装在进气岐管或排气岐管的空腔中。
During the process of low mass flow, local refluence may occur in the exhaust manifold.
在具有低质量流量的过程中，排气管内部可能会发生局部回流。
And the heart of this engine is a trick exhaust manifold and a pair of twin-scroll turbochargers.
和心脏的引擎是一种欺骗排气歧管和双双卷轴涡轮增压器。
Check for signs of leakage or cracked surfaces at both ends of tube, exhaust manifold and EGR valve.
检查两个管的末端，排气歧管和EGR阀是否有泄露或表面有裂痕。
In this paper a newly-developed 1 + 2 MIXPC turbocharging system and its exhaust manifold is introduced.
主要介绍了最新开发的1 +2MIXPC涡轮增压系统及其排气管系。
The exhaust gas flows from the exhaust manifold into an exhaust pipe and from there into the catalytic converter.
废气从排气歧管流入排气管，进入催化转换器。
Install cylinder head, intake manifold, and exhaust manifold, refer to cylinder head installation in this section.
安装汽缸盖，进气歧管和排气管，请参阅本部分的汽缸盖安装。
The other is about the calculation and experiment of the two-dimensional unsteady turbulent flow in an exhaust manifold.
二是对排气管的二维不稳定湍流流动进行了计算和实验研究。
An exhaust passage is connected to the exhaust manifold and a diesel particulate filter is disposed in the exhaust passage.
排放通道连接到排放歧管，并且柴油颗粒过滤器布置在排放通道中。
The thermal stress of internal combustion engine exhaust manifold was calculated with the fluid-structure coupled simulation.
采用流固耦合方法计算了内燃机排气歧管的热应力。
The results show that the crack in exhaust manifold is the place where the thermal stress is more great. The suggestions were …
计算结果表明，排气歧管裂纹产生处就是热应力最大处，根据计算结果提出了改进建议，经试验验证改进措施是有效的。
Turbochargers can be mounted to its own exhaust manifold but on inline engines, both turbos can be mounted on the same manifold.
涡轮增压器可以安装到自己的排气歧管但直列发动机上，都可以安装增压器在同一在静听着的松林之间。
Typical flow patterns in the exhaust manifold was presented, and its structure is optimized according to the results of calculation.
描述了排气管中的典型流动，并根据计算结果对排气管进行了优化。
In this paper, a FVM-TVD method for simulation of one-dimensional unsteady flow in inlet and exhaust manifold of ICE has been constructed.
介绍了进排气系统一维非定常流动的FVM-TVD法（总残差减少的有限体积法）。
It was studied that the reason of fatigue-broken of the exhaust manifold resulted from vibration in a diesel engine using FEA and FE-SAFE software.
运用有限元法和疲劳分析fe - SAFE软件对某型柴油机排烟管由于振动引起的疲劳断裂原因进行了研究。
The exhaust manifold, usually constructed of cast iron, is a pipe that conducts the exhaust gases from the combustion Chambers to the exhaust pipe.
材料通常为铸铁的排气歧管是将废气从燃烧室引入排气管的管道。
The space time conservation element and solution element method was applied to simulate the unsteady gas flow in intake and exhaust manifold of ICE.
本文运用时空守恒元与解元方法对进排气系统中的气体流动进行了模拟计算。
The 3-D transient internal fluid of the exhaust manifold has been simulated with the inlet and outlet boundary conditions calculated by the thermodynamics.
通过热力学计算得到排气歧管的入口和出口边界条件，计算排气歧管的三维瞬态内流场；
The 3-D transient internal fluid of the exhaust manifold has been simulated with the inlet and outlet boundary conditions calculated by the thermodynamics.
通过热力学计算得到排气歧管的入口和出口边界条件，计算排气歧管的三维瞬态内流场；
应用推荐