Optimum condition of film formation was established.
确定了成膜的最佳工艺。
The film formation of ambient drying water - dispersing coatings is described.
叙述了常温成膜水分散涂料的成膜。
This paper does research on the condition of zein film formation and its fresh preservation effect.
总结了国内外玉米醇溶蛋白膜制备与应用的研究现状，并对其应用进行了展望。
Chemical oxidation: through the chemical processing the metal surface oxidation film formation process.
化学氧化：通过化学处理使金属表面形成氧化膜的过程。
The coalescer can improve the ability of film formation of the paint and enhance the flexibility of film.
成膜助剂有利于改善涂膜的成膜性能，提高涂膜的柔韧性；
An electrochemical oxidation-surface transition model about the passivating film formation has been proposed.
据此提出成膜的电化学氧化-表面转化历程。
Steel blackening process under room temperature has been analyzed and possible mechanism of film formation discussed.
分析钢铁常温发黑过程，探讨其可能的成膜机理。
This apparatus can be provided with cooling means to allow enhancement of the throughput of the film formation process.
使用设有冷却手段的溅射装置，可以提高成膜工序的产量。
This paper reviewed the main theoretical models and the effective factors of diffusion process during the film formation.
介绍了成膜扩散的主要理论模型及影响因素。
Solubility and relative evaporation rates of coalescents will influence their evaporating process during the film formation.
成膜助剂的水溶性、相对挥发速度影响其在涂膜干燥过程中的挥发。
The effect of coalescent, film formation temperature, film formation time on latex coatings wet - abrasion property was discussed.
本文研究了成膜助剂、成膜温度和成膜时间对乳胶漆耐洗刷性能的影响。
Accelerating the film formation on the mineral surface and keeping its stability are very important for the microbe leaching rate.
加速微生物在矿物表面成膜及保持其稳定性是影响微生物浸矿速率的重要因素。
A room temperature film formation and low VOC acrylic finishing coatings has been prepared by core-shell structure emulsion polymerization.
用核-壳乳液聚合方法制备了室温成膜低voc丙烯酸类上光涂料。
Experimental investigation on rising film formation process of binary solution on the fluted helix surface of a horizontal tube was carried out.
对水平刻槽管壁面二元溶液升膜形成过程进行了分析。
The invention provides a composition for under-resist film formation which is for use in a lithographic process for producing a semiconductor device.
本发明的课题是提供在半导体装置制造的光刻工艺中使用的形成抗蚀剂下层膜的组合物。
It also summarizes MD simulation in the studies of solid bulk characters, surface problem, interface problem and the progress of thin film formation etc.
介绍用分子动力学模拟方法研究固体的体相结构，表面问题，界面问题以及薄膜形成过程等方面的研究成果。
The test of coat application shows that the film has stable quality, uniform film formation and high peeling strength, as well as lower processing temperature.
涂覆应用试验表明，该涂覆专用料产品质量稳定，成膜均匀，剥离强度高，且降低了加工温度。
The oxygen concentration of the inorganic resist layer can be varied along the thickness direction by changing the proportion or film formation output of reactive gas.
通过改变反应气体的比率或成膜输出，可以使无机光刻胶层的氧浓度在厚度方向不同。
In particular, the amorphous titanium oxide is obtained by using the reactive sputtering method and via deposition at a low temperature and at a high film formation rate.
特别是利用反应性溅射法，在低温下以高成膜速度进行堆积，得到非晶的氧化钛。
Based on the three stages the film formation model was proposed, meanwhile, the EIS equivalent circuit and the impedance expressions in different stages were also presented.
在成膜三阶段基础上提出了稀土转化膜的成膜模型；同时给出各阶段阻抗谱图等效电路及其阻抗表达式。
The cyclic voltammetry curve showed that the irreversible capacity loss might result mainly from the decomposition of solvent and the reaction of film formation at 0.9v or so.
由循环伏安曲线可见，不可逆容量损失主要由发生在0 9V左右的溶剂分解和成膜反应引起。
Pure iron membranes were pre-charged with hydrogen at various current densities. Effect of hydrogen on the film formation process on iron was studied by electrochemical methods.
采用电化学、光电化学和交流阻抗等方法研究了氢对纯铁钝化膜形成过程和电子性质的影响。
With thickening, adhesion, dispersion, emulsification, film formation, suspension, adsorption, gel, surface activity, water retention and protective colloid and other characteristics.
具有增稠，粘合，分散，乳化，成膜，悬浮，吸附，凝胶，表面活性，保持水分和保护胶体等特性。
The microstructure of the oxide film morphology phase composition and micro-hardness changed, and the oxide film formation mechanism was studied by om, XRD, SEM and HV analysis methods.
用OM、XRD、SEM、HV分析研究氧化膜的微观组织形貌、相组成及显微硬度的变化，并对氧化膜生成机理进行探讨。
The performance of the resin latex film was not only dependent on its formulation and the molecular chain structure of the polymer inside, but also the film formation process of the polymer.
树脂乳胶膜的性能不仅与涂料的配方和其中聚合物的分子链结构有关，而且与聚合物的成膜过程密切相关。
The types of silane coupling agents, the mechanism of film formation, model of polymer-metal interface, the preparation of silane films and the properties of films and coatings were summarized.
综述了有机硅烷偶联剂的种类、成膜机理、聚合物-金属界面模型、薄膜制备、薄膜及涂层制品的性能。
The types of silane coupling agents, the mechanism of film formation, model of polymer-metal interface, the preparation of silane films and the properties of films and coatings were summarized.
综述了有机硅烷偶联剂的种类、成膜机理、聚合物-金属界面模型、薄膜制备、薄膜及涂层制品的性能。
应用推荐