The axes are comprised of a generalized homologous temperature, the normalized kinetic energy flux, and the net film thickness.
坐标轴包括广义同系温度，标量化动能以及净膜厚度。
Low solids tend to produce a lower film thickness.
低固体份易于产生较低的膜厚；
It achieves corrosion resistance at low film thickness.
较低的膜厚具有良好的防腐蚀性。
As the film thickness increases, the grain sizes increase.
薄膜晶粒随膜厚增加而增大。
Care should be taken that uniform film thickness is obtained.
注意得到正确均匀的膜厚。
One millionth of a meter. Used to express applied film thickness.
一个百万分之一米。用于表述涂层的厚度。
Fluorescent film thickness tester deviation, or test method error.
荧光膜厚测试仪偏离，或测试方法错误。
With decreasing the film thickness, the maximum absorptance appears.
随着薄膜厚度减小，吸收率具有极大值。
The national standards for film thickness testing methods are introduced.
介绍了国家标准关于漆膜厚度的测试方法。
The EHD film thickness formula for roller bearing is important in application.
滚子轴承的弹流油膜厚度公式具有重要的应用价值。
The film thickness equation considering the journal misalignment is put forward.
提出了轴颈倾斜情况下的轴承油膜厚度方程。
At last, the methods of coating material and coating film thickness were expounded.
最后阐述了选择不同样品的镀膜材料与镀膜厚度的方法。
The film thickness is directly proportional to the resistance of the deposited coating.
涂膜的厚度直接与沉积涂层的电阻成正比关系。
Wet film thickness gauges may be used during coating to ensure correct coating thickness.
在涂敷时应采用湿膜测厚仪以确定准确的涂层厚度。
It has shown that the film thickness can be controlled by adjustment of voltage and time.
试验结果表明：通过调节电泳电压和电泳时间，可以控制膜厚。
It is indicated that the thin film thickness measurement by eddy is also a practical method.
指出了采用涡流测量薄膜厚度也是一种实用的测量方法。
A theoretical formula for computing the film thickness in line contact EHL problems is derived.
给出了一种线接触弹流问题中油膜厚度的理论计算公式。
Both the optical absorption coefficient and bandgap decrease with increasing in film thickness.
光吸收系数以及禁带宽度均随薄膜厚度的增加而下降。
In the nonmetal film production, there is an important significance to detect film thickness online.
在非金属薄膜生产中，对薄膜厚度的在线实时检测具有非常重要的意义。
Objective To investigate the relationship between marginal film thickness of resin luting cements and microleakage.
目的研究树脂类粘结剂边缘厚度与全瓷冠边缘微渗漏的相关关系。
Conservation of mass, momentum, and energy are used to solve for the liquid film thickness, velocity, and temperature.
通过求解质量守恒、动量守恒、能量守恒方程，获得液膜厚度、速度与温度等参数。
As the film thickness increases with temperature and time, cracks appear and further oxidation of aluminium alloys is possible.
作为膜厚度随温度和时间、裂缝的出现和进一步氧化铝合金是可能的。
Minimal film thickness and central film thickness of arc cylindrical worm drive were calculated under different rotation Angle.
计算了圆弧圆柱蜗杆传动在不同的蜗杆转角下的中心膜厚和最小膜厚。
The capacities of a given mass of a specific powder to coat in a cured state an area of substrate at a determined film thickness.
在一定的厚度下，一定量的粉末在基材上涂装的面积的能力。
Electroplating uneven thickness: refers to the actual plating out when the film thickness in high and low, or uneven distribution.
电镀厚度不均：指实际镀出膜厚时高时低，或分布不均。
The results indicated that the sealing parameters changed remarkably near the opening critical film thickness in the start up process.
研究表明，启动过程中，密封的特性参数在开启临界气膜厚度附近快速变化；
The film thickness distribution outside a horizontal test tube was measured with a film-thickness meter, to obtain the average thickness.
采用智能化薄膜厚度测试仪对水平管外液膜流动状态进行了研究，得到液膜厚度的几率分布和平均厚度。
Finally, the key design parameters of coating system was obtained, this system can meet ITRS requirements on uniformity of film thickness.
最后给出了镀膜系统的关键设计参数，此镀膜系统能够满足ITRS关于膜厚均匀性的要求。
The controlled speed determines film thickness and overall coating efficiency, and its surface finish determines the texture of the coating.
速度的控制决定薄膜的厚度和整体涂布的效率，并且表面的光滑决定涂层的手感。
The controlled speed determines film thickness and overall coating efficiency, and its surface finish determines the texture of the coating.
速度的控制决定薄膜的厚度和整体涂布的效率，并且表面的光滑决定涂层的手感。
应用推荐