The gasket faces of girth flanges shall be machined after final heat treatment.
在最终热处理后翼缘法兰的垫片的端面应进行加工。
The main factors affecting the process tolerance of inner splined sleeve are heat treatment, cutting process, and the arrangement of final machining process etc.
影响内花键套制造精度的主要因素是热处理工艺、加工工艺及制造工艺顺序等。
The optimizing experiments on the heat treatment process for the final transmission driven gear made of austempered ductile iron (ADI) were carried out using orthogonal test.
运用正交试验法对奥贝球铁生产拖拉机最终传动从动齿轮的热处理工艺进行了优化试验。
For production of final 800 alloy U-shaped steel tubes used for steam generator heat-conduction, surface shot-blast treatment is a must.
表面喷丸是生产800合金u型蒸汽发生器传热管成品必不可少的处理工序。
This article has described the research and upgrading of the final heat treatment process for the generator shaft end, the optimized process has been selected and put into the operation.
对发电机轴端头的最终热处理工艺进行了研究和改进，筛选出了最佳工艺条件并进行了实施。
The production flow, after forged heat treatment and final heat treatment process for the high strength tube blank have been described in this article.
介绍了高强度管坯的生产流程及锻后热处理、最终热处理工艺。
LC the final heat treatment is followed by cold drawing involving limited deformation. Appropriate further processing allows a certain degree of cold forming e. g. bending, expanding.
冷加工(软)最后热处理之后进行小变形量的冷加工，对钢管再加工时允许有限的冷变形(例如：弯曲，扩口)。
In the final heat treatment using circular quenching grain refinement effect is good, three times quenching refinement of grain can achieve 10 levels.
在最终热处理采用循环淬火晶粒细化效果好，三次淬火细化的晶粒可达到10级。
Gear final heat treatment using the parts deformation small tooth surface quenching;
齿轮的最终热处理采用使零件变形较小的齿面高频淬火；
Gear final heat treatment using the parts deformation small tooth surface quenching;
齿轮的最终热处理采用使零件变形较小的齿面高频淬火；
应用推荐