The analysis of the simulation value compared with the test results of pipe fittings bended Angle proved the validity of the Finite Element Modeling the tubes bended forming process.
通过对管件弯曲角度的试验结果与模拟值的对比分析,证明了建立管件有限元模型的正确性。
Entity model from modeling can be directly used in motion simulation analysis and finite element analysis, which shortens the design time and reduces the data exchange between softwares.
建模所得的实体模型直接用于运动仿真分析和有限元分析,缩短了设计所需的时间,减少了软件间的数据交换。
This paper proposes a general finite element (FE) based phase variable modeling method of permanent magnet (PM) linear motors for the accurate dynamic simulation of drive systems.
考虑电机非理想结构对推力的影响,建立了永磁直线电机的一般化相变量模型。
Based on the nonlinear, elastic-plastic finite element method theory, the modeling approach of the numerical simulation of incremental sheet metal forming was studied firstly in this project.
本课题基于非线性、弹塑性有限元理论方法,对金属板料渐进成形的数值模拟的建模方法进行研究。
Based on the nonlinear, elastic-plastic finite element method theory, the modeling approach of the numerical simulation of incremental sheet metal forming was studied firstly in this project.
本课题基于非线性、弹塑性有限元理论方法,对金属板料渐进成形的数值模拟的建模方法进行研究。
应用推荐