Configure and ensure the boot list is pointing to the standby BOS as the first boot device, as shown in Listing 17.
配置并保证启动列表将备用BOS作为第一启动设备，如清单17所示。
And you get an error I9990301 disk failure or disk reset failed then you have to switch boot sequence and make hd1 the first boot device.
可能会产生一个错误I9990301diskfailureordiskresetfailed，这时必须切换引导次序，让hd 1成为第一个引导设备。
Verify in the LSI configuration utility that the daughter card is enabled and included in the boot list, preferably as the first boot device.
通过LSI配置实用程序检查子卡是否已经启用并包含在引导列表中，子卡最好是第一个引导设备。
To boot using the IBM Installation Toolkit Live DVD, make sure your system has the CD/DVD-ROM drive or the Network Adaptor as its first boot device as follows
要使用IBMInstallationToolkitLiveDVD引导机器，请确保您的系统使用 CD/DVD-ROM驱动器或网络适配器作为其第一引导设备，方法如下
The server will need to be rebooted after the update process, so make sure the bootlist is showing the target alternate disk as the first boot device (as seen in Listing 7).
服务器需要在更新过程完成后重新启动，所以要保证启动列表显示目标备用磁盘作为启动设备（如清单 7 所示）。
This first sector will continue the boot process by loading the rest of the kernel from the boot device.
第一个扇区从引导设备上加载内核的其余部分继续引导过程。
When a boot device is found, the first-stage boot loader is loaded into RAM and executed.
当找到一个引导设备之后，第一阶段的引导加载程序就被装入RAM并执行。
The BIOS loads the first sector of the boot device and executes the code it contains.
BIOS加载启动设备的第一个扇区并运行其包含的代码。
E3 Flasher, the world first dual boot, simplest operation device, Surprising Arrival!
E3闪光器，世界上第一个双引导，最简单的操作装置，令人惊奇的到达！
The SD Card will only be available to the OS if it's inside the device during its first boot. Removing the SD Card will destroy all user data and a hard reset is required!
在设备首次启动时sd卡将被设定为只能由wp7系统使用，移除sd卡将摧毁所有用户数据，且在系统硬重置时sd卡必须在设备内。
The SD Card will only be available to the OS if it's inside the device during its first boot. Removing the SD Card will destroy all user data and a hard reset is required!
在设备首次启动时sd卡将被设定为只能由wp7系统使用，移除sd卡将摧毁所有用户数据，且在系统硬重置时sd卡必须在设备内。
应用推荐