In this paper, computation and experimental study of the seal capacity for magnetic fluid seal were carried, on the basis of the theory of the magnetic fluid seals.
本文在磁性流体密封理论的基础上计算了磁性流体密封的耐压能力，并进行了实验研究。
The irregular grid finite-volume method is proposed for computation of heat transfer and fluid flows in complex region.
提出用非规则网格有限体积法计算不规则边界区域的传热和流体流动问题。
Simulation computation indicates that enhancement by micro-convection has identical magnitude as that by apparent conductivity of fluid in the pipe wall.
模拟计算表明，由微对流导致的对流换热强化与流体在管壁面上的表观导热系数强化具有相同的数量。
On the basis of obtaining reservoir density sections and using fluid density computation technique, the fluid density sections can be yielded.
在获得的储层密度剖面基础上，利用流体密度计算技术，即可得到流体密度剖面。
This paper proposes a dynamic difference mesh for computation of multi-body movement in the infinite fluid filed.
提出无限大流场中多体运动计算的动态差分网格。
Porosity determined from shear moveout had the advantage of less influence on computation result by pore fluid, especially the advantage was obvious when gas was saturated in formation.
利用横波计算地层孔隙度具有计算结果受孔隙流体影响小的优点，特别是在地层含气的情况下，优势更加明显。
A simple and useful fully automatic grid rezoning method, for unstructured triangular grids in the 2d finite element computation of elastic plastic fluid mechanics, is presented.
对二维弹塑性流体力学有限元计算中的非结构三角网格，提出了一种简单、实用的全自动网格重分方法。
It has been widely used in three-dimensional medical reconstruction, computational dynamic fluid, post-processing of finite element computation, seismic and geological applications.
在医学三维重建、计算流体力学、有限元后处理、地震地质等众多领域得到了广泛应用。
In this computation a fluid-elastic plastic model and a finite difference method of Lagrange coordinate are used The parameters of shock, cavity and waveform are obtained and analysed.
在这个计算中，采用了流体——弹塑性变模量模型，使用了拉格朗日坐标有限差分方法和人造粘性，获得了冲击波、空腔和波形参数，并分析了这些参数。
Uniform incoming fluid flowing velocity is set for entry of computation region and pressure boundary condition is inducted for outlet.
在计算区域的进口处给定均匀来流速度，在出口引入压力边界条件。
The computation fluid dynamics(CFD) is used to predict the flow filed inside the selective catalytic reduction(SCR)system of a 600MW power plant.
采用计算流体动力学（CFD）模型预测某600MW电厂选择性催化还原法烟气脱硝系统不同设计情况下的流场状态。
Computation of eccentric annular flowing on Bingham-fluid in pipe is approximate in many literatures and is not of universality.
在调研了大量关于宾汉流体偏心环状管流的文献之后，发现大都是近似计算而不具有普适性。
Using numerical computation of fluid flow, the coefficients of vertical force, lateral force and rolling moment caused by cross-wind were calculated, which were related to train speed and wind speed.
采用流场数值模拟计算方法，计算了横风作用时的垂向气动升力系数、气动横向力系数和侧滚力矩系数，得出各系数与车辆速度和风速之间的变化关系。
A computation method of the partitions equivalent magnetic circuit is applied to the MR fluid damper.
将分段等效磁路法应用于磁流变阻尼器的磁路计算。
When a structure vibrates in water, large amount of computation will be unavoidable if the fluid finite element method is used to calculate the added water mass matrix and damping matrix.
当结构在静水中振动时，如采用流体有限元来计算流体的附加质量和附加阻尼，势必导致解题规模过大。
The equations describing the flow of a viscoplastic fluid on a rotating disk are derived and are solved by perturbation technique and numerical computation respectively for 2 cases.
本文对两种情况导出了描述粘塑性流体在旋转圆盘上流动的基本方程。
The equations describing the flow of a viscoplastic fluid on a rotating disk are derived and are solved by perturbation technique and numerical computation respectively for 2 cases.
本文对两种情况导出了描述粘塑性流体在旋转圆盘上流动的基本方程。
应用推荐