Please do not plug equipment heat release system.
请不要堵塞设备的散热系统。
In equipment operation, not plug equipment heat release part.
请将运转的设备放置在通风处，不宜带电移动。
The heat release rate is the key factor that determines fire hazards.
材料的热释放速率是决定火灾灾害的关键因素。
In an adiabatic system, this heat release serves to increase the chamber temperature.
在一绝热系统中，放出的热量增加了房间的温度。
Once that heat release has cooled the ocean to its freezing temperature, sea ice forms again.
一旦释放出的热量足够多，使海洋达到自己的冰点，海冰又会重新形成。
And sugar intake (mainly polysaccharides), is the most likely cause of high heat release.
而糖的摄取(主要指多糖)，是最容易导致高热量的释放。
The heat release from floor is key nodes in designing of imbed pipe floor heating systems.
地板表面散热量是低温地板辐射供暖设计计算中最重要的参数之一。
The PYROJET is a compact, push through, high heat release, high velocity direct fired heater.
PYROJET空气加热器是一款紧凑型推出式高速直燃加热器。
The measurement of grain respiration heat is the key of ventilation and heat release of grain.
谷物呼吸热值测定是粮食通风散热课题的核心问题。
The HCCI heat release curves in different EGR ratio are simulated with Partition Webie Function.
并结合分段韦伯函数，对不同egr率的HCCI放热率进行模拟研究。
The heat release rate of TBD620V12 diesel engine is analyzed by the method of combustion analysis.
利用燃烧分析方法，对TBD620 V 12柴油机的缸内压力曲线进行了放热规律分析。
Presents several heat exchanging modes of the diesel generator room and the composition of heat release.
介绍了柴油发电机组的几种换热方式与发热量的构成。
To perfect the calculation, we calculated the heat release rate with the actual diagram of work after testing.
样机试验后，再根据实测示功图来计算放热率，从而完善了计算。
The computing formula of the self-heating and combustion heat release source in the coupled models has been set up.
给出了定量确定耦合模型中自热自燃源项的计算式；
In addition, mass loss rate was not the only parameter influencing heat release rate in cone calorimeter for agaric.
同时，木耳的质量损失速率不是影响其热释放速率的惟一因素。
All these effects strengthen creep of the mantle and heat release toward the crust and result in platform activation.
所有这些效应加剧了地幔的蠕动和向地壳的热量释放，并产生地台的活化。
Excess air factor and volumetric heat release rate have little effect on the generation quantity of CO in flue gases.
过量空气系数与容积热负荷对烟气中CO生成量的影响不大。
As a way of maintaining a steady, comfortable temperature, the building features heat release panels high up in the ceiling.
由于保持平稳，舒适的温度的方法，建筑特征放热板高高的天花板。
The control of auto-ignition time and heat release rate is the most difficult technical question in realizing HCCI combustion.
但HCCI燃烧存在运转范围窄、着火时间和放热率不好控制等缺点，具体实施上还有许多困难。
Analyses the characteristics such as large heat release of equipment, compact arrangement of equipment and high rank of voltage.
分析了变电所设备间设备发热量大、设备布置紧凑、电压等级高等特点。
In this paper, the principle of calculation of the heat release rates in diesel engine and the method of calculation are described.
本文介绍了柴油机燃烧放热率计算的基本原理和计算方法。
Disturbances in the recirculating flow regime can produce related variations in the heat release rate in the primary mixing region.
回流区域内的扰动可使主要混合区内热量释放发生相应的变化。
Based on the indicator diagrams obtained, the maximum pressure in cylinder and heat release rate after adding additive were analyzed.
基于实测的示功图，对生物添加剂加入油品后最大缸内压力和燃烧放热率等方面做了发动机燃烧特性分析。
The varying tendencies of mass loss rate, temperatures of each point, and CO concentration were all consistent with heat release rate.
质量损失速率、各点温度以及产物一氧化碳浓度变化曲线均与热释放速率曲线的变化趋势保持一致。
The fully implicit difference method was employed, and the latent heat release was handled with the increment of frozen water fraction.
数值模拟计算采用全隐格式差分方法，用水分冻结量的增量处理相变潜热。
The result shows that the rate of pressure rise and the heat release are the main dynamic load factor that affects the combustion noise.
研究结果表明：气体动力载荷因素中，压力升高率和放热率是影响燃烧噪声的重要因素。
Some heat release rate formulas are added to the application software for calculation on the properties of the fire smoke flow in building.
将各种非稳态火源热释放速率计算式嵌入建筑物火灾烟流性状预测软件并进行了算例验证。
Under off-design operating conditions, shifting of the flame's axial position and its heat release may also influence the system's stability.
在非设计工况下运行时，火焰的轴向位置和燃烧放热的变化也对系统稳定性产生影响。
Heat release rate of the fire is calculated and the distribution of temperatures and concentration of carbon monoxide of smoke are discussed.
计算了火灾释热速率以及着火大空间烟气的温度场和一氧化碳浓度场的变化。
In the convectively heating region latent heat release causes a heating peak in the upper troposphere and a moisture sink in the lower troposphere.
在对流加热区，大量的潜热释放形成深厚的热源和水汽汇，热源峰值出现在上部对流层，水汽汇峰值出现在下部对流层；
应用推荐