High-speed pump belongs to a specific centrifugal pump, and its appearance has put forward new requests and challenges for those designers.
高速泵是一种特殊的离心泵，它的出现对流体输送机械设计人员提出了新的要求和挑战。
Due to high speed, high viscosity pump inside the rotor is barely formed when running idle, surrounding medium by sliding, cause not feeding, or flow rate is small.
由于转速过高，使高粘度泵在运转时内部转子几乎只是形成了空转，围绕所输送介质打滑，造成吸不上料，或者是流量很小。
Recently, the CCR of Qilu Petrochemical refinery hydrocracking workshop successful switch to domestically produced high-speed secondary pump mechanical seals, modified to run in good condition.
近日，齐鲁石化炼油厂连续重整车间加氢裂化高速泵成功改用国产二级机械密封，改造后运行状况良好。
The efficiency of steering pump of port tractor lost very heavy when engine was in high speed.
港口牵引车液压系统中的转向泵在发动机高速状态时的能量损失较大。
Impurity pump mechanical seal after static test, the operation of high-speed rotation of the centrifugal force generated will inhibit the leakage of media.
杂质泵用机械密封经过静试后，运转时高速旋转发生的离心力，会克制介质的泄露。
The Neutral Beam Injection (NBI) system requires a clean high vacuum environment. The liquid helium cryocondensation pump with high pumping speed is an ideal vacuum obtain device.
中性束注入系统要求有洁净的动态高真空环境，大抽速液氦冷凝泵是满足此要求的理想真空获得设备。
The turbine will operate at high temperature and high rotational speed, its pump will work under the conditions of lower or normal temperature, high pressure and high rotational speed.
涡轮在高温、高转速下工作，泵在低温或常温、高压、高转速下工作。
High speed magnetic drive pump just fulfills the special requirements.
采用高速磁力泵可以满足这些特殊要求。
The research result can be referenced for the design and application of high-speed sorting and feeding device of dispensing pump.
研究结果可为泵头盖的高速化整理供送装置设计及应用提供参考。
It is proved that the best method is to enhance the rotor speed and the study shows that the pump can be designed as a full emission or a partial emission pump with a high speed.
得出最理想的方法是提高泵的转速，同时也证明了超临界氦循环泵采用高速全流泵和高速部分流泵设计的可行性。
In this paper, an electronic control system for distributor injection pump of high-speed engine is presented.
本文介绍了小型高速柴油机分配式喷油泵综合电子控制系统。
Because the medium viscosity directly affects the choice of high viscosity pump speed.
因为介质粘度的高低直接影响到选择高粘度泵的转速。
Mix the pump and adopt the whirling impeller of high speed, the material and liquid that will need to mix carry on abundant and effective mixing.
水粉混合泵采用高速旋转的叶轮，将所需混合的料和液进行充分有效的搅拌。
Transport high viscosity medium, low speed pump to be elected, if the low viscosity, the corresponding high-speed selectable.
输送高粘度介质时，泵应选低转速，若粘度较低，相应可选择高转速。
The horizontal high - speed pump in replacing the multi - stage centrifugal pump is adopted. Andits seal and isolate heat parts are also improved. Good effect can be gained after improvement.
高压凝液系统采用卧式高速泵替代原多级离心泵，并对其密封和隔热部分进行改进，改造后获得良好效果。
If the high viscosity pump medium viscosity is too high, and with the rotation speed is too high, will cause the pump flow rate is very low, the noise of the pump is very large.
如果高粘度泵输送的介质粘度过高，而所配的转速也过高的话，就会造成泵的流量很低、泵的噪音很大。
Multileaf foil bearing, instead of ball bearing of turbo-pump in rocket engine, has many important advantages including long life, high speed and low energy loss.
用多叶箔片轴承取代火箭发动机涡轮泵上的滚珠轴承具有工作寿命长、工作转速高、能量损失小等重要优点。
The parallel-connection and variable-speed operation characters of the centrifugal pump groups are studied by conics fitting of the character curves in the high efficiency area.
通过对离心式水泵高效工作区的性能曲线进行二次拟合，分析了离心式水泵机组并联调速运行特性。
Experimental study on moving trajectories of solid particles and their motion pattern in centrifugal pump impellers has been carried out by using high speed photograph technique.
利用高速摄影技术对离心泵叶轮中固体颗粒运动轨迹及其规律进行了试验研究。
High delivery lift and high backpressure required in fuel throttle valve test were obtained through higher rotation speed of the main pump.
利用长征系列发动机主泵作为动力源，提高其转速，解决了燃料节流阀试验要求的高扬程、高背压等技术难题。
The main shaft seal of pump turbines with large capacity at high rotational speed is more liable to failure as compared with that of conventional pump turbines.
大容量、高转速水泵水轮机主轴密封相对常规水轮机主轴密封更容易发生故障。
KT-400 high vacuum oil diffusion pump, which is characterized by extreme high vacuum, pumping speed large, increase production efficiency while the vacuum pneumatic valves with automatic control.
KT- 400高真空油扩散泵，它的特点是真空极限高，抽速大，提高生产效率，同时真空气动阀门采用自动控制。
Based on increasing the per hour yield of modified asphalt, using the high speed shearing machine and pump modified asphalt.
通过对沥青改性方法的研究，基于提高改性沥青单位小时产量的目的，探索出利用高速剪切和二次泵技术实施沥青改性。
It can be concluded that the flow field in the high-speed centrifugal pump with a complex impeller is very complicated, and there exists an obvio...
该计算为进一步提高高速复合叶轮离心泵的性能、减少水力损失提供了一定的理论依据。
Based on the two-dimension theory, a computer code is made in FORTRAN language to design the high specific speed mixed-flow pump.
基于二元理论，用FORTRAN语言编程实现了高比转速混流泵叶轮的水力设计。
This technology uses a high-speed multiphase helico axial pump end and hydraulic turbine driver powered by topside-located conventional water injection systems.
该技术使用高速多相螺旋轴流式泵端及液压涡轮传动装置，并由位于上部的常规注水系统驱动。
Aimed at the conflicts of high speed, high precision and low noise, the improved design for structure joint ways of the motor and variable pump was proposed.
针对高速度、高精度和低噪声之间的矛盾，提出了对电机和泵联接方式的结构改进设计。
Mainly is the pump speed is too high, medium and high viscosity resistance is very big, this will cause pump motor moment of starting current more than rated current, motor overload;
主要是泵的转速太高、介质粘度又太高这样就会造成泵阻力很大，电机的瞬间启动电流超过额定电流，造成电机过载；
The utility model has the advantage that the long service lives of the pump and the oil film of a rotor shaft and an end surface can be maintained under the condition of high-speed rotation.
即使在高速转动状态，也能保持转子轴向端面的油膜，泵的使用寿命长。
The utility model has the advantage that the long service lives of the pump and the oil film of a rotor shaft and an end surface can be maintained under the condition of high-speed rotation.
即使在高速转动状态，也能保持转子轴向端面的油膜，泵的使用寿命长。
应用推荐