There was significant difference in symptom integral, CSS and whole blood viscosity at the high shear rate, respectively (P<0.01).
治疗组的中医症状积分、CSS积分、血黏度高切均优于对照组(P< 0 .0 1)。
The platelet adhesion on surface of fibrillar collagen under high shear rate condition was observed by parallel plate flow chamber with McAb.
利用平行板流动小室技术研究在高剪切力条件下该单抗对血小板在胶原表面黏附的抑制效果。
With its high shear rate and equipped with a water pouring system, the twin screw extruder could be applied to recycle above mentioned materials.
利用挤出机高剪切、可注水的功能实施体型高分子的分解,从而制得性能优良的再生塑料。
It is found that the initial slip length controls the slip behavior at small shear rate, but the critical shear rate controls the boundary slip at high shear rate.
研究发现初始滑移长度对低剪切率下的滑移行为起主要作用,而临界剪切率决定了高剪切率下的边界滑移程度。
The influence of shear rate of the twin-screw stirring mixer with high shear rate on the quality of semi-solid magnesium alloy slurry has been studied by rheo-diecasting process.
采用半固态流变压铸成形工艺,研究了高剪切速率双螺杆机械搅拌制浆机中剪切速率对半固态镁合金浆料质量的影响规律。
The results showed that there was slight chemical reaction between NBR and PA under high temperature and high shear rate, but the chemical reaction did not influence on the process of phase reversion.
结果表明,NBR与PA在高温、高剪切作用下,两相界面之间可发生微化学反应,但并不影响动态硫化时两相之间的相态反转过程。
Strong earthquakes occurred in the high-value region and its margins of shear strain rate, especially in the high-value region of shear strain rate in accordance with tectonic deformation background.
强震通常发生在剪切应变率的高值区及其边缘,尤其是与构造变形背景相一致的剪应变率高值区。
The rheological results of SEBS and TPU by means of high pressure capillary indicates that SEBS is non-Newton fluid, the viscosity decreases when the shear rate increases.
利用高压毛细管流变仪对SEBS和TPU的流变性能进行了研究。结果表明,SEBS熔体流动表现为非牛顿性,粘度随剪切速率增加而降低。
At the same discharge, flow shear rate of fracture fluid is high in the fracture of the thin layer, and its viscosity is low.
在相同排量下,压裂液在薄层裂缝中流动剪切速率高,粘度低。
Based on the theoretic model of one-dimensional shear deformation under high rate loading, a relation of width and spacing for adiabatic shear band to cutting speed is proposed.
通过对高应变速率一维剪切变形理论模型的分析,提出了绝热剪切带宽度和间距与切削速度的关系式。
The related degree is high between blood viscosity in low shear rate and erythrooocyte aggregation index.
分组检验血沉定量增加时其余聚集指标和低切粘度的差异性。
The results showed that high cooling rate of hot rolled billet resulted in abnormal microstructure formation and high hardness, which caused shear cracking.
结果表明,原材料热轧后冷速过快,造成组织异常,硬度偏高,导致了剪切开裂。
When the shear rate is relatively high, this influence obviously weakens.
当剪切速率在比较高的范围内,这种影响明显减弱。
The method for calculating the hole size cf high speed spinning spinneret on the basis of shear rate is presented which has been examined in 15 factories.
文中提出了根据剪切速率计算高速纺喷丝板孔径的方法,并以十五家工厂的资料进行验证。
The method for calculating the hole size cf high speed spinning spinneret on the basis of shear rate is presented which has been examined in 15 factories.
文中提出了根据剪切速率计算高速纺喷丝板孔径的方法,并以十五家工厂的资料进行验证。
应用推荐