Conical degree spiral packing has the advantage in the handling ability, pressure drop and dynamic holdup liquid and so on.
此填料具有处理能力大，阻力压降小，动持液量大、制作简易等优点。
This article mainly introduces the prediction method of the flow pattern, pressure gradient and liquid holdup of two phase flow in horizontal pipelines.
本文着重介绍水平管中这种两相流动的流动型态、压力梯度和持液率的预测方法。
During the operation, the gas holdup and liquid movement velocity could be regulated and controlled using the models to keep the reactor in high-efficiency and steady state.
在实际运行中，通过所建模型对反应器中的气含率和液体运动速率进行有效调控，可实现反应器的高效稳定运行。
Through the statistical analysis of the test results, it was found that we could obtain the liquid slug frequency from the fluctuation of the slug liquid holdup.
通过对试验结果的统计分析可以得出：①可以利用段塞流持液率的波动情况来确定液塞频率。
Hydrodynamics and mass transfer of triplet loop biological fluidized bed reactors were studied in terms of gas holdup, liquid circulation velocity and volumetric mass transfer coefficient.
从气相含率、液体循环速度和体积氧传质系数方面研究自行设计新型结构的三重环流生物流化床的流体力学与传质特性。
The theoretical analyses of the hydrodynamics under a strong interaction flow regime were conducted and data of the bed averaged dynamic liquid holdup were obtained.
对气液强相互作用下滴流床反应器内的流体动力学进行了分析讨论。
Liquid holdup plays an important role in the technology calculation of multi - phase flow. All kinds of correlations always are concluded by the experiment data or field data.
持液率计算在多相流工艺计算中占有重要的地位，各种相关式都是依赖于实验或现场数据得出的经验或半以验相关式。
Determination methods of parameters which involved gas holdup, liquid circulation velocity, solid holdup, bubble behaviors etc in the loop reactor were introduced.
介绍了环流反应器流体力学参数的测定方法，这些参数包括气含率、循环液速、固含率、气泡大小及速度。
Gas holdup and liquid circulation velocity are the mostly important hydrodynamic characters and state parameters of internal-loop airlift reactor.
气含率和液体循环速率是气升式内环流反应器的主要流体力学特征，也是反应器运行过程中的重要状态参数。
The influences of the superficial gas velocity, solid holdup and flowing resistance on gas holdup, bubble size, bubble rise velocity and liquid velocity were systematically studied.
考察了表观气速、固含率和流动阻力对气含率、气泡大小、气泡上升速度和液速的影响。
Solids holdup distribution and liquid backmixing coefficients are fundamental to the scale-up design and optimization of liquid-solid magnetically stabilized reactors.
固含率分布和液相返混系数是液固磁稳定反应器放大与优化所必需的基础数据。
In two-phase oil and gas flow, the calculation of pressure drop and liquid holdup plays an important rule in technological calculation.
在油气两相管流中，压降和持液率的计算在工艺计算中占有重要的地位。
And then, the bubble diameter, bubble number and gas holdup in the bubble group were also measured by bubble and liquid drop auto-surveying instrument.
随后又采用气泡、液滴、泡沫微机自动测量仪测定了气泡团的组成，包括测定了每个气泡团内的气泡直径、气泡个数和气含率等。
The effects of superficial gas velocity, catalyst loading and liquid properties on gas holdup were investigated in a slurry reactor.
在淤浆床反应器中，考察了表观气速、催化剂同含率、液体种类对气含率的影响。
Technological calculation in a hilly multiphase pipe flow includes flow pattern prediction , liquid holdup and pressure drop calculation and temperature prediction.
多相管路的工艺计算包括流型判别，持液率和压降、温降的计算。
Argon bubbles distribute unevenly and the gas holdup of liquid steel in the upper region is far higher than that of the lower region.
氩气的分布不均匀，上回流区钢液的含气率大大高于下回流区。
A drift flux model and an energy dissipation model were set up and were used to describe the gas holdup in the riser and the circulating liquid velocity, respectively.
分别用“漂流通量模型”和“能量耗散模型”描述了气含率和循环液速的变化情况。
A new airlift loop reactor(ALLR) was introduced in this paper. The correlation among liquid phase flowing model, gas holdup and operating conditions of this reactor was investigated.
本文报导了一种新型气升环流反应器 ，对反应器中液相流型、气含率与操作条件之间的关系进行了实验考察。
Liquid circulation rate and gas holdup in an air-lift loop reactor were experimentally investigated as changing with the superficial gas velocity for the system of air-water.
浆液循环速度是外环流浆态床反应器研究中一个重要的流体力学参数，对流体的流动行为和相间传质有重要的影响。
Liquid circulation rate and gas holdup in an air-lift loop reactor were experimentally investigated as changing with the superficial gas velocity for the system of air-water.
浆液循环速度是外环流浆态床反应器研究中一个重要的流体力学参数，对流体的流动行为和相间传质有重要的影响。
应用推荐