A sample so irradiated shows a somewhat lower ignition temperature.
这样照射后的试样，爆发点有所降低。
The ignition temperature and ignition delay time decreased with the increasing radiant heat flux.
结果表明，随着辐射热能流率的增加，着火时间缩短，着火温度降低；
There will be a conspicuous rise in semi-char ignition temperature when the heating rate is increased.
随着加热速率的增加，半焦的着火温度明显上升。
The initial temperature of pyrolysis of Heshan coal was decreased and the ignition temperature was lowered.
油页岩的加入使得高硫煤低温段的燃烧产物初析温度降低，着火温度提前；
A fire requires fuel to burn, air to supply oxygen, and a heat source to bring the fuel up to ignition temperature.
一把火需要燃料来燃烧、空气来提供氧气还有使燃料到底燃烧温度的热量。
The effects of ignition temperature and period of ignition on solubility of scheelite and wolframite have been investigated.
另外还系统地试验了试样灼烧温度和灼烧时间对黑、白钨矿溶解率的影响。
With the content of disordered carbon declining, the reactivity fall, ignition temperature and ignition activation energy increase.
随煤焦的无序碳含量减少，其活性变小，对应的着火温度增加，活化能增加。
Both them has lower ash and sulfur content, higher volatile matter and calorific value, lower ignition temperature and higher reactivity.
这两种煤具有低灰、低硫、高挥发分、高发热量、燃点低、反应性好的特点。
The metal's high ignition temperature of more than 6,920 degrees Fahrenheit forces exhaust gases out at high velocity to propel rockets upward.
这种金属高达6,920华氏度的燃点，释放高温度的气体推进火箭前进。
The ignition of leaked fuel of the diesel engine is studied experimentally. The critical ignition temperature is calculated statistically.
研究了柴油机燃料泄漏后在热壁上的着火，利用统计方法得到着火的临界温度。
The effects of coal rank, pyrolytic temperature of coal and mineral matter in coals or chars on their ignition temperature were determined.
使用可在加压下测定着火点的装置，研究了煤化程度、煤中矿物质和煤焦干馏温度对煤或煤焦的催化着火的影响。
And the apparatus and the method that determines the ignition temperature of coal quickly and accurately using microcomputer are introduced.
介绍了应用微机采样法，快速准确地测定煤的着火温度的装置和方法。
Correlations of coal concentration with the ignition mode, ignition time and ignition temperature of the cloud are predicated by numerical modelling.
通过数值模拟，研究了煤粉浓度与颗粒群的着火方式、着火时间和着火温度等的关系。
The effect of hydrogen on methane combustion and ignition temperature, burning rate and burnout time are discussed through analyzing the calculated results.
通过分析计算，讨论了氢气对甲烷燃烧过程及着火温度、燃烧速率、燃尽时间的影响。
Analyzed the coal dust samples we collected, mensurated the minimum ignition temperature of coal dust layer and coal dust cloud in different diameter range.
对所采集煤尘样品进行实验分析，测定了不同粒径范围下煤尘层和煤尘云的最低着火温度。
Fuel (in vapor form), air (oxygen), and an ignition temperature are necessary for combustion. No combustion can occur without all three of these essentials.
燃料(以蒸汽形式存在)、空气(氧气)和点燃温度是燃烧的必要条件，不具备这三个必要条件不可能燃烧。
Thermal ignition temperature was defined, the thermal ignition process of electric hot wire initiating devices was divided as calefactive phase and explosion phase.
定义了热点火温度，将桥丝式电火工品的热点火过程分为升温阶段和爆炸阶段。
The influences of ignition temperature, fuel content in the precursor gel and calcination temperature on the characteristics of as_prepared particles were investigated.
考察了着火温度、燃料用量和热处理温度对所获得的粉体特性的影响。
In circulating fluidized beds, but with existing problems of high ignition temperature, large content of carbon in the fly ash and relatively low efficiency of combustion.
试验结果发现循环流化床能够有效燃烧无烟煤，但存在着火温度高，飞灰含碳量大，燃烧效率较低等问题。
In addition to the significant merit of no soot emission, DME would be of better ignition quality, lower autoignition temperature and better atomization compared to diesel fuel.
除了无碳烟排放的重要特点以外，和柴油相比二甲醚还具有较好的燃烧性能、较低的自燃温度和较好的雾化特性。
This blend with improved higher ignition temperature is used in the absorbent products industry as an absorbent core, when the blend is heated sufficiently to melt the polyolefin.
这种改进的点火温度较高的混合是用于工业产品，作为吸收剂吸收核心混合时，充分加热熔化的聚烯烃。
The result also indicates that ignition temperature of coal blend is mainly decided by the properties of easily ignited coal when coals blended with great different ignition properties.
计算结果进一步证明，由两种着火特性差别较大煤种组成的混煤，其着火温度主要取决于易着火煤的着火特性。
Combustion parameters such as ignition temperature, peak temperature of maximum weight loss rate, burnout temperature, maximum rate of combustion, and combustibility index were analyzed.
分析了燃烧特征参数如着火温度、燃烧速率最大时的温度、燃尽温度和最大燃烧速率以及燃烧特性指数。
The critical ignition temperature of polyurethane foam was lower as the size of the sample vessel was increased, and that the combustion of cyclopentane-polyurethane foam occurred fiercely.
随着样品容器量加大，聚氨酯的临界燃点降低，环戊烷—聚氨酯发泡塑料会发生剧烈燃烧。
With the rise of heating rate, the maximum release rate of volatile and combustion rate of char, the burnout temperature and the combustible parameter increased, but the ignition temperature…
各试样的挥发分最大释放速率、固定炭最大燃烧速率、燃尽温度均呈增加趋势，它们的燃烧特性均随升温速率的升高而变好。
The law of homogeneous gas ignition temperature(GIT) of pulverized coal particle clusters was investigated on a one-dimensional furnace under reburning conditions with low oxygen concentration.
在一维炉试验台上研究了煤粉颗粒群在低氧浓度再燃条件下的均相着火规律。
An ignition stability index for pulverized coal (CI) has been contrived with IG-DTG analysis data. It comprehensively reflects the pulverized coal's ignition temperature and its combustion intensity.
利用热分析(TG - DTG)数据建立了煤粉着火稳定性指数CI，它是煤粉着火温度与燃烧强度的综合反映。
This method compresses the air to the point where the resulting rise in temperature causes ignition to occur when diesel fuel is added.
压缩点火方式是指添加柴油时压缩空气使温度升高到柴油的燃点而使柴油燃烧。
The study also shows that the ignition and combustion of boron particle lie on the resorting time and the environment temperature, and have no direct relationship with after-burning chamber's length.
研究还发现，硼颗粒的点火燃烧主要取决于硼颗粒在补燃室内的滞留时间和所处的环境温度，而与补燃室的长度没有直接关系。
The study also shows that the ignition and combustion of boron particle lie on the resorting time and the environment temperature, and have no direct relationship with after-burning chamber's length.
研究还发现，硼颗粒的点火燃烧主要取决于硼颗粒在补燃室内的滞留时间和所处的环境温度，而与补燃室的长度没有直接关系。
应用推荐