So I'll start at some initial temperature, T1.
那么我从某个初始温度T1开始。
Initial temperature of catalyst bed is wholly too high.
提高起始反应温度使催化剂床层温度整体过高导致飞温。
Usually the initial temperature and pressure are adjusted so that the gas is cooled.
通常调整起始温度和压力，使气体降温。
The initial temperature of solid heat carrier has great influence on the gas composition.
热载体初始温度对热解气组成影响显著。
The initial temperature of the water in the beaker is also the same as in the experiment.
烧杯里的水的最初温度与上述实验的水的最初温度相同。
The entanglement achieved by fields heavily depends on their initial temperature and the detuning.
这个通过热场获得的纠缠深深的依赖于初始热场的温度和失谐。
The bigger plate thickness is and higher the initial temperature is, the quicker temperature drop is.
轧件越厚，起始温度越高，温降速度越快。
This essay mainly specifies the impacts of the blade cooling technique on the turbine initial temperature.
着重叙述的是叶片的冷却技术对提高透平初温的影响。
The initial temperature of pyrolysis of Heshan coal was decreased and the ignition temperature was lowered.
油页岩的加入使得高硫煤低温段的燃烧产物初析温度降低，着火温度提前；
More moisture content and higher soil initial temperature are favorable to the design and operation of GSHP systems.
当土壤含湿量大、土壤初始温度高时，对于系统的设计与运行是有利的。
The increase of the gas turbine work ratio is mostly demonstrated by the increase of the turbine initial temperature.
燃气轮机效率的提高，主要表现在透平初温的提高。
When the heating power maintain at 20 W, the higher battery level is, the lower thermal runaway initial temperature is.
恒定加热功率为20W 时，充电电流越高，热失控起始温度越低， 电池内部反应越剧烈；
The dimension of the solid phase heated from room temperature is bigger than that heated from a higher initial temperature.
随炉加热方式所获得的固相颗粒尺寸比热炉加热方式所获得的固相颗粒尺寸大。
The influence of initial temperature of reservoir is fairly important, and the initial pressure of reservoir is little important.
油藏初始温度对火烧油层驱油效果影响较大，而油藏初始压力则影响较小。
Based on chaotic variable, a chaos simulated annealing algorithm is proposed and the method of defining the initial temperature is given.
基于混沌变量，提出一种混沌模拟退火优化方法，给出了初始温度的确定方法。
The changes of the compression ratio, equivalence ratio, and initial temperature will bring on distinct change of the ignition of combustion.
而压缩比，燃空当量比，进气温度的变化会引起燃料着火时刻的显著变化。
The results show that the instantaneous temperature of solder droplet when it reached the pad is mainly determined by the initial temperature.
结果表明：对钎料熔滴到达焊盘瞬时的接触温度，熔滴初始温度是其主要影响因素，而高度变化对其影响不大。
When references experience a temperature change and return to the initial temperature, they do not always have the same initial output voltage.
当基准经历一个温度变化且返回初始温度，它们并非总能获得与初始电压相同的电压。
The influence of temperature to the composite stress is very complex, it relates to initial temperature, temperature range and the way to give loads.
温度变化对复合材料板应力场的影响与温度变化幅值、加载方式和初始温度的大小有很大的关系。
The optimization of Initial Temperature Difference (ITD) is the relatively key part in the process of the design of the direct air cooling power station.
初始换热温差ITD值的优化是直接空冷电站设计过程中较为关键的部分，关系到整个电站设计是否经济、合理。
The effects of electric voltage applied, heat fluxes, flow velocity and initial temperature of the oil on the heat transfer enhancement were fully investigated.
以实验方法调查了其换热系数强化率与外加电场强度、热通量及流动速度、油温、管型等因素的相关性。
In addition, it is indicated that the initial temperature of the drop before it droped down is related closely to the nucleation and crystal growth of the alloy.
此外，液滴下落以前的初始温度也与玻璃形成、晶体的成核和长大有密切联系。
Influence of the initial temperature fields and mold hardness on the shrinkage defect of ductile iron casting by EPC process was mainly investigated in this paper.
本文主要讨论了初始温度场和铸型硬度对消失模铸造球墨铸铁件收缩缺陷的影响。
The results can provide reference for equipment design on occasions which has requirement for initial temperature such as in design of hydrogen refueling stations.
研究结果可以为加氢站等对于初始温度有要求场合的设计提供参考。
Then the authors analyse the effect of initial temperature and cooling rate on thermal stress and the low temperature cracking performance of different asphalt cement.
然后探讨了初始温度和降温速率等对温度应力的影响以及不同材料的低温抗裂性能。
Thermodynamic principle of heat recovery system for low temperature waste heat with a given initial temperature and flow and for non-cycling operation is proposed in the article.
本文针对初温、流量一定且不循环使用的低温余热，提出确定其动力回收系统参数的热力学原则。
In the thermal analysis, the initial temperature of billet, beat fluxes (heat flow per unit area) of positive and negative value and convections to surrounding air are considered.
热分析中考虑了坯料的初始温度、外加热源和冷却源的热流密度以及坯料和空气的对流传热。
To carry out the data assimilation of sea temperature observations the adjoint method is applied, which can provide an accurate initial temperature field for numerical prediction.
以一维水温模型为例，利用伴随算子法进行海洋观测数据同化，以便给水温的数值预报提供一个较准确的初始场。
The pulverized coal-air flow ignition limit is mainly influenced by such parameters as initial temperature, ignition source temperature, coal rank and the fineness of the pulverized coal.
煤粉气流的着火界限主要受初始温度、点火源温度、煤种和煤粉细度的影响；
The pulverized coal-air flow ignition limit is mainly influenced by such parameters as initial temperature, ignition source temperature, coal rank and the fineness of the pulverized coal.
煤粉气流的着火界限主要受初始温度、点火源温度、煤种和煤粉细度的影响；
应用推荐