It USES a fast actuated nozzle to follow the exhaust pulse, reducing the turbine inlet area periodically to increase exhaust-gas pressure.
涡流增压器采用了一个快速响应喷头来跟踪尾气脉冲，减少内燃机的进气周期，从而增加尾气排放压力。
Temperature distortion on inlet flow of engine is more important than pressure distortion for engine stability.
进口流场的温度畸变对军用飞机发动机稳定性具有比压力畸变更大的影响。
Requirement: Air inlet must start to open when down stream pressure is 1.0 PSI or above.
要求：当下游流体压力在1.0PSI及以上时，空气进口必须开始打开。
One pressure inlet, two cylinder ports providing pressure to the double acting cylinder or actuator and one or two outlets to exhaust pressure from the cylinders.
一进气压力，双缸端口提供的压力，双作用气缸或执行器和一个或多个渠道从排气汽缸压力。
Fig. 5 shows the variation of the system specific irreversibility using R113 with the turbine inlet pressure under the same conditions used to generate the results shown in Fig. 3.
图5显示了系统具体的不可逆性的变化用R113涡轮进气压力相同的条件下用于生成图3所示的结果。
The optimum parameters, such as electron current and voltage for ionization, acceleration voltage, retarding voltage, gas inlet pressure, were determined by experiments.
通过实验确定了最佳参数，其中包括：离化电子电流和电压、加速电压、阻止电势、供气压力等。
Essentially balanced single seat minimizes a variation in delivery pressure resulting from a varying inlet pressure.
基本平衡单阀座最大限度减小进口压力变化对输出压力的影响。
Crane globe valves are highly efficient for services requiring frequent operation and throttling when pressure drop across the valve is about 20% of inlet pressure.
当通过阀门的压降为管路压力的20%左右时，美国克雷恩截止阀就能够高效应用在频繁操作和节流的应用场合。
Engine pressure ratio (EPR), the ratio of inlet pressure over exhaust-let pressure measurements. The ratio is used as the primary parameter to set thrust on some engines.
发动机压力比(epr)，进气压力与排气压力值的比，某些发动机以此作为设定推力的主要依据。
By changing the nozzle inlet pressure, drill gage width, nozzle diameter factors, to study the changes in these flow fields.
通过改变喷嘴入口压力、钻头保径宽度、喷嘴直径等影响因素，来研究井底流场的变化。
Circulating water pump inlet pipe and outlet pipe should also install pressure gauge.
循环水泵的进水管和出水管上也应装压力表。
Hydrostatic pressure testing of the inlet valves (with open and closed disc) under a pressure of 1, 5 times the maximum static pressure plus water hammer for 30 minutes.
持续30分钟1.5倍的最大静压与水锤压力下，对入口阀(带打开和关闭盘)的静水压试验。
The inlet pressure of the jet pump can also be obtained by the pressure ratio, and it can be used for acquiring the productivity curve of an oil well.
这样，就可以计算出诊断喷射泵井工况所需要的压力比，流量比和泵效等工况参数，泵吸入口压力还可用来计算油井的产能曲线。
Also, it is found and analysed that there exists inlet pressure fluctuation of coiled capillary tubes when the degree of subcooling is changed from one to another.
从一个过冷度工况向另一个过冷度工况转变的过程中存在螺旋管毛细管入口处压力的波动，并对此现象作了简要分析。
This experiment focuses on the influence of inlet pressure and consistence to performance of hydrocyclone including output, separation efficiency, separation precision etc.
本实验研究了水力旋流器的进口压力与浓度对旋流器性能的影响，包括生产能力、分级效率、分级精度、分级粒度等指标。
The vaporized refrigerant vapor from the low temperature and low pressure, suction inlet of the compressor to be compressed, compressed and then discharged into the next cycle.
蒸发后的低温低压冷媒蒸气，从压缩机的吸气口流回，被压缩压缩后排出进入下一循环。
Air inlet filter pressure differential gauge, shipped loose.
空气进气过滤器压差表，散件。
Carrying pressing influences, about 80% that can reach the inlet pressure while carrying the pressing rate.
不受背压影响，背压率可以达到进口压力的80%左右。
Several calculating methods for determining the air-flow rate, the exhaust temperature, the compressor outlet pressure and the turbine inlet pressure are compared.
对四冲程柴油机增压系统的空气流量，排气温度、压气机出口压力和涡轮进口压力的若干种计算方法进行了分析。
The control options include inlet pressure control, discharge pressure control and flow rate control.
控制方式包括进站压力控制、出站压力控制和流量控制。
Indication of inlet-outlet pressure difference between master cyclone inlet and outlet; local indication of pressure difference between high-efficiency filter inlet and outlet.
主旋风分离器进出口压差显示，高效过滤器进出口压差现场显示。
If the grain size distribution of suspending liquid at inlet is identical, the change of inlet pressure and underflow port diameter can influence the separation efficiency.
在进料口悬浮液固相颗粒粒级分布相同的情况下，进料口压力和底流口直径的变化同样对分离效率产生影响。
First, the influences of inlet pressure variations on micro nozzle's performance are obtained by analyzing the variations of various flow parameters in micro nozzle accordingly.
首先，考虑变化压力，分析微喷管流场各项参数的变化，得出其对微喷管性能的影响。
For compressible fluids, where pressure drop exceeds half the inlet pressure.
对于可压缩性流体，如果压降超过进口压力的一半。
High inlet pressure can be caused by too high gas flow.
高气压力可能造成的过高的气体流量。
By applying black box theory inlet pressure, inlet subcooling, outlet pressure and valve opening are selected as influence factors to flow coefficient of electronic expansion valve (EEV).
根据黑箱理论提出将阀前压力、阀前过冷度、阀后压力和膨胀阀流通面积作为膨胀阀流量系数的影响参数。
Calculate the pressure difference by subtracting the desired outlet pressure from the maximum inlet pressure.
基本平衡单阀座最大限度减小进口压力变化对输出压力的影响。
A booster pump, used to increase the sterilization machine into this machine inlet pressure.
一台增压泵，用于增加杀菌机进入本机的进口压力。
The overflow tank level and the speed of both the role of Chip can be changed by changing the factors such as the nozzle inlet pressure, drill gage width, nozzle diameter of the PDC bit.
改变喷嘴入口压力、钻头保径宽度、喷嘴直径等影响因素对改变井底漫流层和排屑槽内的速度都有作用；
Relative to uniform inlet pressure, the distorted or actual profiles may have a rather profound effect on engine performance.
与均匀的压力分布比较起来，畸变的或真实的压力场对发动性能具有相当大的影响。
应用推荐