The falling water level denoted the passing hour as it dipped below hour lines inscribed on the inner surface.
当下降的水位低于内表面刻下的小时线，表示经过了多少时间。
Internal spline is a spline formed on the inner surface of a cylinder.
内花键：内花键是在圆柱体的孔的内表面形成的花键。
The inner surface at one end of metal insert is cone-shaped sealing surface.
上述金属嵌件一端部的内表面为锥形的密封面。
A comprehensive measuring system for the inner surface of artillery is researched.
研究一种用于火炮身管内表面的综合测量系统。
Kurt kept to the inner surface of the spiral, avoiding the darkness that lay beyond.
库尔特留在螺旋的内表面，避开超出去的黑暗部分。
The tool is a rectangular framework that the inner surface of a vertical array of grooves.
该模具为一矩形框架，该框架的内表面设有纵向排列的凹槽。
The researchers studied how aspirin affects the cells found on the inner surface of blood vessels.
研究者研究了如何影响细胞发现阿司匹林的内表面的血管。
A new method of detecting the inner surface and inner diameter of the steel tube is introduced.
提出一种新的检测钢管内表面质量和内直径的方法。
A new method for inspecting inner diameter and inner surface quality of a steel tube is proposed.
提出了一种新的检测钢管内直径及内表面质量的方法。
DNA probe was immobilized in inner surface of a capillary to make a DNA capillary bioreactor (DNA-CBR).
在毛细管内表面将DNA探针固定化，制成荧光毛细生物反应器(DNA -CBR)。
The lamellae (10) have a resin body and a recess (13) in the inner surface (12), in the plane of symmetry.
薄板(10)在内表面(12)有一个树脂体和一个凹槽(13)，位于对称平面内。
Effect of different machining parameters upon the inner surface roughness and the removal rate was analyzed.
分析了不同加工参数对被加工内圆表面粗糙度和研磨量的影响。
Above: Salivary lips showing parallel ridges of inner surface of lower lip, last larval instar of Osmia chalybea.
上图：壁蜂老熟幼虫下唇内表面的平行纹
Conductive or semiconductive layer tightly attached on the insulated inner surface and the outer surface of.
导电或半导电层紧紧地贴合在绝缘的内表面和外表面上。
The results showed that long pulse could increase impact energy on inner surface but had little effect on retained dose.
结果表明，长注入脉宽可以提高内表面注入能量，但对注入剂量影响不大；
Due to the special capability of the inner surface magnetic finishing, long tubes and excitation setup can not rotate quickly.
由于物流管道内表面磁力研磨的特殊性，管道及励磁机构都不宜作高速旋转运动。
The relationship of the change of pore structure and inner surface area during gasification with gasification rate was studied.
研究了反应过程中，煤焦的孔结构和内表面积的变化及它们与气化速率间的关系。
Methods:The tendofemoral contact between the inner surface of quadriceps and femoral condylar was observed on 50 knee specimens.
方法：对50侧膝关节的股四头肌腱内面及其与股骨髁的接触进行了观测。
Lower impact energy and retained dose were found in inner surface PIII, but the former was not very serious, while the latter was.
通过模拟发现，内表面注入过程存在注入能量和注入剂量偏低的问题，但前者并不十分严重，而后者则比较严重。
Sensors on the inner surface of the beakers act like electronic tongues and "taste" the dirt to detect salts that can dissolve in water.
烧杯内表面上的传感器象一条电子舌头，品尝土壤以探测其中的水溶性盐分。
It can be heated or cooled; inner surface adopts mirror polish, no dead Angle, and closed design to ensure material in asepsis condition.
可加热、冷却，内表面采用镜面抛光，无卫生死角，全封闭的设计确保物料始终处在无菌状态下。
And the impulse coupling coefficient is not sensitive to nozzle length and the distance between ignition zone and inner surface of nozzle.
而冲量耦合系数对点火区与聚光系统内表面的距离及喷管长度等参数并不十分敏感。
Using this method, the post-machining inner surface is obtained, and it makes the cutting locus planning in NC machining process possible.
在此基础上得到加工后内廓曲面，为数控加工中刀具轨迹的规划奠定了基础。
Meantime, the compressive stress in inner surface of hollow roller by nitrocarburizing is available for improvement of bend fatigue property.
同时，共渗在空心滚子内表面造成的压应力对改善弯曲疲劳性能有利。
The results show that the welding residual stress on the outer surface and on the inner surface behave quite differently with heated band width.
结果表明，管子内、外侧残余应力和加热宽度表现出不同的规律：管子外侧的残余应力随加热宽度的增加缓慢下降；
The inner surface at one open end of the plastic layer has the thread, and the thread on the plastic layer is connected with the thread on the metal insert.
上述塑料层的一开口端内表面开设有螺纹，该塑料层上的螺纹与金属嵌件上的螺纹相连接。
Comparing with normal rats' bone structure, the specific inner surface and the volume fraction of inorganic mineral's particles in osteoporotic rats reduced.
与正常大鼠的骨结构相比，骨质疏松模型大鼠中的无机矿物质颗粒的比内表面和体积百分数减小。
The metal-plastic composite nut, according to Claim 1 and 2, is characterized in that the inner surface at one end of metal insert is cone-shaped sealing surface.
根据权利要求1或2所述的金属塑料复合螺帽，其特征在于所述金属嵌件一端部的内表面为锥形的密封面。
The metal-plastic composite nut, according to Claim 1 and 2, is characterized in that the inner surface at one end of metal insert is cone-shaped sealing surface.
根据权利要求1或2所述的金属塑料复合螺帽，其特征在于所述金属嵌件一端部的内表面为锥形的密封面。
应用推荐