Therefore, it's prudent to measure the insulation resistance of the test fixtures and cables periodically with an electrometer ohmmeter to ensure their integrity.
因此谨慎的做法是定期地用静电计欧姆计来测量测试夹具和电缆的绝缘电阻，以保证其完整性。
This diagram shows measuring the insulation resistance between any one pin and all other pins on a multipin connector.
在该图中，我们测量一个多管脚的连接器中某个管脚与其它所有管脚之间的绝缘电阻。
Some of these applications may include leakage current of capacitors, reverse diode leakage, or insulation resistance of cables or films.
这类应用可能包括电容器的漏电流、二极管反向漏电、电缆或薄膜的绝缘电阻等。
Measuring insulation resistance for circuit.
电路绝缘电阻测量。
When measuring high resistance, the insulation resistance of the cable is important.
在测量高电阻时，电缆的绝缘电阻是很重要的。
Some applications, such as testing insulation resistance of cables and printed circuit boards and high-pot testing, may require switching high voltages.
在有些应用中，例如测试电缆和印制板的绝缘电阻及耐压测试，可能需要切换高压信号。
Excess humidity can reduce insulation resistance on PC boards and in test connection insulators.
过高的湿度会降低印制电路板和测试连接绝缘子的绝缘电阻。
The procedure for insulation resistance testing consists of preparing, conditioning, and measuring the sample. Details may vary, based on specific test methods.
绝缘电阻测试的步骤包括样品准备、条件控制和测量样品等。根据特定的测试方法，具体的步骤可能会有所变化。
Periodically measure insulation resistance, inspect motor sheath grounding.
定期测量绝缘电阻，检查机壳接地情况。
A reduction in insulation resistance can, of course, have a serious effect on high impedance measurements.
当然，绝缘电阻的降低会严重影响高阻抗测量工作。
On raining days, the insulation resistance of the generator often drops below 0.5 megohm.
在雨天，发电机的绝缘电阻常常降到0.5兆欧以下。
The insulation resistance of these motors should be kept above 1 megohm.
电动机的绝缘电阻应保持大于1兆欧。
If a PCB has low insulation resistance (ir), it can degrade the performance of the circuits on the board considerably.
如果某块PC B具有低绝缘电阻(IR)，则会大大降低印制板上电路的性能。
Low surface insulation resistance (SIR) of a printed circuit board (PCB) can degrade the performance of the circuits on the board considerably.
印制电路板的表面绝缘电阻(SIR)低会大大降低电路板的电路性能。
Examples of insulation resistance measurements include measuring the path be tween traces on a printed circuit board or the resistance between conductors in a multi-conductor cable.
测量绝缘电阻的例子包括测量印制板上走线之间的通路，或多芯电缆中导线之间的电阻。
Insulation resistance is used to describe the isolation performance of high voltage system of electric vehicle.
提出用绝缘电阻描述电动汽车高压电气系统的绝缘性能。
Measure each phase conductor to metal mask and to metal sleeve insulation resistance.
测量每相导体与金属屏蔽、金属套间的绝缘电阻。
Check whether the insulation resistance and the dielectric strength of the electric devices attached to the panel and equipment body are sufficient.
检查一下控电板和设备体上的那些电器设备，看看他们的绝缘电阻和绝缘强度是否合格。
The procedure for insulation resistance testing consists of preparing, conditioning, and measuring the sample.
绝缘电阻测试的步骤包括样品准备、条件控制和测量样品等。
Measure each phase metal mask, metal sleeve to ground insulation resistance.
测量每相金属屏蔽、金属套与大地之间的绝缘电阻。
Sometimes the insulation resistance of a sample is measured only to determine that it is greater than a specified minimum value.
有时候测量一个样本的绝缘电阻仅仅是为了确认大于规定的一个最小值。
The results show that there is not any evidence of silver migration within LTCC construction, and conductor adhesive force, wire-bonding strength and insulation resistance are high.
结果表明：基板内部的银导体不存在迁移现象，导体的附着力、键合强度以及基板的绝缘电阻等性能均比较理想。
It introduces the measurement of insulation resistance and its significance.
介绍了绝缘电阻的测试及其意义。
The testing of insulation resistance, dielectrics voltage-resistance and contact resistance is essential for the connector to reliably operate.
绝缘电阻、介质耐压和接触电阻检验是保证电连接器正常可靠地工作的最基本的常规检验项目。
Analysis shows that the main factor of instability of insulation resistance is machining burr.
通过分析，绝缘电阻不稳定的主要原因是机械加工毛刺。
High insulation resistance, good capacitance stability.
绝缘电阻高，电容量稳定性好。
High insulation resistance, good capacitance stability.
绝缘电阻高，电容量稳定性好。
应用推荐