The carbon content in gas phase was obtained by calculation at different pressures. The interval of temperature was decreased at low pressure.
分析了不同压力下气相传递物质中的碳含量，压力降低使传递的温度区间缩小。
Crude oil's freezing point defined by the routine freezing point analysis is an interval of temperature. The testing process is complicated, with an obvious error influenced by artificial factors.
常规的原油凝点分析是定义凝点为一范围温度，其测试过程复杂，人为因素的影响致使误差较大。
The interval of the coating time is determined by the temperature at the time of construction and the degree of curing of the film (by hand).
重涂时间的间隔，由施工时的温度和涂膜固化的程度（以手触不粘）来确定。
With the steel line and the solid phase of the high and low liquidus temperature and crystallization temperature of the size of interval.
它们与钢的固相线和液相线温度的高低及结晶温度区间的大小有关。
Function description: quicken the cooling of rubber mould; shorten the interval time of using the mould (increase the output); reduce the high-temperature bearing time (lengthen the service life).
功能描述：加快橡胶模具的冷却、减少模具再次使用的间隔时间(提高产量)、减少高温承受时间(使用寿命更长)。
The effect of quenching temperature, the interval time from quenching to aging and aging institution to 2A70 aluminium alloy pre-stretching plate structure and properties are introduced.
介绍了固溶处理温度、淬火到时效间隔时间及时效制度等对2A70铝合金预拉伸厚板组织和性能的影响；
The Interval load Method was adopted to study the relation between the molecular motion of amorphous PMMA and temperature.
采用间歇加力试验法研究非晶聚合物材料pmma的分子运动-温度关系。
According to the feature of SLS, the parameters of interest are layer thickness, hatch spacing, laser power, scan speed, work surroundings temperature, interval time and scanning mode.
根据SLS加工工艺的特点，研究的工艺参数包括：层厚、扫描间距、激光功率、扫描速度、环境温度、层与层之间的加工时间间隔和扫描方式。
Effects of hormone dosage, interval time of hormone injection, oestrus period, season and temperature influenced on mouse superovulation were studied in this experiment.
分析了激素剂量、激素注射间隔时间、发情周期、季节和温度对小鼠超排效果的影响。
Measures of crevices preventing such as the control of temperature and interval of expansion joint are given forth.
提出了温度控制与伸缩缝最大间距控制等防止引起裂缝的措施。
The results show that the softening ratio increases with the increase of deformation temperature and interval time.
结果表明，其静态软化率随变形温度的升高和道次间隔时间的延长而不断增加。
The results showed that the solid liquid phase zone, temperature interval and segregation degree may be obviously enlarged with increasing s content so as to reduce the hot plasticity of the alloy.
结果表明，随着S含量的增加，导致固液两相区、温度范围和偏析程度明显加大，引起合金的热塑性降低。
A concept of equilibrium temperature interval is used to estimate kinetic attributes of reactions.
引入平衡温距的概念来估计反应的动力学属性。
It concludes that the interval model built in the paper has good performance in predicting the temperature variations of ball screws.
显示该模型能较好地预测丝杠温度随时间的变化。
Showed in Table 1, curves formed in the process of body sections' temperature dropping are similar. (The Sequence No. is recording time after a body sections exposed, and the interval is 42 seconds;
表1显示曲线，在此进程中形成的身材部分的温降是相似的。 （序列没有。是一具遗体后，记录时间部分暴露，隔断是42秒；
Showed in Table 1, curves formed in the process of body sections' temperature dropping are similar. (The Sequence No. is recording time after a body sections exposed, and the interval is 42 seconds;
表1显示曲线，在此进程中形成的身材部分的温降是相似的。 （序列没有。是一具遗体后，记录时间部分暴露，隔断是42秒；
应用推荐