Short-time cooking with low pressure steam can produce delicious soymilk of high quality.
利用充分的低压蒸气短时间加热！
The heat source for operation of evaporation may be low pressure steam or surplus heat steam;
蒸发操作的热源可采用抵压蒸汽或废热蒸汽。
Performance of a low pressure steam turbine with bowed bladings was simulated by solving 3d ns equations at different working conditions.
本文对某空冷汽轮机马刀叶片性能进行了不同工况三维数值分析。
The dry, reheated steam then enters the low pressure turbine.
再热过的蒸气然后进入到汽轮机的低压缸。
The boot after the refrigerant compressed by the compressor from low temperature to high temperature and high pressure steam.
开机后冷媒经压缩机压缩由原来的低温低压状态变成高温高压的蒸气。
Ejecting and heating performance of the heater at low steam pressure was studied through the experimental method.
用试验方法研究了该加热器在低进汽压力下的引射性能和加热性能。
The rest of the heat may be allowed to escape, or, for maximum engine efficiency, the steam may be condensed in a separate apparatus, a condenser, at comparatively low temperature and pressure.
剩余的热可以排放，或者蒸汽可在单独的冷凝器中于较低的温度和压力下冷凝，以便获得最大的蒸汽机效率。
The sensitivity analysis indicates that the parameters impacting the production results from high to low are production time, steam dryness, cyclic steam injection volume, steam injection pressure.
敏感性分析表明，蒸汽参数对开发效果影响的顺序从大到小依次为生产时间、注汽干度、周期注汽量、注汽压力、焖井时间和注汽速度；
On this basis, the control of exports of low-pressure steam to reduce pressure on Desuperheater pumps running, saving a great deal of power consumption.
在此基础上，控制低压蒸汽出口压力，减少减温水泵的运行，节约了大量电耗。
Therefore it is in urgent need to develop and promote the heat supply system of low steam pressure heat pump, in which the steam working pressure is below 0.
通过设计、研究和生产运行实例，分析了低压蒸汽热泵的技术要点及推广价值。
Large size parts generally refer to those parts with more than one meter long in each dimension, such as low-pressure cylinder of steam turbine, wing panel of plane and so on.
大型零件通常是指那些在各个维度的尺寸超过一米的零件，比如蒸汽轮机的低压缸体，飞机的机翼壁板以及一些专用零件。
A new type of plate heat exchanger using low-pressure secondary steam was introduced in this article.
介绍了一种能利用低压二次蒸汽的新型板式换热器在味精厂的应用。
Afterheat of iron and steel enterprises can be divided into two types - high grade and low grade. Residual pressure of heating steam is an important component of high grade afterheat.
钢铁企业的余热可分成高、低品位两大类。供热蒸汽的裕压是高品位余热的重要组成。
Triethyleneglycol widely used as dehydration solvent in natural gas industry, it has many advantages such as thermodynamics stabilization, strong SOP up and low steam pressure.
三甘醇因其具热稳定性好、吸水性强、蒸汽压低等优点，作为天然气脱水溶剂得到了广泛的应用。
Has the properties of high spark point and low steam pressure, and can be used safely.
具有高闪点和低蒸气压的性能，使用安全。
The first steam engines in practical use in England and the United States were of low-pressure design.
在英美应用的第一台蒸汽机采用了低压设计。
This valve is suitable for steam which is high differential pressure and high temperature hot water, with a large CV value, high rangeability and low leakage.
该阀门适用于高差压的蒸汽及高温热水，具较大的CV值，高幅度变化范围、低泄漏。
It also gives out a variable coefficient density compensation formula used for measurement of mass flow of the low pressure saturated steam, and the features of this formula.
给出了一个用于低压饱和蒸汽质量流量测量的变系数密度补偿式和该补偿式的特色。
The invention has the advantages that a plurality of medium-pressure steam and low-pressure steam are saved and the waste heat of the co conversion is recycled thoroughly.
本发明的优点在于：可节省大量的中压蒸汽、低压蒸汽，彻底回收CO变换的余热。
From 1993, the reconstruction of low pressure cylinder sealing began to conduct. The floating ring seal are changed into steam jamming seal. The applied effect is good.
1993年开始实施低压缸密封改造，将浮环密封改造成蒸汽阻塞密封，使用效果良好。
The method and step of the calculation of the low cycle fatigue for the high pressure rotor of a steam turbine are introduced and summarized.
本文推论并总结了对汽轮机高压转子进行低周疲劳计算的方法和步骤。
Ultrasonic inspection technology for the narrow section of a weld in low-pressure rotor of steam turbine is studied.
研究汽轮机低压转子焊缝狭窄部位超声波探伤工艺。
Superheated steam trap at low temperature, low pressure, a small load of unruly conditions disappeared with the superheated steam generated when the low-temperature condensed water.
过热蒸汽疏水阀能在低温、低压、小载荷的顽劣工况下结合出过热蒸汽失踪时产生的低温凝聚水。
Run the operation under the control of optimizing aspect being that low pressure inclines shaft seal steam supply pressure , shaft seal heater and shaft seal chiller mainly;
运行优化方面主要是低压侧轴封供汽压力、轴封加热器和轴封冷却器的运行控制；
Run the operation under the control of optimizing aspect being that low pressure inclines shaft seal steam supply pressure , shaft seal heater and shaft seal chiller mainly;
运行优化方面主要是低压侧轴封供汽压力、轴封加热器和轴封冷却器的运行控制；
应用推荐