Reduce hydraulic control manifold pressure to 5200kpa.
将液压控制管汇压力减小到5200千帕。
Then the presented approach is applied to the identification of the manifold pressure in automotive engines. Finally...
最后，将所提出的方法用于汽车发动机歧气管压力系统的模型识别。
The intake manifold pressure is lower when the cranking speed increases, thus the fuel metering strategy should be modified.
随着拖动转速升高，进气歧管压力降低，对应的喷油策略也应随之调整；
After analyzing the signals of the manifold pressure sensor, the sampling algorithm is received by the spectrum characteristics.
在深入分析汽油机进气压力传感器信号的基础上，基于频谱特性确定了信号采集算法。
This paper introduces the calibration system and static and dynamic calibration method of an engine intake manifold pressure sensor.
介绍了发动机进气歧管压力传感器的标定系统和传感器静、动态标定方法。
Load change in the engine intake manifold pressure changes that is when the spool displacement greater, gas output in response to faster.
在发动机负荷变化即进气管压力变化时，阀芯的位移更大，燃气输出量的响应更快。
Taking the nonlinear character of intake system into account, the relation between manifold pressure and intake system parameters is given based on the intake dynamic model.
针对汽油机进气系统的非线性特性，基于汽油机进气通路动态模型，给出了进气压力与系统参数之间的关系。
The results show that the error of estimated value of both throttle position sensor and manifold pressure sensor are less than 10%, and the strategy put forward in this paper is valid.
结果显示，大部分工况下进气压力传感器和节气门位置传感器的信号重构误差可控制在10%以内，表明了所提出的调节策略是切实有效的。
Mark 25 valves have a plug-in base or manifold, a plug-in solenoid and an optional plug-in sandwich pressure regulator.
马克25阀有一个基础或多方面的，一个插件螺线管插件和三明治压力调节可选插件。
If the engine backfires, the sudden pressure in the intake manifold forces the valve back.
如果发动机回火，进气歧管骤增的压力就迫使阀门向后移动。
With the redesigned valves, the engine is not sensitive to air pressure and will easily run just by blowing into the intake manifold.
由于重新设计的阀门，发动机不敏感，空气压力，将很容易运行只需吹的进气歧管。
The rm Series rotary Manifold utilizes a unique concept in transferring air pressure thru fixed ports to rotating parts on the rotary platform.
旋转流形上的RM系列通过采用固定端口一个独特的空气压力的概念转移到旋转平台的旋转部件上。
All the Y-type valves are provided with sealing plates, in particular, the "floating" sealing plates which are fixed to the surface of the manifold box by the air pressure in the bag.
所有Y型阀的装配方式都配有密封垫，特别是“浮动”密封垫利用分气箱内的空气压力固定在分气箱表面。
High back pressure of exhaust manifold, rapid change in load, scavenge fire and so on.
高背压的排气系统，在负载快速变化，清除火灾等。
In the P0442 example above, the fuel level, intake air temperature and manifold absolute pressure sensors are used.
在上面所给出P 0442示例中，燃油箱液面位置，进气空气温度和歧管绝对压力传感器将被应用。
A pressure control manifold then controls the gas pressure that is fed to the process or application.
压力控制管控制着输入到生产过程或应用的气体压力。
What's more, the steam-jacketed steam distribution manifold completely surrounds the distribution pipe with steam at supply pressure, further reducing condensation due to radiation loss.
另外，蒸汽夹套喷管被供汽压力下的蒸汽完全包围，进一步减小因辐射损失造成的冷凝。
Install the high pressure relief valve in the compressor manifold fitting.
在压缩机歧管配件里安装高压释放阀。
A typical customer installation (see Fig. 4) includes a tank, vaporizer, and pressure control manifold.
用户使用的设备(见图4)一般包括储存罐、汽化器和压力控制管。
PC032 Pressure Sensor: It can test manifold absolute pressure of diesel engine, provide the signal to ECU, then control the lasting time of the fuel injection.
PC032压力传感器：用于柴油发动机进气歧管内绝对压力的检测，向ECU（电控单元）提供信号，实现对发动机喷油持续时间的控制。
Rotary Manifold utilizes a unique concept in transferring air pressure thru fixed ports to rotating parts on the rotary platform.
的RM系列旋转形转移利用固定的端口，通过空气压力，旋转部分的旋转平台上一个独特的概念。
The simulation gives a detailed quantitative picture of the velocity field, pressure distribution and instantaneous mass flow rate within the manifold.
数值模拟定量给出了多分支管道内详细的速度矢量场，压力样梯度场及各分支管道的质量流量变化曲线。
The Mark 3 line is available with 10-32 or 1/8 porting in either sub-base or manifold mounting, sandwich speed control and sandwich pressure regulators. more…
标记三是符合10-32或1 /可在任何8次移植，基地或多方面的安装，三明治夹心速度控制和压力调节器。更多…
Processes that use nitrogen as a liquid do not require the vaporizers and pressure control manifold.
使用液氮的过程不要求有汽化器和压力控制管。
The rm Series rotary manifold utilizes a unique concept in transferring air pressure thru fixed ports to rotating parts on the rotary platform.
旋转的RM系列在转让多方面利用固定的端口，通过空气压力，旋转部分的旋转平台上一个独特的概念。
Maximum pressure must be stamped on the manifold.
在分流式系统上应刻上最大的压力。
Pressure regulating AND SHUTOFF valve PRSOV, a valve in the pneumatic system for regulating bleed air pressure from the engine to the pneumatic manifold.
压力调节和关断活门，气源系统中用以调节从发动机到气源总管的引气压力的活门。
Pressure regulating AND SHUTOFF valve PRSOV, a valve in the pneumatic system for regulating bleed air pressure from the engine to the pneumatic manifold.
压力调节和关断活门，气源系统中用以调节从发动机到气源总管的引气压力的活门。
应用推荐