The control circuit and test results of heat film mass air flow counter are given.
本文给出了热膜式空气流量计的控制电路和试验结果。
Mass Air Flow Sensor and other sensors such as Position Sensor, Temperature sensor etc.
空气流量计及其他传感装置如位置传感器，水温传感器，等。
Earlier engine control systems mainly based on mass air flow, fuel quality and Spark Timing.
早期的控制系统主要是以气缸充气量、燃油质量和点火正时为控制参数。
A mass air flow sensor is used to find out the mass of air entering a fuel-injected internal combustion engine.
质量流量传感器，大量的油罐车空气流量传感器用于找出群众的空气进入一个成功内燃机。
Two kinds of key sensors, hot-film mass air flow (MAF) sensor and universal exhaust oxygen gas sensor, for the AFR control are fully studied in this paper.
本论文主要研究空燃比控制中的两种关键传感器：热膜式空气质量流量传感器和宽带型废气氧传感器的动态性能。
In order to calibrate the thermal mass air flow meter by the method of standard flow meter, this paper designs a suit of thermal flow meter's calibration test-bed.
设计了一套热式流量计的标定试验台，用标准流量计法，对热式流量计进行标定。
The influence of air Relative Humidity and mass flow on dust generation rate was determined.
通过实验主要测定空气湿度和质量流量对粉尘产生率的影响。
The limit of accuracy is based upon the quality of the mass balance data, meter calibrations, flue gas analysis, and air flow meter accuracy.
精确程度取决于质量平衡数据的质量、量表的校验、燃料气分析以及空气流量表的精度。
A new type of indirect flow control method shows that liquid flow can be controlled with a mass flow controller on the squeeze air system.
介绍了一种新型的调压式流量控制方法，即通过气路安装质量流量控制器的方法对液路流量进行控制。
In order to build the DPF pressure drop model based on air intake flow, DPF bed temperature, soot and fuel charge, the paper has carried out a series of tests, collected a mass of data.
为了建立基于进气流量、DPF床温、碳烟以及喷油量的DPF压降模型，论文进行了一系列的试验，采集了大量数据。
A planar model of air and water flow on metal fill surface was set up to investigate heat and mass transfer performance of air conditioner.
建立了填料塔的二维传热传质模型，考虑了因水蒸发或凝结而引起的水的质量变化和空气的质量变化。
A mathematical model was developed to investigate mass flow rates in the heat transfer pipes of the air side heat exchanger with and without distribution pipes for an air source heat pump.
建立分液管和换热器的数学模型，对空气源热泵风侧换热器在有、无分液管的情况下的各盘管中质量流量分配问题分别进行研究。
The hot-wire air flow sensor is a kind of sensor that can measure the mass flow of air directly.
热线式流量计是一种可以直接测量空气质量流量的传感器。
On the basis of experiment of two-phase pressure drop, for air-water flow through horizontal tube, the effect of mass velocity on the two-phase pressure drop is analyzed.
在对空气-水在水平放置的圆管内流动时的两相压降实验的基础上，分析质量流速对两相压降的影响。
A method of stepped-diameter design for pneumatic conveying pipelines, as well as relationship among pressure loss, ratio of material to air, and mass flow rate of materials etc.
介绍气力输送管道的变径设计方法和变径管道气力输送试验中压损、料气比、物料质量流量等间的关系。
Adopting the traditional mixture ventilation, it is difficult to improve the indoor air quality due to the limit of the fresh breeze's mass flow, unless we consume more energy.
采用传统的混合式通风形式，由于新风风量的限制，在不提高能耗的条件下，很难提高室内的空气品质。
Air mass flow sensor is broadly used in engine testing and control system.
质量空气流量传感器广泛应用于发动机测试及控制系统。
The utility model is used for measuring the mass flow of air and has the advantages that explosion is prevented, and the explosive loss in the flowmeter is reduced.
本实用新型用于测量气体的质量流量，具有防爆和减少流量计内部爆炸损失的优点。
The petrol engine has, due to its throttled air intake, a large range of variation in exhaust mass flow compared to the Diesel engine.
由于进气口的限流，相比柴油发动机，汽油发动机的排气流量有大范围的变化。
The factors that influence the whole efficiency of ventilating system adopting adjustment to variable air mass flow and friction were investigated.
对采用变流量、变阻力调节式通风系统整体效率的影响因素进行了探讨。
Under the condition of constant phosphorus mass flow rate, the smog exit temperature would increase slowly while other parameters would decrease with increasing excess air coefficient.
在燃磷量不变情况下，最高燃烧温度、壁面最大热流和平均热流均随过剩空气系数的增大而减小，但烟气出口温度缓慢增加。
The influences of key design and operating parameters, such as bypass air ratio, compressor speed and total air mass flow rate etc.
分析了空气旁通率、压缩机转速及空气质量流量等主要设计及运行参数对干燥性能的影响。
First, experimental study on the influence of air temperature, velocity, initial moisture content of wood particles and mass flow rates ratio in the process of ISD has been performed.
首先，在不同气流温度、温度、流量及不同刨花初含水率、载带率条件下进行刨花对撞流干燥实验。
The oxygen mass transfer coefficient increases at the beginning and then decreases with the augment of carrier content, and increases with the augment of air flow rate and liquid flow rate.
氧传质系数则随着载体含量的增加先增后减，随着气流量和液流量的增大而增大。
The influences of key design and operating parameters, such as bypass air ratio, compressor speed and total air mass flow rate etc. , on the performance of heat pump microwave drier were investigated.
分析了空气旁通率、压缩机转速及空气质量流量等主要设计及运行参数对干燥性能的影响。
Results show that the EGR rate can be effectively regulated by adjusting VNT vane position while still ensuring sufficient fresh intake air mass flow.
结果表明，通过调节VNT开度可以有效控制EGR率，并能保证较充足的新鲜空气量。
Results show that the EGR rate can be effectively regulated by adjusting VNT vane position while still ensuring sufficient fresh intake air mass flow.
结果表明，通过调节VNT开度可以有效控制EGR率，并能保证较充足的新鲜空气量。
应用推荐