For bay lengths other than those shown, the maximum spacing of purlin bracing shall be 80 O. c.
凹进去的长度除了图示的以外，用于支撑的桁条的最大间距应该是80O.C。
Note how the scores are separated by orders of magnitude and divisions of 10. Use broad spacing in your initial scoring setups to allow maximum flexibility as your scoring criteria changes.
请注意分数是如何按10个数量级的顺序来划分的。在初始评分设置中使用宽间距以允许评分标准更改拥有最大的灵活性。
The obvious solution would be simply to set the tick spacing on the horizontal slider whenever its maximum value is updated, as shown in Listing 3.
明显的解决方案是，只要滑块的最大值被更新，就在水平滑块上简单地设置刻度间隔，如清单3所示。
In the gain measurement, the sample spacing can be enlarged directly, yet the required maximum remains unchangeable.
增益测量时可以将采样间距直接增大，亦可有效地获得所需的最大值。
The results show that the maximum achievable repeater spacing is 17km over that calculated using a conventional worst-case design approach for a premature failure rate of 0.1%.
结果表明，当系统先期失效率为0.1％时，按统计法设计的最大中继距离可以比传统的最坏值法加长17公里。
The maximum or minimum stirrup ratio and stirrup spacing requirements were comparatively analyzed.
对各规范中的最大、最小配箍率及箍筋间距要求进行了对比分析。
The layer with the largest spacing to one of its neighbours also possesses the maximum surface atomic density.
面间距最大的一对原子面也具有最大的面原子密度。
In light of the results calculated by maximum hole spacing in freezing horizon, The freezing wall should be enclosed, however, hydrological hole don t leak.
本文就冻结工程施工中遇到的冻结层位最大孔间距计算出冻结壁已交圈，但水文孔不冒水的问题结合了作者的施工经验进行了深入的分析。
At a given electric field intensity when the wire-wire spacing is 0.6-1 times that of the wire-plate, the utilization of pulsed energy by the reactor will reach a maximum value.
在电场长度一定下，线线间距为线板间距的0.6 ~1倍时，反应器对脉冲能量的利用达到最大。
By the analysis of average crack spacing, the maximum cracks width, crack height of the reinforced beams. derived a maximum crack width formula for the reinforced beam.
通过对加固梁平均裂缝间距、最大裂缝宽度、裂缝高度等的分析，推导出了加固梁最大裂缝宽度计算公式。
The relationship of deflection, crack spacing and maximum crack width with the stress, diameter and ratio of steel bars can be predicted by existing model presented in the code.
试验梁的挠度、裂缝间距和最大裂缝宽度与钢筋应力、钢筋直径和配筋率等因素的关系基本上可用现有模型预测。
The relationship of deflection, crack spacing and maximum crack width with the stress, diameter and ratio of steel bars can be predicted by existing model presented in the code.
试验梁的挠度、裂缝间距和最大裂缝宽度与钢筋应力、钢筋直径和配筋率等因素的关系基本上可用现有模型预测。
应用推荐