Experiment indicates that this controller could satisfy the requirement of multi-axle motor-servo movement controller.
试验表明，该控制器能够满足多轴电机伺服运动控制的需要。
Servo motor has a long overload ability, have smaller rotary inertia and big plugging around moment.
伺服电机有较长的过载能力，有较小的转动惯量和大的堵转转矩。
Servo motor has small start frequency, can quickly from the lowest revolution accelerated to the rated speed.
伺服电机有很小的启动频率，能很快从最低转速加速到额定转速。
Servo motor control the car running, if there is no device in place is bound to cause the car abnormal operation, printing problems.
伺服电机操控着小车运转，假如没有装置到位必定致使小车运转反常，打印呈现疑问。
Ac servo system in many performance is better than the stepping motor.
交流伺服系统在许多性能方面都优于步进电机。
Servo motor is of high precision, speed and care with milliseconds, the disadvantage is that capital is relatively rare.
伺服电机利益是精度高，速度快，照料以毫秒计算，缺点是本钱相对名贵。
Adopting ac servo motor as the driving device, can the dc servo motor and a high precision, high performance as the half closed loop or closed loop control system.
采用交流伺服电机作为驱动器件，可以和直流伺服电机一样构成高精度，高性能的半闭环或闭环控制系统。
Based on direct drive servo motor CNC bending machine technology is an emerging technology.
基于伺服电机直接驱动的折弯机数控技术则是一门新兴的技术。
From the lowest to the highest speed, speed servo motor can smooth running, torque ripple is small.
从最低转速到最高转速，伺服电机都能平滑运转，转矩波动小。
Now commonly used servo motor is ac servo motor, the axial end in motor with photoelectric encoder, by examining the rotor Angle to frequency conversion control.
目前常用的伺服电机是交流伺服电机，在电机的轴端装有光电编码器，通过检测转子角度用以变频控制。
The exchange of motor and servo means that once one motor or servo doesn't work, it possible to be replaced by other less important motor or servo.
电机和伺服互换性，是指在实际生产中，某台电机或者伺服坏了之后，是否可以用相对不重要的电机或者伺服替换的容易程度。
Three group of servo motor finish the function of precise counting, stacking and transfering out while high speed running.
由三组伺服电机共同构成高速运行下精确计数堆积输出功能。
Remove longitudinal interlock servo motor.
拆下纵向互锁伺服电机。
Can be connected with any servo motor around the world.
可适配全球任何一台伺服电动机。
Standard configuration is sidle frequency conversion motor drive & dec optional configuration is servo motor drive.
标准配置横行变频马达驱动，可选购横行伺服马达驱动。
A servo motor accurately controls the fluid level in the tank.
伺服电机可精确控制箱中的液位。
Auto suction outlet system. Suction outlet controlled by servo motor precision, following the knife edge automatic adjustment.
吸风口由伺服电机精准控制，跟随边自动调整。
Servo motor has a long overload ability, have smaller inertia and the big plugging around moment.
伺服电机有较长的过载能力，有较小的转动惯量和大的堵转转矩。
Proficient in PLC programming (Siemens), human-machine interface touch screen, frequency converter, servo driver, stepper motor.
精通PLC编程（西门子、三菱），人机接口触摸屏、变频器、伺服驱动器、步进电机。
Position detection of rotor in hybrid stepping motor servo system can use traditional outside position sensor or sensorless scheme based on theoretical algorism, but there are many problems produced.
混合式步进电动机伺服系统转子的位置检测，可以用传统的外配位置传感器或基于理论算法的无位置传感器方案，但是存在许多问题。
Design a servo motor control system.
设计一种伺服电机控制系统。
Aiming at characteristics of unpredictability the load torque used in ac motor servo system, a method of load torque adaptive identification based on state observer is presented.
针对交流电机伺服系统中负载转矩不可预测性的特点，提出一种基于状态观测器的负载转矩自适应辨识方法。
This paper describes performance indexes, structure features, design method and experimental investigation of electrohydraulic servo motor with super-low-speed, wide speed control and high precision.
本文介绍了超低速、宽高速、高精度电液伺服马达的性能指标、结构特点、设计方法和试验研究。
This paper presented L2 robust control for permanent magnet linear motor servo system.
对永磁直线电机伺服系统提出非线性L2鲁棒控制。
The motor servo drive system was used to control antenna turning, adjust the antenna to point at satellite again and receive signal.
再用电机伺服驱动系统控制天线转动，调整其重新指向卫星接收信号。
Adopting ac servo motor as a drive device, can and dc servo motor as a high precision, high performance and a half closed loop or closed loop control system.
采用交流伺服电机作为驱动器件，可以和直流伺服电机一样构成高精度，高性能的半闭环或闭环控制系统。
Commonly used servo motor is ac servo motor, the motor shaft with in the photoelectric encoder, by detecting the rotor Angle to frequency conversion control.
常用的伺服电机是交流伺服电机，在电机的轴端装有光电编码器，通过检测转子角度用以变频控制。
Standard configuration is sidle frequency conversion motor drive; optional configuration is servo motor drive.
标准配置横行变频马达驱动，可选购横行伺服马达驱动。
The position tracking controller with good performance is the guarantee of high precision brushless DC motor servo system.
为了设计高精度的直流无刷电机伺服控制系统，性能优良的位置跟踪控制器是其重要保障。
The position tracking controller with good performance is the guarantee of high precision brushless DC motor servo system.
为了设计高精度的直流无刷电机伺服控制系统，性能优良的位置跟踪控制器是其重要保障。
应用推荐