It has some virtues such as less damages to GF, non pollutant to environment and easy control of resin content.
该工艺具有对纤维损伤小、不污染环境和树脂含量容易控制等优点。
The effect of resin content and weaving type of the fabrics on mechanical properties of carbon fabric reinforced composites was studied.
本文研究了织物编织类型及树脂含量对碳织物复合材料力学性能的影响。
The researches show that the content of resin and the relative molecular mass of maltene decrease as the reaction progress.
研究表明，随着反应的进行，树脂含量和相对分子质量降低。
Practice results indicated that the content of formaldehyde in resin binder can be controlled less than1.8%and the mechanical properties completely satisfied the requirement of production.
生产应用结果表明，该树脂粘结剂中甲醛含量可控制在1.8%以下，力学性能完全可以满足生产要求。
Study of different types and different content of water-borne polyurethane resin modified.
研究不同类型及不同含量的环氧树脂对水性聚氨酯的改性。
The analysis of fluorocarbon resin content in fluorocarbon lacquer by using oxygen bomb burning method with fluorin ion electrode are discussed in detail.
采用氧弹燃烧法配合氟离子电极对有机溶剂型和水溶性氟碳漆中氟碳树脂含量的分析方法进行了研究。
Based on above test results, reasonable content of epoxy resin was proposed to use in paving on steel deck plate.
基于以上试验结果，提出应用于钢桥面铺装的环氧树脂合理含量建议值。
The study shows that only when the content of TP resin is not blow 15%, can the relatively obvious toughening effect be found.
研究表明，只有当tp树脂含量不低于15%时，方可获得较明显的增韧效果。
The influences of the resin content and molding parameter on the air permeation of bipolar plates were researched.
考察了树脂含量和成型工艺参数对双极板透气性能的影响。
This paper studied the selection of resin type, reason of resin breakage, influence of solid content in reaction solution and method of resin deactivation and regeneration.
研究了树脂催化剂类型的选择，树脂易破碎的原因，反应液中同含量对反应的影响，以及树脂的失活与再生方法。
The influences of basic resin, nucleating agents and its content, other agents, extrusion temperature and rotating velocity on the transparency of PP are studied by lab experiment.
小试研究了基础树脂、成核剂种类与含量、其它助剂及加工过程中挤出机温度与转速对PP透明性的影响。
The impregnating methods concerned in this paper have the advantages such as availability for different types of resin systems, prepreg with uniform resin content and higher producing efficiency, etc.
本文所涉及的预浸方法具有如下优点：适于不同体系的树脂，预浸料树脂含量均匀，生产效率高等。
Treatment of ground pulp with lipase was investigated to reduce resin content of pulp.
本研究用脂肪酶对磨木浆进行处理，以降低浆料中树脂含量。
Carbon black -urushiol formaldehyde resin conductive paint has been prepared in this paper. Effects of carbon black content, grinding time and the thickness of paint were investigated.
本文研制了炭黑-漆酚醛树脂导电涂料。讨论了导电填料炭黑的含量、研磨时间以及漆膜的厚度对涂料导电性能的影响。
Compared with the original pulp, resin content of the treated ground pulp with lipase under optimum condition decreased by 52.58 % and strength of the treated pulp increased in varying degrees.
在脂肪酶最佳处理工艺条件下，磨木浆与原浆相比，树脂含量下降了52.58%，而强度均有不同程度的提高。
Improvement on synthesis process and additives was made to develop a new type of resin binder with low content of formaldehyde, high strength and low costs.
为生产出甲醛含量低、强度高、成本低和工艺性强的粘结剂，通过改进合成工艺及添加助剂，研制出了一种低游离醛的树脂粘结剂。
The correlation formula for calculating the resin content and curing degree of UP FRP were introduced.
本文介绍计算聚酯玻璃钢树脂含量和固化度的校正公式，该公式对实际工作有一定的指导意义。
Methods CITF was obtained through macroporous absorption resin and UV spectrophotometry was used to analyze the content of total flavonoids.
方法采用优选树脂纯化野菊花总黄酮，以分光光度法测定野菊花总黄酮含量。
The exact amount will depend on the type of resin and its inherent shrinkage, the glass content, process temperatures and the number of generations between the master model and the production part.
具体数值决定于树脂类型和其固有收缩量、玻纤含量、过程温度和原模翻新生产模具的次数。
The modified effect of the high hydroxyl content acrylic resin was stronger than the low hydroxyl content acrylic resin.
而高羟基含量的丙烯酸酯树脂比低羟基含量的改性效果好。
The resin content in timber of Yunnan pine was mainly controled by hereditary substance, and also affected by the geographic variation of grow place.
云南松木材的松脂含量主要决定于遗传因素，但又受生长地理位置变异的影响。
With the content of super water absorbent resin increasing, the composing proportion of soil liquid phase increases, and the function of water storage strengthens.
随着高吸水树脂含量的增加，土壤液相组成比例增加，蓄水功能增强。
The measures to prevent nitrogen blow hole caused by high nitrogen content of resin sand are: adopting low nitrogen resin, adding iron oxide into sand or coating and keeping resin from moisture.
防止树脂砂含氮量高引起的氮气孔的方法是：选用低氮树脂、型砂或涂料中加入氧化铁粉和避免树脂受潮。
An epoxy resin, an organic secondary amine, a polyamide and a blocked isocyanate are selected as main materials to synthesize polymer resin with solid content of 70%.
本实验采用环氧树脂、有机仲胺、聚酰胺和封闭异氰酸酯为主要原料，合成了固体分在70%的阳离子型环氧聚合物树脂；
The results show that the level of polysulfide polyurea and the content of hard segment in polysulfide polyurea influence the morphology, T_g and modulus of cured epoxy resin.
结果表明，液体聚硫聚脲齐聚物的用量、齐聚物中聚脲含量对固化后的环氧树脂玻璃化温度、模量及形态有较大影响。
This paper introduces an improved test of soluble resin content in epoxy preimpregnated DMD material.
本文介绍了一种改进的环氧树脂预浸DMD可溶性树脂含量检测方法。
The resin content, the volatile content and the pre-curing degree of the silica/phenolic resin prepreg cloth were on-line determined by near infrared diffuse reflection spectrum.
采用近红外漫反射光谱技术对高硅氧/酚醛预浸布的树脂含量、挥发分含量和预固化度等质量指标进行了在线测定。
A series of Polyvinyl Chloride (PVC) blending resin were synthesized with different dispersion, additive content.
采用不同体系分散剂、不同调粒剂用量合成了系列聚氯乙烯掺混树脂。
A series of Polyvinyl Chloride (PVC) blending resin were synthesized with different dispersion, additive content.
采用不同体系分散剂、不同调粒剂用量合成了系列聚氯乙烯掺混树脂。
应用推荐